اشترك بالحزمة الذهبية واحصل على وصول غير محدود شمرا أكاديميا
تسجيل مستخدم جديدDistributed Urban Freeway Traffic Optimization Considering Congestion Propagation
77
0
0.0
(
0
)
اسأل ChatGPT حول البحث
ﻻ يوجد ملخص باللغة العربية
Effective traffic optimization strategies can improve the performance of transportation networks significantly. Most exiting works develop traffic optimization strategies depending on the local traffic states of congested road segments, where the congestion propagation is neglected. This paper proposes a novel distributed traffic optimization method for urban freeways considering the potential congested road segments, which are called potential-homogeneous-area. The proposed approach is based on the intuition that the evolution of congestion may affect the neighbor segments due to the mobility of traffic flow. We identify potential-homogeneous-area by applying our proposed temporal-spatial lambda-connectedness method using historical traffic data. Further, global dynamic capacity constraint of this area is integrated with cell transmission model (CTM) in the traffic optimization problem. To reduce computational complexity and improve scalability, we propose a fully distributed algorithm to solve the problem, which is based on the partial augmented Lagrangian and dual-consensus alternating direction method of multipliers (ADMM). By this means, distributed coordination of ramp metering and variable speed limit control is achieved. We prove that the proposed algorithm converges to the optimal solution so long as the traffic optimization objective is convex. The performance of the proposed method is evaluated by macroscopic simulation using real data of Shanghai, China.
قيم البحث
اقرأ أيضاً
Capacity drop is an empirically observed phenomenon in vehicular traffic flow on freeways whereby, after a critical density is reached, a state of congestion sets in, but the freeway does not become decongested again until the density drops well belo
w the critical density. This introduces a hysteresis effect so that it is easier to enter the congested state than to leave it. However, many existing first-order models of traffic flow, particularly those used for control design, ignore capacity drop, leading to suboptimal controllers. In this paper, we consider a cell transmission model of traffic flow that incorporates capacity drop to study the problem of optimal freeway ramp metering. We show that, if capacity drop is ignored in the control design, then the resulting controller, obtained via a convex program, may be significantly suboptimal. We then propose an alternative model predictive controller that accounts for capacity drop via a mixed integer linear program and show that, for sufficiently large rollout horizon, this controller is optimal. We also compare these approaches to a heuristic hand-crafted controller that is viewed as a modification of an integral feedback controller to account for capacity drop. This heuristic controller outperforms the controller that ignores capacity drop but underperforms compared to the proposed alternative model predictive controller. These results suggest that it is generally important to include capacity drop in the controller design process, and we demonstrate this insight on several case studies.
Urban air mobility (UAM) has attracted the attention of aircraft manufacturers, air navigation service providers and governments in recent years. Preventing the conflict among urban aircraft is crucial to UAM traffic safety, which is a key in enablin
g large scale UAM operation. Pre-flight conflict-free path planning can provide a strategic layer in the maintenance of safety performance, thus becomes an important element in UAM. This paper aims at tackling conflict-free path planning problem for UAM operation with a consideration of four-dimensional airspace management. In the first place, we introduced and extended a four-dimensional airspace management concept, AirMatrix. On the basis of AirMatrix, we formulated the shortest flight time path planning problem considering resolution of conflicts with both static and dynamic obstacles. A Conflict-Free A-Star algorithm was developed for planning four-dimensional paths based on first-come-first-served scheme. The algorithm contains a novel design of heuristic function as well as a conflict detection and resolution strategy. Numerical experiment was carried out in Jurong East area in Singapore, and the results show that the algorithm can generate paths resolving a significant number of potential conflicts in airspace utilization, with acceptable computational time and flight delay. The contributions of this study provide references for stakeholders to support the development of UAM.
This paper studies a scalable control method for multi-zone heating, ventilation and air-conditioning (HVAC) systems to optimize the energy cost for maintaining thermal comfort and indoor air quality (IAQ) (represented by CO2) simultaneously. This pr
oblem is computationally challenging due to the complex system dynamics, various spatial and temporal couplings as well as multiple control variables to be coordinated. To address the challenges, we propose a two-level distributed method (TLDM) with a upper level and lower level control integrated. The upper level computes zone mass flow rates for maintaining zone thermal comfort with minimal energy cost, and then the lower level strategically regulates zone mass flow rates and the ventilation rate to achieve IAQ while preserving the near energy saving performance of upper level. As both the upper and lower level computation are deployed in a distributed manner, the proposed method is scalable and computationally efficient. The near-optimal performance of the method in energy cost saving is demonstrated through comparison with the centralized method. In addition, the comparisons with the existing distributed method show that our method can provide IAQ with only little increase of energy cost while the latter fails. Moreover, we demonstrate our method outperforms the demand controlled ventilation strategies (DCVs) for IAQ management with about 8-10% energy cost reduction.
The control and managing of power demand and supply become very crucial because of penetration of renewables in the electricity networks and energy demand increase in residential and commercial sectors. In this paper, a new approach is presented to b
ridge the gap between Demand-Side Management (DSM) and microgrid portfolio, sizing and placement optimization. Although DSM helps energy consumers to take advantage of recent developments in utilization of Distributed Energy Resources (DERs) especially microgrids, a huge need of connecting DSM results to microgrid optimization is being felt. Consequently, a novel model that integrates the DSM techniques and microgrid modules in a two-layer configuration is proposed. In the first layer, DSM is employed to minimize the electricity demand (e.g. heating and cooling loads) based on zone temperature set-point. Using the optimal load profile obtained from the first layer, all investment and operation costs of a microgrid are then optimized in the second layer. The presented model is based on the existing optimization platform developed by RU-LESS (Rutgers University, Laboratory for Energy Smart Systems) team. As a demonstration, the developed model has been used to study the impact of smart HVAC control on microgrid compared to traditional HVAC control. The results show a noticeable reduction in total annual energy consumption and annual cost of microgrid.
Mitigating traffic congestion on urban roads, with paramount importance in urban development and reduction of energy consumption and air pollution, depends on our ability to foresee road usage and traffic conditions pertaining to the collective behav
ior of drivers, raising a significant question: to what degree is road traffic predictable in urban areas? Here we rely on the precise records of daily vehicle mobility based on GPS positioning device installed in taxis to uncover the potential daily predictability of urban traffic patterns. Using the mapping from the degree of congestion on roads into a time series of symbols and measuring its entropy, we find a relatively high daily predictability of traffic conditions despite the absence of any a priori knowledge of drivers origins and destinations and quite different travel patterns between weekdays and weekends. Moreover, we find a counterintuitive dependence of the predictability on travel speed: the road segment associated with intermediate average travel speed is most difficult to be predicted. We also explore the possibility of recovering the traffic condition of an inaccessible segment from its adjacent segments with respect to limited observability. The highly predictable traffic patterns in spite of the heterogeneity of drivers behaviors and the variability of their origins and destinations enables development of accurate predictive models for eventually devising practical strategies to mitigate urban road congestion.
سجل دخول لتتمكن من نشر تعليقات
التعليقات
جاري جلب التعليقات
سجل دخول لتتمكن من متابعة معايير البحث التي قمت باختيارها
