ترغب بنشر مسار تعليمي؟ اضغط هنا

Using Spontaneous Emission of a Qubit as a Resource for Feedback Control

115   0   0.0 ( 0 )
 نشر من قبل Benjamin Huard
 تاريخ النشر 2016
  مجال البحث فيزياء
والبحث باللغة English




اسأل ChatGPT حول البحث

Persistent control of a transmon qubit is performed by a feedback protocol based on continuous heterodyne measurement of its fluorescence. By driving the qubit and cavity with microwave signals whose amplitudes depend linearly on the instantaneous values of the quadratures of the measured fluorescence field, we show that it is possible to stabilize permanently the qubit in any targeted state. Using a Josephson mixer as a phase-preserving amplifier, it was possible to reach a total measurement efficiency $eta$=35%, leading to a maximum of 59% of excitation and 44% of coherence for the stabilized states. The experiment demonstrates multiple-input multiple-output analog Markovian feedback in the quantum regime.



قيم البحث

اقرأ أيضاً

We present a technique to measure the transfer function of a control line using a qubit as a vector network analyzer. Our method requires coupling the line under test to the the longitudinal component of the Hamiltonian of the qubit and the ability t o induce Rabi oscillations through simultaneous driving of the transversal component. We used this technique to characterize the flux control of a superconducting Transmon qubit in the range of 8 to 400,MHz. Our method can be used for the qubit flux line calibration to increase the fidelity of entangling gates for the quantum processor. The qubit can be also used as a microscopic probe of the electro-magnetic fields on a chip.
Future communication and computation technologies that exploit quantum information require robust and well-isolated qubits. Electron spins in III-V semiconductor quantum dots, while promising candidates, see their dynamics limited by undesirable hyst eresis and decohering effects of the nuclear spin bath. Replacing electrons with holes should suppress the hyperfine interaction and consequently eliminate strong nuclear effects. Using picosecond optical pulses, we demonstrate coherent control of a single hole qubit and examine both free-induction and spin-echo decay. In moving from electrons to holes, we observe significantly reduced hyperfine interactions, evidenced by the reemergence of hysteresis-free dynamics, while obtaining similar coherence times, limited by non-nuclear mechanisms. These results demonstrate the potential of optically controlled, quantum dot hole qubits.
We develop a systematic method of performing corrected gate operations on an array of exchange-coupled singlet-triplet qubits in the presence of both fluctuating nuclear Overhauser field gradients and charge noise. The single-qubit control sequences we present have a simple form, are relatively short, and form the building blocks of a corrected CNOT gate when also implemented on the inter-qubit exchange link. This is a key step towards enabling large-scale quantum computation in a semiconductor-based architecture by facilitating error reduction below the quantum error correction threshold for both single-qubit and multi-qubit gate operations.
The interaction between a qubit and its environment provides a channel for energy relaxation which has an energy-dependent timescale governed by the specific coupling mechanism. We measure the rate of inelastic decay in a Si MOS double quantum dot (D QD) charge qubit through sensing the charge states response to non-adiabatic driving of its excited state population. The charge distribution is sensed remotely in the weak measurement regime. We extract emission rates down to kHz frequencies by measuring the variation of the non-equilibrium charge occupancy as a function of amplitude and dwell times between non-adiabatic pulses. Our measurement of the energy-dependent relaxation rate provides a fingerprint of the relaxation mechanism, indicating that relaxation rates for this Si MOS DQD are consistent with coupling to deformation acoustic phonons.
108 - K. Kakuyanagi , A. Kemp , T. Baba 2015
Quantum feedback is a technique for measuring a qubit and applying appropriate feedback depending on the measurement results. Here, we propose a new on-chip quantum feedback method where the measurement-result information is not taken from the chip t o the outside of a dilution refrigerator. This can be done by using a selective qubit-energy shift induced by measurement apparatus. We demonstrate on-chip quantum feedback and succeed in the rapid initialization of a qubit by flipping the qubit state only when we detect the ground state of the qubit. The feedback loop of our quantum feedback method closed on a chip, and so the operating time needed to control a qubit is of the order of 10 ns. This operating time is shorter than with the convectional off-chip feedback method. Our on-chip quantum feedback technique opens many possibilities such as an application to quantum information processing and providing an understanding of the foundation of thermodynamics for quantum systems.
التعليقات
جاري جلب التعليقات جاري جلب التعليقات
سجل دخول لتتمكن من متابعة معايير البحث التي قمت باختيارها
mircosoft-partner

هل ترغب بارسال اشعارات عن اخر التحديثات في شمرا-اكاديميا