ترغب بنشر مسار تعليمي؟ اضغط هنا

Controllable growth of centimeter-size 2D perovskite heterostructural single crystals for highly narrow dual-band photodetectors

136   0   0.0 ( 0 )
 نشر من قبل Dehui Li
 تاريخ النشر 2018
  مجال البحث فيزياء
والبحث باللغة English




اسأل ChatGPT حول البحث

Two-dimensional (2D) organic-inorganic perovskites have recently attracted increasing attention due to their great environmental stability, remarkable quantum confinement effect and layered characteristic. Heterostructures consisting of 2D layered perovskites are expected to exhibit new physical phenomena inaccessible to the single 2D perovskites and can greatly extend their functionalities for novel electronic and optoelectronic applications. Herein, we develop a novel solution method to synthesize 2D perovskite single-crystals with the centimeter size, high phase purity, controllable junction depth, high crystalline quality and great stability for highly narrow dual-band photodetectors. On the basis of the different lattice constant, solubility and growth rate between different n number, the newly designed synthesis method allows to first grow n=1 perovskite guided by the self-assembled layer of the organic cations at the water-air interface and subsequently n=2 layer is formed via diffusion process. Such growth process provides an efficient away for us to readily obtain 2D perovskite heterostructural single-crystals with various thickness and junction depth by controlling the concentration, reaction temperature and time. Photodetectors based on such heterostructural single crystal plates exhibit extremely low dark current, high on-off current ratio, and highly narrow dual-band spectral response with a full-width at half-maximum of 20 nm at 540 nm and 34 nm at 610 nm. In particular, the synthetic strategy is general for other 2D perovskites and the narrow dual-band spectral response with all full-width at half-maximum below 40 nm can be continuously tuned from red to blue by properly changing the halide compositions.



