ترغب بنشر مسار تعليمي؟ اضغط هنا

A scalable architecture for distributed receive beamforming: analysis and experimental demonstration

157   0   0.0 ( 0 )
 نشر من قبل Francois Quitin
 تاريخ النشر 2015
  مجال البحث الهندسة المعلوماتية
والبحث باللغة English




اسأل ChatGPT حول البحث

We propose, analyze and demonstrate an architecture for scalable cooperative reception. In a cluster of N + 1 receive nodes, one node is designated as the final receiver, and the N other nodes act as amplify-and-forward relays which adapt their phases such that the relayed signals add up constructively at the designated receiver. This yields received SNR scaling linearly with N, while avoiding the linear increase in overhead incurred by a direct approach in which received signals are separately quantized and transmitted for centralized processing. By transforming the task of long-distance distributed receive beamforming into one of local distributed transmit beamforming, we can leverage a scalable one-bit feedback algorithm for phase synchronization. We show that time division between the long-distance and local links eliminates the need for explicit frequency synchronization. We provide an analytical framework, whose results closely match Monte Carlo simulations, to evaluate the impact of phase noise due to relaying delay on the performance of the one-bit feedback algorithm. Experimental results from our prototype implementation on software-defined radios demonstrate the expected gains in received signal strength despite significant oscillator drift, and are consistent with results from our analytical framework.



قيم البحث

اقرأ أيضاً

123 - Elad Domanovitz , Uri Erez 2019
A simple method is proposed for use in a scenario involving a single-antenna source node communicating with a destination node that is equipped with two antennas via multiple single-antenna relay nodes, where each relay is subject to an individual po wer constraint. Furthermore, ultra-reliable and low-latency communication are desired. The latter requirement translates to considering only schemes that make use of local channel state information. Whereas for a receiver equipped with a single antenna, distributed beamforming is a well known and adequate solution, no straightforward extension is known. In this paper, a scheme is proposed based on a space-time diversity transformation that is applied as a front-end operation at the destination node. This results in an effective unitary channel matrix replacing the scalar coefficient corresponding to each user. Each relay node then inverts its associated channel matrix, which is the generalization of undoing the channel phase in the classical case of distributed beamforming to a single-antenna receiver, and then repeats the message over the resulting gain-only channel. In comparison to a single-antenna destination node, the method doubles the diversity order without requiring any channel state information at the receiver while at the same time retaining the array gain offered by the relays.
285 - Linlin Sun , Yaolu Qin , Feng Shu 2018
Medium-scale or large-scale receive antenna array with digital beamforming can be employed at receiver to make a significant interference reduction, but leads to expensive cost and high complexity of the RF-chain circuit. To deal with this issue, a c lassic analog-and-digital beamforming (ADB) structure was proposed in the literature for greatly reducing the number of RF-chains. Based on the ADB structure, we in this paper propose a robust hybrid ADB scheme to resist directions of arrival (DOAs) estimation errors. The key idea of our scheme is to employ null space projection (NSP) in analog beamforming domain and diagonal loading (DL) method in digital beamforming domain. Simulation results show that the proposed scheme performs more robustly, and moreover, has a significant improvement on the receive signal to interference plus noise ratio (SINR) compared to NSP ADB scheme and DL method.
We consider the problem of quantifying the Pareto optimal boundary in the achievable rate region over multiple-input single-output (MISO) interference channels, where the problem boils down to solving a sequence of convex feasibility problems after c ertain transformations. The feasibility problem is solved by two new distributed optimal beamforming algorithms, where the first one is to parallelize the computation based on the method of alternating projections, and the second one is to localize the computation based on the method of cyclic projections. Convergence proofs are established for both algorithms.
160 - Yin Teng , Jiayu Li , Lin Liu 2020
In this paper, we present a novel scenario for directional modulation (DM) networks with a full-duplex (FD) malicious attacker (Mallory), where Mallory can eavesdrop the confidential message from Alice to Bob and simultaneously interfere Bob by sendi ng a jamming signal. Considering that the jamming plus noise at Bob is colored, an enhanced receive beamforming (RBF), whitening-filter-based maximum ratio combining (MRC) (WFMRC), is proposed. Subsequently, two RBFs of maximizing the secrecy rate (Max-SR) and minimum mean square error (MMSE) are presented to show the same performance as WFMRC. To reduce the computational complexity of conventional MMSE, a low-complexity MMSE is also proposed. Eventually, to completely remove the jamming signal from Mallory and transform the residual interference plus noise to a white one, a new RBF, null-space projection (NSP) based maximizing WF receive power, called NSP-based Max-WFRP, is also proposed. From simulation results, we find that the proposed Max-SR, WFMRC, and low-complexity MMSE have the same SR performance as conventional MMSE, and achieve the best performance while the proposed NSP-based Max-WFRP performs better than MRC in the medium and high signal-to-noise ratio regions. Due to its low-complexity,the proposed low-complexity MMSE is very attractive. More important, the proposed methods are robust to the change in malicious jamming power compared to conventional MRC.
In this paper, we develop an analytical framework for the initial access (a.k.a. Base Station (BS) discovery) in a millimeter-wave (mm-wave) communication system and propose an effective strategy for transmitting the Reference Signals (RSs) used for BS discovery. Specifically, by formulating the problem of BS discovery at User Equipments (UEs) as hypothesis tests, we derive a detector based on the Generalised Likelihood Ratio Test (GLRT) and characterise the statistical behaviour of the detector. The theoretical results obtained allow analysis of the impact of key system parameters on the performance of BS discovery, and show that RS transmission with narrow beams may not be helpful in improving the overall BS discovery performance due to the cost of spatial scanning. Using the method of large deviations, we identify the desirable beam pattern that minimises the average miss-discovery probability of UEs within a targeted detectable region. We then propose to transmit the RS with sequential scanning, using a pre-designed codebook with narrow and/or wide beams to approximate the desirable patterns. The proposed design allows flexible choices of the codebook sizes and the associated beam widths to better approximate the desirable patterns. Numerical results demonstrate the effectiveness of the proposed method.
التعليقات
جاري جلب التعليقات جاري جلب التعليقات
سجل دخول لتتمكن من متابعة معايير البحث التي قمت باختيارها
mircosoft-partner

هل ترغب بارسال اشعارات عن اخر التحديثات في شمرا-اكاديميا