اشترك بالحزمة الذهبية واحصل على وصول غير محدود شمرا أكاديميا
تسجيل مستخدم جديدHigh-Performance Carbon Nanotube Field-Effect Transistor with Tunable Polarities
141
0
0.0
(
0
)
اسأل ChatGPT حول البحث
ﻻ يوجد ملخص باللغة العربية
State-of-the-art carbon nanotube field-effect transistors (CNFETs) behave as Schottky barrier (SB)-modulated transistors. It is known that vertical scaling of the gate oxide significantly improves the performance of these devices. However, decreasing the oxide thickness also results in pronounced ambipolar transistor characteristics and increased drain leakage currents. Using a novel device concept, we have fabricated high-performance, enhancement-mode CNFETs exhibiting n or p-type unipolar behavior, tunable by electrostatic and/or chemical doping, with excellent OFF-state performance and a steep subthreshold swing (S =63 mV/dec). The device design allows for aggressive oxide thickness and gate length scaling while maintaining the desired device characteristics.
قيم البحث
اقرأ أيضاً
We report the radio-frequency performance of carbon nanotube array transistors that have been realized through the aligned assembly of highly separated, semiconducting carbon nanotubes on a fully scalable device platform. At a gate length of 100 nm,
we observe output current saturation and obtain as-measured, extrinsic current gain and power gain cut-off frequencies, respectively, of 7 GHz and 15 GHz. While the extrinsic current gain is comparable to the state-of-the-art the extrinsic power gain is improved. The de-embedded, intrinsic current gain and power gain cut-off frequencies of 153 GHz and 30 GHz are the highest values experimentally achieved to date. We analyze the consistency of DC and AC performance parameters and discuss the requirements for future applications of carbon nanotube array transistors in high-frequency electronics.
In this study, a model of a Schottky-barrier carbon nanotube field- effect transistor (CNT-FET), with ferromagnetic contacts, has been developed. The emphasis is put on analysis of current-voltage characteristics as well as shot (and thermal) noise.
The method is based on the tight-binding model and the non- equilibrium Greens function technique. The calculations show that, at room temperature, the shot noise of the CNT FET is Poissonian in the sub-threshold region, whereas in elevated gate and drain/source voltage regions the Fano factor gets strongly reduced. Moreover, transport properties strongly depend on relative magnetization orientations in the source and drain contacts. In particular, one observes quite a large tunnel magnetoresistance, whose absolute value may exceed 50%.
A finite Schottky barrier and large contact resistance between monolayer MoS2 and electrodes are the major bottlenecks in developing high-performance field-effect transistors (FETs) that hinder the study of intrinsic quantum behaviors such as valley-
spin transport at low temperature. A gate-tunable graphene electrode platform has been developed to improve the performance of MoS2 FETs. However, intrinsic misalignment between the work function of pristine graphene and the conduction band of MoS2 results in a large threshold voltage for the FETs, because of which Ohmic contact behaviors are observed only at very high gate voltages and carrier concentrations (~1013 cm-2). Here, we present high-performance monolayer MoS2 FETs with Ohmic contact at a modest gate voltage by using a chemical-vapor-deposited (CVD) nitrogen-doped graphene with a high intrinsic electron carrier density. The CVD nitrogen-doped graphene and monolayer MoS2 hybrid FETs platform exhibited a large negative shifted threshold voltage of -54.2 V and barrier-free Ohmic contact under zero gate voltage. Transparent contact by nitrogen-doped graphene led to a 214% enhancement in the on-current and a four-fold improvement in the field-effect carrier mobility of monolayer MoS2 FETs compared with those of a pristine graphene electrode platform. The transport measurements, as well as Raman and X-ray photoelectron spectroscopy analyses before and after thermal annealing, reveal that the atomic C-N bonding in the CVD nitrogen-doped graphene is responsible for the dominant effects of electron doping. Large-scale nitrogen-doped graphene electrodes provide a promising device platform for the development of high-performance devices and the study of unique quantum behaviors.
We report on the nano-electron beam assisted fabrication of atomically sharp iron-based tips and on the creation of a nano-soldering iron for nano-interconnects using Fe-filled multiwalled carbon nanotubes (MWCNTs). High energy electron beam machinin
g has been proven a powerful tool to modify desired nanostructures for technological applications and to form molecular junctions and interconnections between carbon nanotubes. Recent studies showed the high degree of complexity in the creation of direct interconnections between multiwalled and CNTs having dissimilar diameters. Our technique allows for carving a MWCNT into a nanosoldering iron that was demonstrated capable of joining two separated halves of a tube. This approach could easily be extended to the interconnection of two largely dissimilar CNTs, between a CNT and a nanowire or between two nanowires.
We describe a film of highly-aligned single-walled carbon nanotubes that acts as an excellent terahertz linear polarizer. There is virtually no attenuation (strong absorption) when the terahertz polarization is perpendicular (parallel) to the nanotub
e axis. From the data we calculated the reduced linear dichrosim to be 3, corresponding to a nematic order parameter of 1, which demonstrates nearly perfect alignment as well as intrinsically anisotropic terahertz response of single-walled carbon nanotubes in the film.
سجل دخول لتتمكن من نشر تعليقات
التعليقات
جاري جلب التعليقات
سجل دخول لتتمكن من متابعة معايير البحث التي قمت باختيارها
