ترغب بنشر مسار تعليمي؟ اضغط هنا

Constant rate shearing on two dimensional cohesive disks

89   0   0.0 ( 0 )
 نشر من قبل Nathalie Olivi-Tran
 تاريخ النشر 2005
  مجال البحث فيزياء
والبحث باللغة English




اسأل ChatGPT حول البحث

We performed two-dimensional Molecular Dynamics simulations of cohesive disks under shear. The cohesion between the disks is added by the action of springs between very next neighbouring disks, modelling capillary forces. The geometry of the cell allows disk-disk shearing and not disk-cell wall shearing as it is commonly found in literature. Does a stick-slip phenomenon happen though the upper cover moves at a constant velocity, i.e. with an infinite shearing force? We measured the forces acted by the disks on the upper cover for different shearing rates, as well as the disk velocities as a function of the distance to the bottom of the cell. It appears that the forces measured versus time present a periodic behavior,very close to a stick slip phenomenon, for shearing rates larger than a given threshold. The disks collective displacements in the shearing cell (back and ahead) is the counterpart of the constant velocity of the upper cover leading to a periodic behavior of the shear stress.



قيم البحث

اقرأ أيضاً

The rheology of cohesive granular materials, under a constant pressure condition, is studied using molecular dynamics simulations. Depending on the shear rate, pressure, and interparticle cohesiveness, the system exhibits four distinctive phases: uni form shear, oscillation, shear-banding, and clustering. The friction coefficient is found to increase with the inertial number, irrespective of the cohesiveness. The friction coefficient becomes larger for strong cohesion. This trend is explained by the anisotropies of the coordination number and angular distribution of the interparticle forces. In particular, we demonstrate that the second-nearest neighbors play a role in the rheology of cohesive systems.
An experimental system has been found recently, a coagulated CaCO3 suspension system, which shows very variable yield behaviour depending upon how it is tested and, specifically, at what rate it is sheared. At Peclet numbers Pe > 1 it behaves as a si mple Herschel Bulkley liquid, whereas at Pe < 1 highly non-monotonic flow curves are seen. In controlled stress testing it shows hysteresis and shear banding and in the usual type of stress scan, used to measure flow curves in controlled stress mode routinely, it can show very erratic and irreproducible behaviour. All of these features will be attributed here to a dependence of the solid phase, or, yield stress, on the prevailing rate of shear at the yield point. Stress growth curves obtained from step strain-rate testing showed that this rate-dependence was a consequence of Peclet number dependent strain softening. At very low Pe, yield was cooperative and the yield strain was order-one, whereas as Pe approached unity, the yield strain reduced to that needed to break interparticle bonds, causing the yield stress to be greatly reduced. It is suspected that rate-dependent yield could well be the rule rather than the exception for cohesive suspensions more generally. If so, then the Herschel-Bulkley equation can usefully be generalized to read (in simple shear). The proposition that rate-dependent yield might be general for cohesive suspensions is amenable to critical experimental testing by a range of means and along lines suggested.
The yielding of concentrated cohesive suspensions can be deformation-rate dependent. One consquence of this is that a single suspension can present in one several different ways, depending upon how it is tested, or more generally, how it is caused to flow. We have seen variously Herschel-Bulkley flow, highly non-monotonic flow curves and highly erratic or chaotic yield, all in one suspension. In controlled-rate testing one sees a systematic effect of deformation rate. In controlled stress testing, matters are more subtle. Whereas step-stress creep testing will elicit reproducible behaviour, any attempt to determine a flow curve by, e.g. stepping up or sweeping stress at an inappropriate rate can lead to highly irreproducible behaviour.
We analyze the local structure of two dimensional packings of frictional disks numerically. We focus on the fractions x_i of particles that are in contact with i neighbors, and systematically vary the confining pressure p and friction coefficient mu. We find that for all mu, the fractions x_i exhibit powerlaw scaling with p, which allows us to obtain an accurate estimate for x_i at zero pressure. We uncover how these zero pressure fractions x_i vary with mu, and introduce a simple model that captures most of this variation. We also probe the correlations between the contact numbers of neighboring particles.
70 - O. Pozo , N. Olivi-Tran 2006
A Molecular Dynamics approach has been used to compute the shear force resulting from the shearing of disks. Two-dimensional monodisperse disks have been put in an horizontal and rectangular shearing cell with periodic boundary conditions on right an d left hand sides. The shear is applied by pulling the cover of the cell either at a constant rate or by pulling a spring, linked to the cover, with a constant force. Depending on the rate of shearing and on the elasticity of the whole set up, we showed that the measured shear force signal is either irregular in time, regular in time but not in shape, or regular in shape.
التعليقات
جاري جلب التعليقات جاري جلب التعليقات
سجل دخول لتتمكن من متابعة معايير البحث التي قمت باختيارها
mircosoft-partner

هل ترغب بارسال اشعارات عن اخر التحديثات في شمرا-اكاديميا