In this paper the tracking model in WiMAX Relay Station'
Directional antenna are implemented by OPNET Modeler to Direct
the beam toward users.
this research studies 2x2 MIMO LTE signal transmission from the
main tower eNB and the relay node RN over single mode fiber
using ROF technology and take advantage of the WDM technology,
the results show the ability of ROF to accommodate MIMO
com
munication with high efficiency.
The network has been simulated and analyzed using Optisystem
program, and the results were more than promising.
The purpose of this research is to design and realization of an electronic apparatus which is able to control the process of irrigation that depending on soil moisture .This apparatus organize the process of irrigation, when the level of soil moistur
e under a specific value that it was chosen depending on water field capacity of crop ,it operates the pump which connected with it, and when the moisture level reaches that value the pump stops working.
The apparatus consists of two parts:
The first part: An electronic circuit using a number of operational amplifiers ,some electronic elements ,and voltmeter to measure voltage between load resistance which is in serial with resistance between two probes that set in soil.
The second part: An electrical part ,which provides a secure connection between the previous electronic circuit and water pump.
This study was carried out on a simple of black soil .The relation between electrical resistance of soil and volume of water used in irrigation was drawing for three values of distance between probes and power supply. We found an intense declination curves for small values of used water volume.
This paper tries to clarify the impact of parallel and serial compensation of power transmission lines on the
performance of distance relays which protect these lines. To this end, power system analysis software
(NEPLAN) will be used for explaining
distance relay behavior in the presence of different parallel or serial
reactive power compensators, with main types of faults that may occur in different locations on the protected
line.
In this paper, Syrian power transmission network is simulated using (NEPLAN) software, and three reactive
power compensators: parallel (STATCOM), serial (TCSC), and unified (UPFC), are used to compensate
reactive power on transmission line. Several simulations, in many cases are carried out to illustrate the
impact of fault type and location on the measured impedance seen by the distance relay.
The objective of identifying the impact of reactive compensators on fault impedance seen by distance relay
(i.e. fault location), is to determine the possible ways to resolve the problem and improve the performance of
transmission line protection.
STATCOM
FACTS
الحاكمة المسافية
المعوضات الردية
المعوض التزامني الستاتيكي
المعوض الموحد
المعوض التسلسلي ذو التحكم الثايرستوري
Distance relay
Static Synchronous Compensator
Unified Power Flow Controller
UPFC
Flexible Alternating Current Transmission
Thyristor Controlled Series Compensator
TCSC
المزيد..