اشترك بالحزمة الذهبية واحصل على وصول غير محدود شمرا أكاديميا
تسجيل مستخدم جديدEpitaxial Growth of Spinel Cobalt Ferrite Films on MgAl$_2$O$_4$ Substrates by Direct Liquid Injection Chemical Vapor Deposition
194
0
0.0
(
0
)
اسأل ChatGPT حول البحث
ﻻ يوجد ملخص باللغة العربية
The direct liquid injection chemical vapor deposition (DLI-CVD) technique has been used for the growth of cobalt ferrite (CFO) films on (100)-oriented MgAl$_2$O$_4$ (MAO) substrates. Smooth and highly epitaxial cobalt ferrite thin films, with the epitaxial relationship $mathrm{MAO} (100):[001] parallel mathrm{CFO} (100):[001]$, are obtained under optimized deposition conditions. The films exhibit bulk-like structural and magnetic properties with an out-of-plane lattice constant of $8.370;mathrm{AA}$ and a saturation magnetization of $420;mathrm{kA/m}$ at room temperature. The Raman spectra of films on MgAl$_2$O$_4$ support the fact that the Fe$^{3+}$- and the Co$^{2+}$-ions are distributed in an ordered fashion on the B-site of the inverse spinel structure. The DLI-CVD technique has been extended for the growth of smooth and highly oriented cobalt ferrite thin films on a variety of other substrates, including MgO, and piezoelectric lead magnesium niobate-lead titanate and lead zinc niobate-lead titanate substrates.
قيم البحث
اقرأ أيضاً
Films of (111)-textured Cu, Ni, and Cu$_x$Ni$_y$ were evaluated as substrates for chemical vapor deposition of graphene. A metal thickness of 400 nm to 700 nm was sputtered onto a substrate of $alpha-$Al$_2$O$_3$(0001) at temperatures of 250 C to 650
C. The films were then annealed at 1000 C in a tube furnace. X-ray and electron backscatter diffraction measurements showed all films have (111) texture but have grains with in-plane orientations differing by $60^{circ}$. The in-plane epitaxial relationship for all films was $[110]_{metal}$||$[10bar{1}0]_{{Al}_{2}{O}_{3}}$. Reactive sputtering of Al in O$_2$ before metal deposition resulted in a single in-plane orientation over 97 % of the Ni film but had no significant effect on the Cu grain structure. Transmission electron microscopy showed a clean Ni/Al$_2$O$_3$ interface, confirmed the epitaxial relationship, and showed that formation of the $60^{circ}$ twin grains was associated with features on the Al$_2$O$_3$ surface. Increasing total pressure and Cu vapor pressure during annealing decreased the roughness of Cu and and Cu$_x$Ni$_y$ films. Graphene grown on the Ni(111) films was more uniform than that grown on polycrystalline Ni/SiO$_2$ films, but still showed thickness variations on a much smaller length scale than the distance between grains.
Uniform single layer graphene was grown on single-crystal Ir films a few nanometers thick which were prepared by pulsed laser deposition on sapphire wafers. These graphene layers have a single crystallographic orientation and a very low density of de
fects, as shown by diffraction, scanning tunnelling microscopy, and Raman spectroscopy. Their structural quality is as high as that of graphene produced on Ir bulk single crystals, i.e. much higher than on metal thin films used so far.
We experimentally investigated the magnetic properties of NiCo$_2$O$_4$ epitaxial films known to be conductive oxides with perpendicular magnetic anisotropy (PMA) at room temperature. Both magneto-torque and magnetization measurements at various temp
eratures provide clear experimental evidence of the spin reorientation transition at which the MA changes from PMA to easy-cone magnetic anisotropy (ECMA) at a certain temperature ($T_{rm{SR}}$). ECMA was commonly observed in films grown by pulsed laser deposition and reactive radio frequency magnetron sputtering, although $T_{mathrm{SR}}$ is dependent on the growth method as well as the conditions. The cone angles measured from the $c$-axis increased successively at $T_{mathrm{SR}}$ and approached a maximum of 45-50 degrees at the lowest measurement temperature of 5 K. Calculation with the cluster model suggests that the Ni$^{3+}$ ions occupying the $T_d$ site could be the origin of the ECMA. Both the magnetic properties and the results of the calculation based on the cluster model indicate that the ECMA is attributable to the cation anti-site distribution of Ni$^{3+}$, which is possibly formed during the growth process of the thin films.
A comparative study of the structural, microstructural and magnetic properties of CrO$_2$ thin films grown onto (110) and (100) TiO$_2$ rutile single crystal substrates by chemical vapor deposition (CVD), using CrO$_3$ as chromium precursor and eithe
r oxygen or argon as carrier gas is presented. Our results show that growth under argon carrier gas leads to high quality CrO$_2$ epilayers with structural and magnetic properties similar to those obtained using the more standard oxygen carrier gas. Furthermore, we interpret the larger magnetic coercivity observed for the (110) oriented films in terms of their microstructure, in particular of the highest strain and edge roughness of the building structures of the CrO$_2$ epilayers, which are settled by the substrate crystallographic orientation.
AB$_2$O$_4$ normal spinels with a magnetic B site can host a variety of magnetic and orbital frustrations leading to spin-liquid phases and field-induced phase transitions. Here we report the first epitaxial growth of (111)-oriented MgCr$_2$O$_4$ thi
n films. By characterizing the structural and electronic properties of films grown along (001) and (111) directions, the influence of growth orientation has been studied. Despite distinctly different growth modes observed during deposition, the comprehensive characterization reveals no measurable disorder in the cation distribution nor multivalency issue for Cr ions in either orientation. Contrary to a naive expectation, the (111) stabilized films exhibit a smoother surface and a higher degree of crystallinity than (001)-oriented films. The preference in growth orientation is explained within the framework of heteroepitaxial stabilization in connection to a significantly lower (111) surface energy. These findings open broad opportunities in the fabrication of 2D kagome-triangular heterostructures with emergent magnetic behavior inaccessible in bulk crystals.
سجل دخول لتتمكن من نشر تعليقات
التعليقات
جاري جلب التعليقات
سجل دخول لتتمكن من متابعة معايير البحث التي قمت باختيارها
