The high traffic density causes traffic congestion on the road, causing delays before it reaches its destination, in addition to the stress and high psychological impact on the driver, it also results in staff and staff being late for work and studen
ts being late for school, With frequent accidents on these busy roads. Congestion has a lot of reasons, one of them is poor infrastructure that leads to a state of congestion, a significant increase in the number of vehicles, a lack of prior information for road users about the traffic situation, Division of traffic management into several departments (Public works, municipality, security, transport…). They become ineffective in some areas, aggressive driving style Which may be an effective factor in creating congestion, in addition to the use of individual transport rather than mass transport. Latakia suffers from a very poor transport system, and the indiscriminate movement of vehicles on its streets. This has been accompanied by increased traffic, which has led to many problems. The most important is the problem of congestion, in terms of increasing the values of delay times in different road sectors. This has contributed to major traffic crises and congestion. It affected service levels on arterial streets in the city's downtown, in the absence of rush-hour studies. Two main streets have been selected in the commercial and downtown center of Latakia City, which is an important arterial street for the distribution of movement. These arterial streets connect the commercial and administrative center of the city with the other parties of the city. The moving controller analyses a large number of actual speeds of the vehicle, measured in each sector, with a view to estimating congestion, calculating its indicators, and determining peak hours. Congestion levels were inferred based on the values of the speed performance index, and the average speeds of daytime and evening peak hours have been mapped to considered street sectors.
This research aims to accelerate the restoration of the
bone cavity resulting from the surgical removal of the dental cysts
through fill the cavity with Palatelet-Rish Plasma.
during root canal preparation,
intracanal debris could extrude apically. The purpose of this in
vitro study was to detect the effect of preparation technique on the
amount of apically extruded debris.
The aim of this study is to evaluate the healing after
apicectomy by using two different techniques. And to evaluate the
effect of MTA as a retrograde filling material and also the Er:YAG
laser as a tool for resecting the apex, and the influence of them in
the healing.
The purpose of this study was to evaluate whether the
development of the maxillary canine can be used for prediction
of pubertal growth spurt in the Syrian population. The study
group consisted of 150 boys, 142 girls ranging in age from 10,
16 years.
Analysis study was done to explain the effect of the
longitudinal section on the values of pressure of the water
hammer resulting from the trip of pumps, which results a low
pressure wave often lead to get cavitation, has been shown from
the anal
ytical study of several profiles and compare the results,
that the shape of the profile and the level of the pressure line
after the stopping of pumps determines the type of cavitation
formed , the region in which it occurs and the pressure values
resulting from it, when the profile doesn’t contain bends or the
bends are below the level of line pressure a distributed
cavitation is occurred, In the case of the presence of high points
, the effect of the bend is linked to several factors:
1 - the greater the height of the bend above line pressure increases the possibility for column separation and increases the pressure
forces.
2 –the pressure forces increase whenever the bend closer to the pumps.