اشترك بالحزمة الذهبية واحصل على وصول غير محدود شمرا أكاديميا
تسجيل مستخدم جديدComparative Studies on Giant Magnetoresistance in Carbon Nanotubes and Graphene Nanoribbons with Ferromagnetic Contacts
262
0
0.0
(
0
)
تأليف
S. Krompiewski
اسأل ChatGPT حول البحث
ﻻ يوجد ملخص باللغة العربية
This contribution reports on comparative studies on giant magnetoresistance (GMR) in carbon nanotubes (CNTs) and graphene nanoribbons of similar aspect ratios (i.e perimeter/length and width/length ratios, for the former and the latter, respectively). The problem is solved at zero temperature in the ballistic transport regime, by means of the Greens functions technique within the tight-binding model and with the so-called wide band approximation for electrodes. The GMR effect in graphene is comparable to that of CNTs, it depends strongly on the chirality and only slightly on the aspect ratio. It turns out that graphene, analogously to CNTs may be quite an interesting material for spintronic applications.
قيم البحث
اقرأ أيضاً
Carbon-based nanostructures and graphene, in particular, evoke a lot of interest as new promising materials for nanoelectronics and spintronics. One of the most important issue in this context is the impact of external electrodes on electronic proper
ties of graphene nanoribbons (GNR). The present theoretical method is based on the tight-binding model and a modified recursive procedure for Greens functions. The results show that within the ballistic transport regime, the so called end-contacted geometry (of minimal GNR/electrode interface area), is usually more advantageous for practical applications than its side-contacted counterpart (with a larger coverage area), as far as the electrical conductivity is concerned. As regards the giant magnetoresistance coefficient, however, the situation is exactly opposite, since spin- splitting effects are more pronounced in the lower conductive side-contacted setups.
We present an investigation of different thin-film evaporated ferromagnetic materials for their suitability as electrodes in individual single-wall and multi-wall carbon nanotube-based spin devices. Various electrode shapes made from permalloy (Ni_{8
1}Fe_{19}), the diluted ferromagnet PdFe, and PdFe/Fe bilayers are studied for both their micromagnetic properties and their contact formation to carbon nanotubes. Suitable devices are tested in low-temperature electron transport measurements, displaying the typical tunneling magnetoresistance of carbon nanotube pseudo spin valves.
We use the robust nearest-neighbour tight-binding approximation to study on the same footing interband dipole transitions in narrow-bandgap carbon nanotubes and graphene nanoribbons. It is demonstrated that curvature effects in metallic single-walled
carbon nanotubes and edge effects in gapless graphene nanoribbons not only open up bang gaps, which typically correspond to THz frequencies, but also result in a giant enhancement of the probability of optical transitions across these gaps. Moreover, the matrix element of the velocity operator for these transitions has a universal value (equal to the Fermi velocity in graphene) when the photon energy coincides with the band-gap energy. Upon increasing the excitation energy, the transition matrix element first rapidly decreases (for photon energies remaining in the THz range but exceeding two band gap energies it is reduced by three orders of magnitude), and thereafter it starts to increase proportionally to the photon frequency. A similar effect occurs in an armchair carbon nanotube with a band gap opened and controlled by a magnetic field applied along the nanotube axis. There is a direct correspondence between armchair graphene nanoribbons and single-walled zigzag carbon nanotubes. The described sharp photon-energy dependence of the transition matrix element together with the van Hove singularity at the band gap edge of the considered quasi-one-dimensional systems make them promising candidates for active elements of coherent THz radiation emitters. The effect of Pauli blocking of low-energy interband transitions caused by residual doping can be suppressed by creating a population inversion using high-frequency (optical) excitation.
We report on spin dependent transport measurements in carbon nanotubes based multi-terminal circuits. We observe a gate-controlled spin signal in non-local voltages and an anomalous conductance spin signal, which reveal that both the spin and the orb
ital phase can be conserved along carbon nanotubes with multiple ferromagnetic contacts. This paves the way for spintronics devices exploiting both these quantum mechanical degrees of freedom on the same footing.
In this study, a model of a Schottky-barrier carbon nanotube field- effect transistor (CNT-FET), with ferromagnetic contacts, has been developed. The emphasis is put on analysis of current-voltage characteristics as well as shot (and thermal) noise.
The method is based on the tight-binding model and the non- equilibrium Greens function technique. The calculations show that, at room temperature, the shot noise of the CNT FET is Poissonian in the sub-threshold region, whereas in elevated gate and drain/source voltage regions the Fano factor gets strongly reduced. Moreover, transport properties strongly depend on relative magnetization orientations in the source and drain contacts. In particular, one observes quite a large tunnel magnetoresistance, whose absolute value may exceed 50%.
سجل دخول لتتمكن من نشر تعليقات
التعليقات
جاري جلب التعليقات
سجل دخول لتتمكن من متابعة معايير البحث التي قمت باختيارها
