اشترك بالحزمة الذهبية واحصل على وصول غير محدود شمرا أكاديميا
تسجيل مستخدم جديدRole of ferroelectric polarization during growth of highly strained ferroelectrics revealed by in-situ x-ray diffraction
133
0
0.0
(
0
)
اسأل ChatGPT حول البحث
ﻻ يوجد ملخص باللغة العربية
Strain engineering of perovskite oxide thin films has proven to be an extremely powerful method for enhancing and inducing ferroelectric behavior. In ferroelectric thin films and superlattices, the polarization is intricately linked to crystal structure, but we show here that it can also play an important role in the growth process, influencing growth rates, relaxation mechanisms, electrical properties and domain structures. We have studied this effect in detail by focusing on the properties of BaTiO$_{3}$ thin films grown on very thin layers of PbTiO$_{3}$ using a combination of x-ray diffraction, piezoforce microscopy, electrical characterization and rapid in-situ x-ray diffraction reciprocal space maps during the growth using synchrotron radiation. Using a simple model we show that the changes in growth are driven by the energy cost for the top material to sustain the polarization imposed upon it by the underlying layer, and these effects may be expected to occur in other multilayer systems where polarization is present during growth. Our research motivates the concept of polarization engineering during the growth process as a new and complementary approach to strain engineering.
قيم البحث
اقرأ أيضاً
In epitaxially strained ferroelectric thin films and superlattices, the ferroelectric transition temperature can lie above the growth temperature. Ferroelectric polarization and domains should then evolve during the growth of a sample, and electrosta
tic boundary conditions may play an important role. In this work, ferroelectric domains, surface termination, average lattice parameter and bilayer thickness are simultaneously monitored using in-situ synchrotron x-ray diffraction during the growth of BaTiO$_3$/SrTiO$_3$ superlattices on SrTiO$_3$ substrates by off-axis RF magnetron sputtering. The technique used allows for scan times substantially faster than the growth of a single layer of material. Effects of electric boundary conditions are investigated by growing the same superlattice alternatively on SrTiO$_3$ substrates and 20nm SrRuO$_3$ thin films on SrTiO$_3$ substrates. These experiments provide important insights into the formation and evolution of ferroelectric domains when the sample is ferroelectric during the growth process.
Using density-functional calculations we study the structure and polarization response of tetragonal PbTiO3, BaTiO3 and SrTiO3 in a strain regime that is previously overlooked. Different from common expectations, we find that the polarizations in all
three substances saturate at large strains, demonstrating a universal phenomenon. The saturation is shown to originate from an unusual and strong electron-ion correlation that leads to cancellation between electronic and ionic polarizations. Our results shed new insight on the polarization properties, and reveal the existence of a fundamental limit to the strain-induced polarization enhancement.
Molecular beam epitaxy of Fe3Si on GaAs(001) is studied in situ by grazing incidence x-ray diffraction. Layer-by-layer growth of Fe3Si films is observed at a low growth rate and substrate temperatures near 200 degrees Celsius. A damping of x-ray inte
nsity oscillations due to a gradual surface roughening during growth is found. The corresponding sequence of coverages of the different terrace levels is obtained. The after-deposition surface recovery is very slow. Annealing at 310 degrees Celsius combined with the deposition of one monolayer of Fe3Si restores the surface to high perfection and minimal roughness. Our stoichiometric films possess long-range order and a high quality heteroepitaxial interface.
In-situ X-ray diffraction (XRD) and transmission electron microscopy (TEM) have been used to investigate many physical science phenomena, ranging from phase transitions, chemical reaction and crystal growth to grain boundary dynamics. A major limitat
ion of in-situ XRD and TEM is a compromise that has to be made between spatial and temporal resolution. Here, we report the development of in-situ X-ray nanodiffraction to measure atomic-resolution diffraction patterns from single grains with up to 5 millisecond temporal resolution, and make the first real-time observation of grain rotation and lattice deformation during photoinduced chemical reactions. The grain rotation and lattice deformation associated with the chemical reactions are quantified to be as fast as 3.25 rad./sec. and as large as 0.5 Angstroms, respectively. The ability to measure atomic-resolution diffraction patterns from individual grains with several millisecond temporal resolution is expected to find broad applications in materials science, physics, chemistry, and nanoscience.
The stacking sequence of hexagonal close-packed and related crystals typically results in steps on vicinal {0001} surfaces that have alternating A and B structures with different growth kinetics. However, because it is difficult to experimentally ide
ntify which step has the A or B structure, it has not been possible to determine which has faster adatom attachment kinetics. Here we show that in situ microbeam surface X-ray scattering can determine whether A or B steps have faster kinetics under specific growth conditions. We demonstrate this for organo-metallic vapor phase epitaxy of (0001) GaN. X-ray measurements performed during growth find that the average width of terraces above A steps increases with growth rate, indicating that attachment rate constants are higher for A steps, in contrast to most predictions. Our results have direct implications for understanding the atomic-scale mechanisms of GaN growth and can be applied to a wide variety of related crystals.
سجل دخول لتتمكن من نشر تعليقات
التعليقات
جاري جلب التعليقات
سجل دخول لتتمكن من متابعة معايير البحث التي قمت باختيارها
