تم الاعتماد في هذا البحث على طريقة تصميم التجارب، و تم تقييم النتائج بطريقة الاستجابة السطحية. دلّت النتائج أن متحول شدة التيار هو المتحول الأكثر سيطرةً على الخصائص الميكانيكية المدروسة، و تمّ تحديد قيم
المتحولات التي تُعطي أفضل قيم للاستجابات.
Design of experiments (DOE)
had been used in the study, and the results had been evaluated by the
surface response method. The results showed that the welding
current is the main parameter by its effect on the mechanical studied
properties and the parameters values which give the best responses
had been determined.
References used
(Jiang Y, Xu B, Lu Y, Xiang Y, Liu C & Xia D, 2008 - Application prospects of plasma welding within remanufacturing engineering, In World congress on maintenance. (p. 2
Co-ordinated, 2013 - Gas Tungsten Arc welding III & Plasma Arc Welding. IIT Roorkee, India; Retrieved from: http://nptel.ac.in/courses/112107090/module4/lecture6/lecture6.pdf
Tseng H, Jou M, Chang Y & Huang Y, 2008 - Influence of process parameters on joining strength in microplasma arc welding, International Journal of Manufacturing Technology and Management. 13(2-4), 265-279
In this research, a study of the influence of arc welding
parameters on the thermal cycle was conducted, where the thermal
cycle within the welded plate of stainless steel 304L by plasma arc
welding (PAW) with weld-on-plate was measured using
the
This research seeks to localize the technology of plasma arc welding (PAW), the best
alternative against tungsten arc welding (TIG). So a quantitative comparison between these
two technologies has been made, according to the particular case that is
The influence of thermomechanical treatments on the microstructural properties of stainless steel D9 alloy
steel was studied.
This research showed the great importance for following studies of the effect of polluted phosphoric acid,
produced in General Fertilizer Company, on the high corrosion resisting alloys, to reach suitable alloys
for equipments and machines used for
Refusion the boundaries of weld's reinforcement was done using TIG
without filler metal .The mechanical properties & micro-structure of
various zones in low carbon steel welded joints were studied.