اشترك بالحزمة الذهبية واحصل على وصول غير محدود شمرا أكاديميا
تسجيل مستخدم جديدFork stamping of pristine carbon nanotubes onto ferromagnetic contacts for spin-valve devices
163
0
0.0
(
0
)
اسأل ChatGPT حول البحث
ﻻ يوجد ملخص باللغة العربية
We present a fabrication scheme called fork stamping optimized for the dry transfer of individual pristine carbon nanotubes (CNTs) onto ferromagnetic contact electrodes fabricated by standard lithography. We demonstrate the detailed recipes for a residue-free device fabrication and in-situ current annealing on suspended CNT spin-valve devices with ferromagnetic Permalloy (Py) contacts and report preliminary transport characterization and magnetoresistance experiments at cryogenic temperatures. This scheme can directly be used to implement more complex device structures, including multiple gates or superconducting contacts.
قيم البحث
اقرأ أيضاً
We present an investigation of different thin-film evaporated ferromagnetic materials for their suitability as electrodes in individual single-wall and multi-wall carbon nanotube-based spin devices. Various electrode shapes made from permalloy (Ni_{8
1}Fe_{19}), the diluted ferromagnet PdFe, and PdFe/Fe bilayers are studied for both their micromagnetic properties and their contact formation to carbon nanotubes. Suitable devices are tested in low-temperature electron transport measurements, displaying the typical tunneling magnetoresistance of carbon nanotube pseudo spin valves.
We report on spin dependent transport measurements in carbon nanotubes based multi-terminal circuits. We observe a gate-controlled spin signal in non-local voltages and an anomalous conductance spin signal, which reveal that both the spin and the orb
ital phase can be conserved along carbon nanotubes with multiple ferromagnetic contacts. This paves the way for spintronics devices exploiting both these quantum mechanical degrees of freedom on the same footing.
Graphene - a single atomic layer of graphite - is a recently-found two-dimensional form of carbon, which exhibits high crystal quality and ballistic electron transport at room temperature. Soft magnetic NiFe electrodes have been used to inject polari
zed spins into graphene and a 10% change in resistance has been observed as the electrodes switch from the parallel to the antiparallel state. This coupled with the fact that a field effect electrode can modulate the conductivity of these graphene films makes them exciting potential candidates for spin electronic devices.
This contribution reports on comparative studies on giant magnetoresistance (GMR) in carbon nanotubes (CNTs) and graphene nanoribbons of similar aspect ratios (i.e perimeter/length and width/length ratios, for the former and the latter, respectively)
. The problem is solved at zero temperature in the ballistic transport regime, by means of the Greens functions technique within the tight-binding model and with the so-called wide band approximation for electrodes. The GMR effect in graphene is comparable to that of CNTs, it depends strongly on the chirality and only slightly on the aspect ratio. It turns out that graphene, analogously to CNTs may be quite an interesting material for spintronic applications.
We report on a dry transfer technique for single wall carbon nanotube devices which allows to embed them in high finesse microwave cavity. We demonstrate the ground state charge readout and a quality factor of about 3000 down to the single photon reg
ime. This technique allows to make devices such as double quantum dots which could be instrumental for achieving the strong spin photon coupling. It can easily be extended to generic carbon nanotube based microwave devices.
سجل دخول لتتمكن من نشر تعليقات
التعليقات
جاري جلب التعليقات
سجل دخول لتتمكن من متابعة معايير البحث التي قمت باختيارها
