تعرض هذا البحث إلى طريقة جديدة لتحديد الاستطاعة الردية المسموحة للمولدات التزامنيـة
المربوطة إلى عقد التوليد في الشبكة الكهربائية، و ذلك اعتماداً على الاستطاعة الفعلية و التوتر
و التيار المسموح به لكل من الثابت و الدائر بالإضافة إلى المعطيات الأخرى للمولـد، و يقـدم
تحليلاً لمعادلات الثابت و الدائر و للعوامل التي تؤدي دوراً في تحديد قيمتيهما كالقوة المحركـة
الكهربائية الداخلية و مميزات اللاحمل للآلة التزامنية و مدى تأثيرها في مركبات التيار التي يتم
على أساسها تعيين الحدود المسموحة لتغيّر الاستطاعة الردية [ Qmin , Qmax[ للمولـدات فـي
عملية تنظيم التوتر لعقد الشبكة الكهربائية. كما تم في سياق البحث وضع الألغوريتم الـلازم
لحساب الاستطاعة الردية المسموحة لكل من المولـد ذي الـدائر الأسـطواني و المولـد ذي
الأقطاب البارزة عند قيم مختلفة للتوتر و الاستطاعة الفعلية المستجرة.
No English abstract
References used
Zhang, S. & Irving, M. R., Enhanced Newton - Raphson algorithm for normal, controlled and optimal power flow solutions using column exchange techniques, IEE, England 1994
Yamayee, Z. A.& Bala, J. L., Electromechanical Energy Devices and Power Systems, John Wiley & Sons, Inc. 1994
Nagrath, I. J. & Kathari D. P., Modern Power System Analysis, MG Graw - Hill, Inc. 1982
In this research the dynamic impact of the interconnection on the rotor
angle Stability for Synchronous Generators in the Syrian Network were
analyzed through the dynamic simulation of the power system and building
of equations is linear and then
The out-of-stability state of synchronous generator which
connected to high voltage network due to the transient
situations which lead us to disconnect the generator causes
finincial and technical problems. Therfore the purpose of this
research i
This paper tries to clarify the impact of parallel and serial compensation of power transmission lines on the
performance of distance relays which protect these lines. To this end, power system analysis software
(NEPLAN) will be used for explaining
Reactive power compensation in distribution networks is one of the most important economic and
environmental issues in power system studies. In this paper the following points are investigated:
· The characteristics of the most developed equipment
We, in Al AHLIA Company for RUBBER and Plastic Products - Damascus
by Coordination with Damascus University, prepared a typical blend for local
production of the electric generators elastomeric couplings. That was achieved
after a detailed analysi