Do you want to publish a course? Click here

The Effect of the Pressure Decay Factor on the Response Spectrum of the Explosion Load

تأثير عامل تخامد الضغط على طيف الاستجابة لحمولة الانفجار

974   1   17   0 ( 0 )
 Publication date 2014
and research's language is العربية
 Created by Shamra Editor




Ask ChatGPT about the research

This research discusses the exponential function of the explosion load and the pressure decay factor in this function (a). After that, four functions with four different values of the pressure decay factor are studied, and that is for the un-damped SDOF system, where the equation of motion is formed and solved. Then, using MATLAB software for every function, the relationship between (Yst/Y(t)) and t/T is plotted, and that enables plotting the response spectrum for each one. Moreover, a comparison between the spectra of the last three functions with the first one that describes the triangular explosion load is drawn. This research has concluded that for a certain range of (a), it is possible, and with acceptable approximation, to use the spectra of triangular load, but beyond that it is better to use the spectra of exponential load.

References used
Bangash, M.Y.H., Bangash, T. Explosion- Resistant Buildings. Springer- Verlag, Berlin Heidelberg, 2006, 805
Biggs, J. M. Introduction to Structural Dynamics, McGraw Hill, New York, 1964,341
Bulson, P.S. EXPLOSIVE LOADING OF ENGINEERIN STRUCTUERS. E & FN Spon, London, 1997,236
We, J., Quintero, R., Galati, N., Nanni, A. Failure Modeling of Bridge Components Subjected to Blast Loading. International Journal of Concrete Structures and Materials, Vol.1, No.1, December 2007, 19-28
Henrych, J. The dynamics of explosion and its use. Elsevier, Amsterdam, 1979,558
rate research

Read More

Corrosion is the most important problem in the process of oil production, Its results are: sudden fracture, high economic cost and great loss in oil equipment. Appropriate solutions have been suggested to extend the life of facilities, and to avoid c orrosion phenomenon which may get the facility out of service, But, finding the main reasons causing this phenomenon, and studying the factors that contribute to increase or reduce the spread of corrosion requires more urgent attention. In this paper, the data of the pressure has been analyzed in three crude oil pipelines and focus was on the values during the days where changes were irregular. In the same period, the study of internal corrosion rate was being done, using weight loss method. It has been noticed that when the value of pressure is greater than 2 Mpa, the internal corrosion rate will be above the maximum. allowable limit which is 4 mil per year (MPY), while the internal corrosion rate will be within the acceptable range when the pressure is not greater than 1 Mpa.
In this work we have studied the effect of exchange interactions between the gluons of order on the pressure and phase diagram of quark – gluon plasma, where we have studied both of them as function of temperature and chemical potential, and we as sumed that, the plasma composed of just two massless quarks (the up and down quark) which exchange interaction. The bag model has been used, where the bag B and coupling constants were assumed to be independent of temperature and chemical potential. We have found that the gluons interactions of order had a negative effect on the pressure of the plasma, which cause the quarks to stay in the confined phase, and then increases the critical temperature where the hadrons dissolve to quarks and gluons. We have showed that, the results depend strongly on the values of both the coupling and bag constants which had been used.
Serum response factor (SRF) is a protein that regulates the transcription of several other genes. It regulates especially cardiovascular system developmental regulatory genes. This study which was based on the immunohistochemistry showed that SRF influence the brain and limb vasculature development in the mice embryo.
This paper presents an experimental investigation of the flow pattern and wall pressure due to the change of the opening discharge diameter in cylindrical silos. The experiments were performed on a metal silo prototype using corn as a granular mater ial. The silo prototype used in the study was built of a metallic cylinder, which can be opened longitudinally allowing the observation of the flow pattern through a plexi-glass wall, and the wall pressure distribution was measured using a special granular pressure transducer. The present study revealed unexpected results to what might be expected through current theoretical knowledge.
The aim of this paper is to present a recent experimental investigation of the wall pressure distribution observed during the emptying of a modeling silo, with and without, inserts, for three different heights hi of the insert base above the hopper outlet. The experiments were carried out with corn, at the concrete lab. in faculty of civil engineering in Damascus university in Syria. The results show that the upper-cone with downer-cone trunk insert had a strong influence on the pressures in the silo.
comments
Fetching comments Fetching comments
Sign in to be able to follow your search criteria
mircosoft-partner

هل ترغب بارسال اشعارات عن اخر التحديثات في شمرا-اكاديميا