قيم البحث

اقرأ أيضاً

Two-dimensional (2D) magnets with intrinsic ferromagnetic/antiferromagnetic (FM/AFM) ordering are highly desirable for future spintronics devices. However, the synthesis of 2D magnetic crystals, especially the direct growth on SiO2/Si substrate, is j ust in its infancy. Here, we report a chemical vapor deposition (CVD)-based rational growth approach for the synthesis of ultrathin FeTe crystals with controlled structural and magnetic phases. By precisely optimizing the growth temperature (Tgrowth), FeTe nanoplates with either layered tetragonal or non-layered hexagonal phase can be controlled with high-quality. The two controllable phases lead to square and triangular morphologies with a thickness down to 3.6 and 2.8 nm, respectively. More importantly, transport measurements reveal that tetragonal FeTe is antiferromagnetic with a Neel temperature (TN) about 71.8 K, while hexagonal FeTe is ferromagnetic with a Curie temperature (TC) around 220 K. Theoretical calculations indicate that the ferromagnetic order in hexagonal FeTe is originated from a concomitant lattice distortion and the spin-lattice coupling. This study represents a major step forward in the CVD growth of 2D magnetic materials on SiO2/Si substrates and highlights on their potential applications in the future spintronic devices.
Two-dimensional (2D) perovskites or Ruddleson Popper (RP) perovskites have emerged as a class of material inheriting the superior optoelectronic properties of two different materials: perovskites and 2D materials. The large exciton binding energy and natural quantum well structure of 2D perovskite not only make these materials ideal platforms to study light-matter interactions, but also render them suitable for fabrication of various functional optoelectronic devices. Nanoscale structuring and morphology control have led to semiconductors with enhanced functionalities. For example, nanowires of semiconducting materials have been extensively used for important applications like lasing and sensing. Catalyst-assisted Vapor Liquid Solid (VLS) techniques, and template assisted growth, have conventionally been used for nanowire growth. However, catalyst and template-free scalable growth with morphology control of 2D perovskites have remained elusive. In this manuscript, we demonstrate a facile approach for morphology-controlled growth of high-quality nanowires of 2D perovskite, (BA)2PbI4. We demonstrate that the photoluminescence (PL) from the nanowires are highly polarized with a polarization ratio as large as ~ 0.73, which is one of the largest reported for perovskites. We further show that the photocurrent from the device based on the nanowire/graphene heterostructure is also sensitive to the polarization of the incident light with the photocurrent anisotropy ratio of ~3.62 (much larger than the previously reported best value of 2.68 for perovskite nanowires), thus demonstrating the potential of these nanowires as highly efficient photodetectors of polarized light.
115 - Lei Tang , Tao Li , Yuting Luo 2020
Two-dimensional (2D) transition metal dichalcogenides (TMDCs) have attracted great attention due to their physical and chemical properties that make them promising in electronics and optoelectronics. Because of the difficulties in controlling concent rations of solid precursors and spatially non-uniform growth dynamics, it is challenging to grow wafer-scale 2D TMDCs with good uniformity and reproducibility so far, which significantly hinders their practical use. Here we report a vertical chemical vapor deposition (VCVD) design to grow monolayer TMDCs with a uniform density and high quality over the whole wafer, and with excellent reproducibility. The use of such VCVD design can easily control the three key growth parameters of precursor concentration, gas flow and temperature, which cannot be done in currently widely-used horizontal CVD system. Statistical results show that VCVD-grown monolayer TMDCs including MoS2 and WS2 are of high uniformity and quality on substrates over centimeter size. We also fabricated multiple van der Waals heterostructures by the one-step transfer of VCVD-grown TMDC samples, owning to its good uniformity. This work opens a way to grow 2D materials with high uniformity and reproducibility on the wafer scale, which can be used for the scalable fabrication of 2D materials and their heterostructures.
Thermal wave crystals based on the dual-phase-lag model are investigated in this paper by both theoretical analysis and numerical simulation to control the non-Fourier heat conduction process. The transfer matrix method is used to calculate the compl ex dispersion curves. The temperature field is calculated by the finite difference time domain method. The results show that thermal band-gaps exist due to the Bragg-scattering. The key parameters characterizing the band-gaps are analyzed. The thermal wave impedance and mid-gap frequencies are introduced to predict band-gaps theoretically. Our results show that the larger the difference in the thermal wave impedances is, the wider of the thermal band-gaps will be. This study demonstrates a type of the thermal metamaterials which have potential innovative applications such as thermal imagining, thermal diodes and thermal waveguides for energy transmission.
It is thought that growing large, oriented grains of perovskite can lead to more efficient devices. We study MAPbI3 films fabricated via Flash Infrared Annealing (FIRA) consisting of highly oriented, large grains. Domains observed in the SEM are ofte n misidentified with crystallographic grains, but SEM images dont provide diffraction information. We measure the grain size, crystal structure and grain orientation using Electron Back-Scattered Diffraction (EBSD) and we study how these affect the optoelectronic properties as characterized by local photoluminescence (PL) and time-resolved microwave conductivity measurements (TRMC). We find a spherulitic growth yielding large (tens of micron), highly oriented grains along the (112) and (400) planes in contrast to randomly oriented, smaller (400 nm) grains observed in films fabricated via conventional antisolvent (AS) dripping. We observe a local enhancement and shift of the photoluminescence emission at different regions of the FIRA clusters, but these can be explained with a combination of light-outcoupling and self-absorption. We observe no effect of crystal orientation on the optoelectronic properties. Additionally, despite a substantial difference in grain size between our FIRA sample and a conventional AS sample, we find similar photoluminescence and charge carrier mobilities and lifetime for the two films. These findings show that the optoelectronic quality is not necessarily related to the orientation and size of crystalline domains in perovskite films indicating that fabrication requirements may be more relaxed for perovskites.
التعليقات
جاري جلب التعليقات جاري جلب التعليقات
سجل دخول لتتمكن من متابعة معايير البحث التي قمت باختيارها
mircosoft-partner

هل ترغب بارسال اشعارات عن اخر التحديثات في شمرا-اكاديميا