اشترك بالحزمة الذهبية واحصل على وصول غير محدود شمرا أكاديميا
تسجيل مستخدم جديدThermally Oxidized Two-dimensional TaS2 as a High-k{appa} Gate Dielectric for MoS2 Field-Effect Transistors
93
0
0.0
(
0
)
اسأل ChatGPT حول البحث
ﻻ يوجد ملخص باللغة العربية
We report a new approach to integrating high-k{appa} dielectrics in both bottom- and top-gated MoS2 field-effect transistors (FETs) through thermal oxidation and mechanical assembly of layered twodimensional (2D) TaS2. Combined X-ray photoelectron spectroscopy (XPS), optical microscopy, atomic force microscopy (AFM), and capacitance-voltage (C-V) measurements confirm that multilayer TaS2 flakes can be uniformly transformed to Ta2O5 with a high dielectric constant of ~ 15.5 via thermal oxidation, while preserving the geometry and ultra-smooth surfaces of 2D TMDs. Top-gated MoS2 FETs fabricated using the thermally oxidized Ta2O5 as gate dielectric demonstrate a high current on/off ratio approaching 106, a subthreshold swing (SS) down to 61 mV/dec, and a field-effect mobility exceeding 60 cm2V-1 s-1 at room temperature, indicating high dielectric quality and low interface trap density.
قيم البحث
اقرأ أيضاً
We introduce a fabrication method for gate-all-around nanowire field-effect transistors. Single nanowires were aligned perpendicular to underlying bottom gates using a resist-trench alignment technique. Top gates were then defined aligned to the bott
om gates to form gate-all-around structures. This approach overcomes significant limitations in minimal obtainable gate length and gate-length control in previous horizontal wrap-gated nanowire transistors that arise because the gate is defined by wet etching. In the method presented here gate-length control is limited by the resolution of the electron-beam-lithography process. We demonstrate the versatility of our approach by fabricating a device with an independent bottom gate, top gate, and gate-all-around structure as well as a device with three independent gate-all-around structures with 300 nm, 200 nm, and 150 nm gate length. Our method enables us to achieve sub-threshold swings as low as 38 mV/dec at 77 K for a 150 nm gate length.
We report the development of nanowire field-effect transistors featuring an ultra-thin parylene film as a polymer gate insulator. The room temperature, gas-phase deposition of parylene is an attractive alternative to oxide insulators prepared at high
temperatures using atomic layer deposition. We discuss our custom-built parylene deposition system, which is designed for reliable and controlled deposition of <100 nm thick parylene films on III-V nanowires standing vertically on a growth substrate or horizontally on a device substrate. The former case gives conformally-coated nanowires, which we used to produce functional $Omega$-gate and gate-all-around structures. These give sub-threshold swings as low as 140 mV/dec and on/off ratios exceeding $10^3$ at room temperature. For the gate-all-around structure, we developed a novel fabrication strategy that overcomes some of the limitations with previous lateral wrap-gate nanowire transistors. Finally, we show that parylene can be deposited over chemically-treated nanowire surfaces; a feature generally not possible with oxides produced by atomic layer deposition due to the surface `self-cleaning effect. Our results highlight the potential for parylene as an alternative ultra-thin insulator in nanoscale electronic devices more broadly, with potential applications extending into nanobioelectronics due to parylenes well-established biocompatible properties.
Electrical characterization of few-layer MoS2 based field effect transistors with Ti/Au electrodes is performed in the vacuum chamber of a scanning electron microscope in order to study the effects of electron beam irradiation on the transport proper
ties of the device. A negative threshold voltage shift and a carrier mobility enhancement is observed and explained in terms of positive charges trapped in the SiO2 gate oxide, during the irradiation. The transistor channel current is increased up to three order of magnitudes after the exposure to an irradiation dose of 100e-/nm2. Finally, a complete field emission characterization of the MoS2 flake, achieving emission stability for several hours and a minimum turn-on field of about 20 V/um with a field enhancement factor of about 500 at anode-cathode distance of 1.5um, demonstrates the suitability of few-layer MoS2 as two-dimensional emitting surface for cold-cathode applications.
Non-volatile memory devices have been limited to flash architectures that are complex devices. Here, we present a unique photomemory effect in MoS$_2$ transistors. The photomemory is based on a photodoping effect - a controlled way of manipulating th
e density of free charges in monolayer MoS$_2$ using a combination of laser exposure and gate voltage application. The photodoping promotes changes on the conductance of MoS$_2$ leading to photomemory states with high memory on/off ratio. Such memory states are non-volatile with an expectation of retaining up to 50 % of the information for tens of years. Furthermore, we show that the photodoping is gate-tunable, enabling control of the recorded memory states. Finally, we propose a model to explain the photodoping, and we provide experimental evidence supporting such a phenomenon. In summary, our work includes the MoS$_2$ phototransistors in the non-volatile memory devices and expands the possibilities of memory application beyond conventional memory architectures.
For the first time, n-type few-layer MoS2 field-effect transistors with graphene/Ti as the hetero-contacts have been fabricated, showing more than 160 mA/mm drain current at 1 {mu}m gate length with an on-off current ratio of 107. The enhanced electr
ical characteristic is confirmed in a nearly 2.1 times improvement in on-resistance and a 3.3 times improvement in contact resistance with hetero-contacts compared to the MoS2 FETs without graphene contact layer. Temperature dependent study on MoS2/graphene hetero-contacts has been also performed, still unveiling its Schottky contact nature. Transfer length method and a devised I-V method have been introduced to study the contact resistance and Schottky barrier height in MoS2/graphene /metal hetero-contacts structure.
سجل دخول لتتمكن من نشر تعليقات
التعليقات
جاري جلب التعليقات
سجل دخول لتتمكن من متابعة معايير البحث التي قمت باختيارها
