اشترك بالحزمة الذهبية واحصل على وصول غير محدود شمرا أكاديميا
تسجيل مستخدم جديدUsing thermo-optical nonlinearity to robustly separate absorption and radiation losses in nanophotonic resonators
76
0
0.0
(
0
)
اسأل ChatGPT حول البحث
ﻻ يوجد ملخص باللغة العربية
Low-loss nanophotonic resonators have been widely used in fundamental science and applications thanks to their ability to concentrate optical energy. Key for resonator engineering, the total intrinsic loss is easily determined by spectroscopy, however, quantitatively separating absorption and radiative losses is challenging. While the concentrated heat generated by absorption within the small mode volume results in generally unwanted thermo-optical effects, they can provide a way for quantifying absorption. Here, we propose and experimentally demonstrate a technique for separating the loss mechanisms with high confidence using only linear spectroscopic measurements. We use the optically measured resonator thermal time constant to experimentally connect the easily-calculable heat capacity to the thermal impedance, needed to calculate the absorbed power from the temperature change. We report the absorption, radiation, and coupling losses for ten whispering-gallery modes of three different radial orders on a Si microdisk. Similar absorptive loss rates are found for all the modes, despite order-of-magnitude differences in the total dissipation rate due to widely differing radiation losses. Measuring radiation losses of many modes enables distinguishing the two major components of radiation loss originating from scattering and leakage. The all-optical characterization technique is applicable to any nanophotonic resonators subject to thermo-optical effects.
قيم البحث
اقرأ أيضاً
Advances in integrated photonics open exciting opportunities for batch-fabricated optical sensors using high quality factor nanophotonic cavities to achieve ultra-high sensitivities and bandwidths. The sensitivity improves with higher optical power,
however, localized absorption and heating within a micrometer-scale mode volume prominently distorts the cavity resonances and strongly couples the sensor response to thermal dynamics, limiting the sensitivity and hindering the measurement of broadband time-dependent signals. Here, we derive a frequency-dependent photonic sensor transfer function that accounts for thermo-optical dynamics and quantitatively describes the measured broadband optomechanical signal from an integrated photonic atomic-force-microscopy nanomechanical probe. Using this transfer function, the probe can be operated in the high optical power, strongly thermo-optically nonlinear regime, reaching a sensitivity of $approx$ 0.4 fm/Hz$^{1/2}$, an improvement of $approx 10times$ relative to the best performance in the linear regime. Counterintuitively, we discover that higher transduction gain and sensitivity are obtained with lower quality factor optical modes for low signal frequencies. Not limited to optomechanical transducers, the derived transfer function is generally valid for describing small-signal dynamic response of a broad range of technologically important photonic sensors subject to the thermo-optical effect.
Whispering gallery modes in GaAs disk resonators reach half a million of optical quality factor. These high Qs remain still well below the ultimate design limit set by bending losses. Here we investigate the origin of residual optical dissipation in
these devices. A Transmission Electron Microscope analysis is combined with an improved Volume Current Method to precisely quantify optical scattering losses by roughness and waviness of the structures, and gauge their importance relative to intrinsic material and radiation losses. The analysis also provides a qualitative description of the surface reconstruction layer, whose optical absorption is then revealed by comparing spectroscopy experiments in air and in different liquids. Other linear and nonlinear optical loss channels in the disks are evaluated likewise. Routes are given to further improve the performances of these miniature GaAs cavities.
Diamond integrated photonic devices are promising candidates for emerging applications in nanophotonics and quantum optics. Here we demonstrate active modulation of diamond nanophotonic circuits by exploiting mechanical degrees of freedom in free-sta
nding diamond electro-optomechanical resonators. We obtain high quality factors up to 9600, allowing us to read out the driven nanomechanical response with integrated optical interferometers with high sensitivity. We are able to excite higher order mechanical modes up to 115 MHz and observe the nanomechanical response also under ambient conditions.
Using metamaterial absorbers, we have shown that metallic layers in the absorbers do not necessarily constitute undesired resistive heating problem for photovoltaics. Tailoring the geometric skin depth of metals and employing the natural bulk absorba
nce characteristics of the semiconductors in those absorbers can enable the exchange of undesired resistive losses with the useful optical absorbance in the active semiconductors. Thus, Ohmic loss dominated metamaterial absorbers can be converted into photovoltaic near-perfect absorbers with the advantage of harvesting the full potential of light management offered by the metamaterial absorbers. Based on experimental permittivity data for indium gallium nitride, we have shown that between 75%-95% absorbance can be achieved in the semiconductor layers of the converted metamaterial absorbers. Besides other metamaterial and plasmonic devices, our results may also apply to photodectors and other metal or semiconductor based optical devices where resistive losses and power consumption are important pertaining to the device performance.
Optical nonlinearity plays a pivotal role in quantum information processing using photons, from heralded single-photon sources to long-sought quantum repeaters. Despite the availability of strong light-atom interaction, an all-optical nonlinearity is
highly desired for more scalable quantum protocols. Here, we realize quantum nanophotonic integrated circuits in thin-film InGaP with a record-high second-order optical nonlinearity of $1.5%$---the ratio of the single-photon trimodal coupling strength ($g/2pi=11.2$ MHz) and cavity-photon loss rate. We demonstrate photon-pair generation via degenerate spontaneous parametric down conversion in the InGaP photonic circuit with an ultrahigh rate exceeding 27.5 MHz per 1 $mu$W pump power and large coincidence-to-accidental ratio up to $1.4times 10^4$. Our work shows InGaP as a potentially transcending platform for quantum nonlinear optics and quantum information applications.
سجل دخول لتتمكن من نشر تعليقات
التعليقات
جاري جلب التعليقات
سجل دخول لتتمكن من متابعة معايير البحث التي قمت باختيارها
