In order to build 3D structural model for Mamlaht Al-Kom
structure in the North Palmyride Chain, the potential reflections
were defined like Korushina Anhydrite (K.A) the cover, and
Korushina Dolomite (K.D) the reservoir, therefore the time,
velo
city, and depth maps for Korushina dolomite reflection were
constructed. Finally the 3D Structural Model for formation (K.D)
was defined. So that the hydrocarbon potential is discussed.
This research aims to decrease the cost of last production stages
through decreasing the cost of potential casing repair by avoiding the
problems that casing string may be exposed to. Such problems are
caused by the temperature effect of salt dril
ling fluids as well as other
fluids normally existed in the annular behind casing at the nonecemented
intervals.
This research aims to increase the production lifetime of oil and gas
wells through avoiding the problems that production casing string
may be exposed to. Such problems are caused by the effect of different
drilling fluids as well as other fluids normally existed in the annular
behind casing at the none-cemented intervals.
This paper presents the shear behavior of lightweight concrete beams
without shear reinforcement produced by scoria aggregates. A total of nine
beams were tested under four-point loads, including three lightweight
concrete beams without steel fibers and six steel fiber reinforced
lightweight concrete beams.
In this research we present results of the studying and calculating the optically active
range depth for diffuse light reflected coating at change of the dispersiveness of pigment
grains used in coating and wavelength of incident electromagnetic ra
diation. This coating
consists of zinc oxide powder and organic material that acts as a binding film. The size of
zinc oxide powder grains were changed between 0.2 μm and 10 μm. In addition, the depths
of optically active range of diffuse light reflected coating were calculated when the
absorption coefficient of the pigment used in the ZnO/binder coating changed between
-1 0.1cm and -1 1000cm . The obtained results allow us optimization of the diffuse light
reflecting coatings thickness at preparation determined kinds of them.
The purpose of this research is to study the effect of Subcrestal placement of dental
implants on marginal bone loss in immediate implantation. The research sample
comprised of 24 implants were immediately placed after extraction,12 implants have
placed at Equicrestal level (6 in the maxilla and 6 mandible) served as control group and
12 impalnts (6 in the maxilla and 6 mandible) have placed at Subcrestal level served as test
group. modified bleeding index MBI, probing pocket depth PPD and marginal bone loss
MBL Implant survival, evaluated for both groups. Mbl were 0.85 mm in control group and
1.30 mm in test group after one year of dental emplacement The results of the present
study showed that the success rate was 100% in both groups, there was no statistical
difference between the test and control regarding, MBI, while there was statistical
difference between the test and control regarding MBL, PPD. during periods of follow up .
The radiating process of a crystalline sample cause damages in this sample .These damages composed mostly of displaced sample atoms from their regular position in lattice, and placed in irregular position, and of very less quantity from some beam par
ticles ( strange particles ) , that placed inside of this sample. The depth and amount of these damages are correlating with radiating parameters. It's possible to estimate the depth distribution profiles of damages by RBS-Method, but the sensitivity of this method is not enough to determine the depth distribution of concentration of beam particles , that placed inside of the sample . The placement depth of RBS-Profiles top is strongly correlated with orientation angle of a sample's channel relative to radiating beam also to kind of channel ,whereas the RBS-Profiles top displaces in depth , in channel radiation compare with its counter part in random radiation and the displacement value correlates with radiation parameters The height of RBS-Profiles top increase by increasing of radiation dose, and height that can't be survived called amorph state , and the agreeing dose called ,amorph dose , the amorph dose correlates also with radiation parameters, special sample temperature.
In area of Elward east located in Euphrates Graben, 2D and 3D
Seismic data were used to reveal subsurface geological structures,
especially Reservoir Rutbah Formation dated as Lower Cretaceous
and to explore hydrocarbon traps of this Formation. And to
discover new drillable locations by integrating geological and
seismic data and using seismic attribute techniques such as Dip
and coherency.
The study addressed the most important phases of Turkish foreign policy since the
establishment of the modern Turkish republic in 1923. And the principles govering it. Then
it focused on the new trends of foreign policy after the Jastice and develo
pment Islamic
rooted party came to power in Turkey 2002. Especially the strategic depth, reset problems
or zero problems with neighbors and new ottomanism.
The study concluded that the basic tenets which guided turkey's foreign policy since
the founding of the republic included caution and pragmatism.
It is generally agreed that growth in palatine results from bone formation at the
palatine sutures and lengthening of the alveolar processes, but the extent to which these
two sites contribute to the depth and length of the hard palate remains unso
lved. Hence,
professionals should use quantitative assessments of the hard palate, which allow more
accuracy in the diagnosis and assessment of this structure.
Aim investigating the relationship between the length and depth of the skeletal hard
palatine with facial growth type in adult subjects using CBCT scan.
