اشترك بالحزمة الذهبية واحصل على وصول غير محدود شمرا أكاديميا
تسجيل مستخدم جديدHigh Cadence Optical Transient Searches using Drift Scan Imaging III: Development of an Inexpensive Drive Control System and Characterisation and Correction of Drive System Periodic Errors
84
0
0.0
(
0
)
تأليف
S. J. Tingay
اسأل ChatGPT حول البحث
ﻻ يوجد ملخص باللغة العربية
In order to further develop and implement novel drift scan imaging experiments to undertake wide field, high time resolution surveys for millisecond optical transients, an appropriate telescope drive system is required. This paper describes the development of a simple and inexpensive hardware and software system to monitor, characterise, and correct the primary category of telescope drive errors, periodic errors due to imperfections in the drive and gear chain. A model for the periodic errors is generated from direct measurements of the telescope drive shaft rotation, verified by comparison to astronomical measurements of the periodic errors. The predictive model is generated and applied in real-time in the form of corrections to the drive rate. A demonstration of the system shows that that inherent periodic errors of peak-to-peak amplitude ~100 are reduced to below the seeing limit of ~3. This demonstration allowed an estimate of the uncertainties on the transient sensitivity timescales of the prototype survey of Tingay & Joubert (2021), with the nominal timescale sensitivity of 21 ms revised to be in the range of 20 - 22 ms, which does not significantly affect the results of the experiment. The correction system will be adopted into the final version of high cadence imaging experiment, which is currently under construction. The correction system is inexpensive (<$A100) and composed of readily available hardware, and is readily adaptable to other applications. Design details and codes are therefore made publicly available.
قيم البحث
اقرأ أيضاً
An imaging technique with sensitivity to short duration optical transients is described. The technique is based on the use of wide-field cameras operating in a drift scanning mode, whereby persistent objects produce trails on the sensor and short dur
ation transients occupy localised groups of pixels. A benefit of the technique is that sensitivity to short duration signals is not accompanied by massive data rates, because the exposure time >> transient duration. The technique is demonstrated using a pre-prototype system composed of readily available and inexpensive commercial components, coupled with common coding environments, commercially available software, and free web-based services. The performance of the technique and the pre-prototype system is explored, including aspects of photometric and astrometric calibration, detection sensitivity, characterisation of candidate transients, and the differentiation of astronomical signals from non-astronomical signals (primarily glints from satellites in Earth orbit and cosmic ray hits on sensor pixels). Test observations were made using the pre-prototype system, achieving sensitivity to transients with 21 ms duration, resulting in the detection of five candidate transients. An investigation of these candidates concludes they are most likely due to cosmic ray hits on the sensor and/or satellites. The sensitivity obtained with the pre-prototype system is such that, under some models for the optical emission from FRBs, the detection of a typical FRB, such as FRB181228, to a distance of approximately 100 Mpc is plausible. Several options for improving the system/technique in the future are described.
We have realised a simple prototype system to perform searches for short timescale optical transients, utilising the novel drift scan imaging technique described by Tingay (2020). We used two coordinated and aligned cameras, with an overlap field-of-
view of approximately 3.7 sq. deg., to capture over 34000 X 5 second images during approximately 24 hours of observing. The system is sensitive to optical transients, due to an effective exposure time per pixel of 21 ms, brighter than a V magnitude of 6.6. In our 89.7 sq. deg. hr of observations we find no candidate astronomical transients, giving an upper limit to the rate of these transients of 0.8 per square degree per day, competitive with other experiments of this type. The system is triggered by reflections from satellites and various instrumental effects, which are easily identifiable due to the two camera system. The next step in the development of this promising technique is to move to a system with larger apertures and wider fields of view.
The H.E.S.S. observatory was recently extended with a fifth telescope located at the center of the array - H.E.S.S. II. With a reflector roughly six times the area of the smaller telescopes and four times more pixels per sky area, this new telescope
can resolve images of particle showers in the atmosphere in unprecedented detail and explore the gamma-ray sky in the poorly studied regime around a few tens of Giga electron-volt. H.E.S.S. II has been equipped with a high-performance drive system that can deliver the high torque necessary to accelerate and slew the 600 tonnes telescope while keeping a good tracking accuracy. A modular design with a high degree of redundancy has been employed to achieve stability of operation and to ensure that the telescope can be moved to a safe position within a short period of time. Each axis is driven by four 28 kW servo motors which are pair-wise torque-biased and synchronized through a state of the art Programmable Logic Controller (PLC). With this system, a fast repositioning and a minimal settling time has been achieved - crucial when studying transient sources such as gamma-ray bursts which are a prime target for this telescope. This contribution will report on the successful commissioning of the H.E.S.S. II drive system in the first half of 2012 at the H.E.S.S. site in Namibia. The technical implementation and the performance of the drive system will be presented.
It is demonstrated that the development of a nuclear fusion rocket engine based on a D $-$ $^{3}$He (Deterium-Helium 3) technology will allow to travel in the solar system and beyond. The Direct Fusion Drive (DFD) is the D $-$ $^{3}$He-fueled, aneutr
onic, thermonuclear fusion propulsion system that is under development at Princeton University Plasma Physics Laboratory [1]. It is considered and analyzed the Earth-Mars mission using the DFD. It is shown that one-way trips to Mars in slightly more than 100 days become possible and also journeys to the asteroid belt will take about 250 days [2]. It is presented an analysis of realistic new trajectories for a robotic mission to Saturns largest moon, Titan, to demonstrate the great advantages related to the thermonuclear DFD. The trajectories calculations and analysis for Saturns largest moon Titan different profile missions are given based on the characteristics of a 2 MW class DFD engine. This capability results in a total trip duration of 2.6 years for the thrust-coast-thrust profile and less than 2 years for the continuous thrust profile [3]. Using the same 2 MW class DFD engine one can reach some trans-Neptunian object, such as the dwarf planets Makemake, Eris, and Haumea in less than 10 years with a payload mass of at least 1500 kg, so that it would enable all kind of missions, from scientific observation to in-situ operations [4]. We consider for each mission a Thrust-Coast-Thrust profile. For this reason, each mission is divided into 3 phases: i. the trajectory to escape Earth gravity influence; ii. the interplanetary travel, from the exit of Earth sphere of influence to the end of the coasting phase; iii. maneuvers to rendezvous with a target object. We present calculations to reach a vicinity at 125 AU.
The MAGIC telescope is an imaging atmospheric Cherenkov telescope, designed to observe very high energy gamma-rays while achieving a low energy threshold. One of the key science goals is fast follow-up of the enigmatic and short lived gamma-ray burst
s. The drive system for the telescope has to meet two basic demands: (1) During normal observations, the 72-ton telescope has to be positioned accurately, and has to track a given sky position with high precision at a typical rotational speed in the order of one revolution per day. (2) For successfully observing GRB prompt emission and afterglows, it has to be powerful enough to position to an arbitrary point on the sky within a few ten seconds and commence normal tracking immediately thereafter. To meet these requirements, the implementation and realization of the drive system relies strongly on standard industry components to ensure robustness and reliability. In this paper, we describe the mechanical setup, the drive control and the calibration of the pointing, as well as present measurements of the accuracy of the system. We show that the drive system is mechanically able to operate the motors with an accuracy even better than the feedback values from the axes. In the context of future projects, envisaging telescope arrays comprising about 100 individual instruments, the robustness and scalability of the concept is emphasized.
سجل دخول لتتمكن من نشر تعليقات
التعليقات
جاري جلب التعليقات
سجل دخول لتتمكن من متابعة معايير البحث التي قمت باختيارها
