اشترك بالحزمة الذهبية واحصل على وصول غير محدود شمرا أكاديميا
تسجيل مستخدم جديدSilicon-based Intermediate-band Infrared Photodetector realized by Te Hyperdoping
433
0
0.0
(
0
)
اسأل ChatGPT حول البحث
ﻻ يوجد ملخص باللغة العربية
Si-based photodetectors satisfy the criteria of low-cost and environmental-friendly, and can enable the development of on-chip complementary metal-oxide-semiconductor (CMOS)-compatible photonic systems. However, extending their room-temperature photoresponse into the mid-wavelength infrared (MWIR) regime remains challenging due to the intrinsic bandgap of Si. Here, we report on a comprehensive study of a room-temperature MWIR photodetector based on Si hyperdoped with Te. The demonstrated MWIR p-n photodiode exhibits a spectral photoresponse up to 5 {mu}m and a slightly lower detector performance than the commercial devices in the wavelength range of 1.0-1.9 {mu}m. We also investigate the correlation between the background noise and the sensitivity of the Te-hyperdoped Si photodiode, where the maximum room-temperature specific detectivity is found to be 3.2 x 10^12 cmHz^{1/2}W^{-1} and 9.2 x 10^8 cmHz^{1/2}W^{-1} at 1 {mu}m and 1.55 {mu}m, respectively. This work contributes to pave the way towards establishing a Si-based broadband infrared photonic system operating at room temperature.
قيم البحث
اقرأ أيضاً
The detection of light helicity is key to several research and industrial applications from drugs production to optical communications. However, the direct measurement of the light helicity is inherently impossible with conventional photodetectors ba
sed on III-V or IV-VI semiconductors, being naturally non-chiral. The prior polarization analysis of the light by a series of often moving optical elements is necessary before light is sent to the detector. A method is here presented to effectively give to the conventional dilute nitride GaAs-based semiconductor epilayer a chiral photoconductivity in paramagnetic-defect-engineered samples. The detection scheme relies on the giant spin-dependent recombination of conduction electrons and the accompanying spin polarization of the engineered defects to control the conduction band population via the electrons spin polarization. As the conduction electron spin polarization is, in turn, intimately linked to the excitation light polarization, the light polarization state can be determined by a simple conductivity measurement. This effectively gives the GaAsN epilayer a chiral photoconductivity capable of discriminating the handedness of an incident excitation light in addition to its intensity. This approach, removing the need of any optical elements in front of a non-chiral detector, could offer easier integration and miniaturisation. This new chiral photodetector could potentially operate in a spectral range from the visible to the infra-red using (In)(Al)GaAsN alloys or ion-implanted nitrogen-free III-V compounds.
(Si)GeSn semiconductors are finally coming of age after a long gestation period. The demonstration of device quality epi-layers and quantum-engineered heterostructures has meant that tunable all-group IV Si-integrated infrared photonics is now a real
possibility. Notwithstanding the recent exciting developments in (Si)GeSn materials and devices, this family of semiconductors is still facing serious limitations that need to be addressed to enable reliable and scalable applications. The main outstanding challenges include the difficulty to grow high crystalline quality layers and heterostructures at the desired Sn content and lattice strain, preserve the material integrity during growth and throughout device processing steps, and control doping and defect density. Other challenges are related to the lack of optimized device designs and predictive theoretical models to evaluate and simulate the fundamental properties and performance of (Si)GeSn layers and heterostructures. This Perspective highlights key strategies to circumvent these hurdles and bring this material system to maturity to create far-reaching new opportunities for Si-compatible infrared photodetectors, sensors, and emitters for applications in free-space communication, infrared harvesting, biological and chemical sensing, and thermal imaging.
We present a mid-IR ($lambda approx$ 8.3 $mu$m) quantum well infrared photodetector (QWIP) fabricated on a mid-IR transparent substrate, allowing photodetection with illumination from either the front surface or through the substrate. The device is b
ased on a 400 nm-thick GaAs/AlGaAs semiconductor QWIP heterostructure enclosed in a metal-insulator-metal (MIM) cavity and hosted on a mid-IR transparent ZnSe substrate. Metallic stripes are symmetrically patterned by e-beam lithography on both sides of the active region. The detector spectral coverage spans from $lambda approx 7.15$ $mu$m to $lambda approx 8.7$ $mu$m by changing the stripe width L - from L = 1.0 $mu$m to L = 1.3 $mu$m - thus frequency-tuning the optical cavity mode. Both micro-FTIR passive optical characterizations and photocurrent measurements of the two-port system are carried out. They reveal a similar spectral response for the two detector ports, with an experimentally measured T$_{BLIP}$ of $approx$ 200K.
We report a high Responsivity broad band photo-detector working in the wavelength range 400 nm to 1100 nm in a horizontal array of Si microlines (line width ~1 micron) fabricated on a Silicon-on-Insulator (SOI) wafer. The array was made using a combi
nation of plasma etching, wet etching and electron beam lithography. It forms a partially suspended (nearly free) Silicon microstructure on SOI. The array detector under full illumination of the device shows a peak Responsivity of 18 A/W at 800 nm, at a bias of 1V which is more than an order of magnitude of the Responsivity in a commercial Si detector. In a broad band of 400 nm to 1000 nm the Responsivity of the detector is in excess of 10A/W. We found that the suspension of the microlines in the array is necessary to obtain such high Responsivity. The suspension isolates the microlines from the bulk of the wafer and inhibits carrier recombination by the underlying oxide layer leading to enhanced photo-response. This has been validated through simulation. By using focused illumination of selected parts of a single microline of the array, we could isolate the contributions of the different parts of the microline to the photo-current.
In the field of quantum photon sources, single photon emitter from solid is of fundamental importance for quantum computing, quantum communication, and quantum metrology. However, it has been an ultimate but seemingly distant goal to find the single
photon sources that stable at room or high temperature, with high-brightness and broad ranges emission wavelength that successively cover ultraviolet to infrared in one host material. Here, we report an ultraviolet to near-infrared broad-spectrum single photon emitters (SPEs) based on a wide band-gap semiconductor material hexagonal boron nitride (hBN). The bright, high purity and stable SPEs with broad-spectrum are observed by using the resonant excitation technique. The single photon sources here can be operated at liquid helium, room temperature and even up to 1100 K. Depending on the excitation laser wavelengths, the SPEs can be dramatically observed from 357 nm to 896 nm. The single photon purity is higher than to 90 percentage and the narrowest linewidth of SPE is down to $sim$75 $mu$eV at low temperature, which reaches the resolution limit of our spectrometer. Our work not only paves a way to engineer a monolithic semiconductor tunable SPS, but also provides fundamental experimental evidence to understand the electronic and crystallographic structure of SPE defect states in hBN.
سجل دخول لتتمكن من نشر تعليقات
التعليقات
جاري جلب التعليقات
سجل دخول لتتمكن من متابعة معايير البحث التي قمت باختيارها
