اشترك بالحزمة الذهبية واحصل على وصول غير محدود شمرا أكاديميا
تسجيل مستخدم جديدCorrelated Link Shadow Fading in Multi-hop Wireless Networks
112
0
0.0
(
0
)
اسأل ChatGPT حول البحث
ﻻ يوجد ملخص باللغة العربية
Accurate representation of the physical layer is required for analysis and simulation of multi-hop networking in sensor, ad hoc, and mesh networks. This paper investigates, models, and analyzes the correlations that exist in shadow fading between links in multi-hop networks. Radio links that are geographically proximate often experience similar environmental shadowing effects and thus have correlated fading. We describe a measurement procedure and campaign to measure a large number of multi-hop networks in an ensemble of environments. The measurements show statistically significant correlations among shadowing experienced on different links in the network, with correlation coefficients up to 0.33. We propose a statistical model for the shadowing correlation between link pairs which shows strong agreement with the measurements, and we compare the new model with an existing shadowing correlation model of Gudmundson (1991). Finally, we analyze multi-hop paths in three and four node networks using both correlated and independent shadowing models and show that independent shadowing models can underestimate the probability of route failure by a factor of two or greater.
قيم البحث
اقرأ أيضاً
In this paper, we propose a new Quality Link Metric (QLM), ``Inverse Expected Transmission Count (InvETX) in Optimized Link State Routing (OLSR) protocol. Then we compare performance of three existing QLMs which are based on loss probability measurem
ents; Expected Transmission Count (ETX), Minimum Delay (MD), Minimum Loss (ML) in Static Wireless Multi-hop Networks (SWMhNs). A novel contribution of this paper is enhancement in conventional OLSR to achieve high efficiency in terms of optimized routing load and routing latency. For this purpose, first we present a mathematical framework, and then to validate this frame work, we select three performance parameters to simulate default and enhanc
Stochastic stability for centralized time-varying Kalman filtering over a wireles ssensor network with correlated fading channels is studied. On their route to the gateway, sensor packets, possibly aggregated with measurements from several nodes, may
be dropped because of fading links. To study this situation, we introduce a network state process, which describes a finite set of configurations of the radio environment. The network state characterizes the channel gain distributions of the links, which are allowed to be correlated between each other. Temporal correlations of channel gains are modeled by allowing the network state process to form a (semi-)Markov chain. We establish sufficient conditions that ensure the Kalman filter to be exponentially bounded. In the one-sensor case, this new stability condition is shown to include previous results obtained in the literature as special cases. The results also hold when using power and bit-rate control policies, where the transmission power and bit-rate of each node are nonlinear mapping of the network state and channel gains.
Unmanned aerial vehicles (UAVs) have emerged as a promising solution to provide wireless data access for ground users in various applications (e.g., in emergence situations). This paper considers a UAV-enabled wireless network, in which multiple UAVs
are deployed as aerial base stations (BSs) to serve users distributed on the ground. Different from prior works that ignore UAVs backhaul connections, we practically consider that these UAVs are connected to the core network through a ground gateway node via rate-limited multi-hop wireless backhauls. We also consider that the air-to-ground (A2G) access links from UAVs to users and the air-to-air (A2A) backhaul links among UAVs are operated over orthogonal frequency bands. Under this setup, we aim to maximize the common (or minimum) throughput among all the ground users in the downlink of this network subject to the flow conservation constraints at the UAVs, by optimizing the UAVs deployment locations, jointly with the bandwidth and power allocation of both the access and backhaul links. However, the common throughput maximization is a non-convex optimization problem that is difficult to be solved optimally. To tackle this issue, we use the techniques of alternating optimization and successive convex programming (SCP) to obtain a locally optimal solution. Numerical results show that the proposed design significantly improves the common throughput among all ground users as compared to other benchmark schemes.
In this paper, we consider a networked control system (NCS) in which an dynamic plant system is connected to a controller via a temporally correlated wireless fading channel. We focus on communication power design at the sensor to minimize a weighted
average state estimation error at the remote controller subject to an average transmit power constraint of the sensor. The power control optimization problem is formulated as an infinite horizon average cost Markov decision process (MDP). We propose a novel continuous-time perturbation approach and derive an asymptotically optimal closed-form value function for the MDP. Under this approximation, we propose a low complexity dynamic power control solution which has an event- driven control structure. We also establish technical conditions for asymptotic optimality, and sufficient conditions for NCS stability under the proposed scheme.
Recent advances in antenna technology have made the design of multi-beam antennas (MBA) feasible. Compared to an omni-directional or a single beam directional antenna, an MBA equipped node can achieve a throughput of up to m times, by simultaneously
communicating on its m non-interfering beams. As a result, a few multi-beam directional medium access control (MAC) schemes have been proposed in the literature recently, which are implemented mostly on the in-house simulation setups in Matlab or C/C++. These implementations make many assumptions to simplify their design, without a thorough implementation of other network layers. However, the implementation of a multi-beam MAC scheme on the well-known discrete event network simulator platforms (such as the Riverbed Modeler, NS3, QualNet) is challenging as it requires extensive changes and additions to various source code modules. In fact, the network protocols in these simulator packages have been mainly designed for omni-directional communication, and very few implementations of directional MAC and other network protocols exist in the literature. This paper presents a framework to implement a multi-beam directional MAC scheme in multi-hop wireless networks, by using the Wireless Suite of Riverbed Modeler. The detailed implementation procedures are described for multi-beam antenna module, multi-beam node model, concurrent packet transmission and reception, scheduling, collision avoidance, retransmission, and local node synchronization. These MAC modules and methodology can be very helpful to the researchers and developers for implementing the single-beam as well as multi-beam directional MAC and routing protocols in Riverbed Modeler.
سجل دخول لتتمكن من نشر تعليقات
التعليقات
جاري جلب التعليقات
سجل دخول لتتمكن من متابعة معايير البحث التي قمت باختيارها
