اشترك بالحزمة الذهبية واحصل على وصول غير محدود شمرا أكاديميا
تسجيل مستخدم جديدCommunications and Signals Design for Wireless Power Transmission
238
0
0.0
(
0
)
اسأل ChatGPT حول البحث
ﻻ يوجد ملخص باللغة العربية
Radiative wireless power transfer (WPT) is a promising technology to provide cost-effective and real-time power supplies to wireless devices. Although radiative WPT shares many similar characteristics with the extensively studied wireless information transfer or communication, they also differ significantly in terms of design objectives, transmitter/receiver architectures and hardware constraints, etc. In this article, we first give an overview on the various WPT technologies, the historical development of the radiative WPT technology and the main challenges in designing contemporary radiative WPT systems. Then, we focus on discussing the new communication and signal processing techniques that can be applied to tackle these challenges. Topics discussed include energy harvester modeling, energy beamforming for WPT, channel acquisition, power region characterization in multi-user WPT, waveform design with linear and non-linear energy receiver model, safety and health issues of WPT, massive MIMO (multiple-input multiple-output) and millimeter wave (mmWave) enabled WPT, wireless charging control, and wireless power and communication systems co-design. We also point out directions that are promising for future research.
قيم البحث
اقرأ أيضاً
This paper jointly optimizes the flying location and wireless communication transmit power for an unmanned aerial vehicle (UAV) conducting covert operations. This is motivated by application scenarios such as military ground surveillance from airborn
e platforms, where it is vital for a UAVs signal transmission to be undetectable by those within the surveillance region. Specifically, we maximize the communication quality to a legitimate ground receiver outside the surveillance region, subject to: a covertness constraint, a maximum transmit power constraint, and a physical location constraint determined by the required surveillance quality. We provide an explicit solution to the optimization problem for one of the most practical constraint combinations. For other constraint combinations, we determine feasible regions for flight, that can then be searched to establish the UAVs optimal location. In many cases, the 2-dimensional optimal location is achieved by a 1-dimensional search. We discuss two heuristic approaches to UAV placement, and show that in some cases they are able to achieve close to optimal, but that in other cases significant gains can be achieved by employing our developed solutions.
The feasibility of physical-layer-based security approaches for wireless communications in the presence of one or more eavesdroppers is hampered by channel conditions. In this paper, cooperation is investigated as an approach to overcome this problem
and improve the performance of secure communications. In particular, a decode-and-forward (DF) based cooperative protocol is considered, and the objective is to design the system for secrecy capacity maximization or transmit power minimization. System design for the DF-based cooperative protocol is first studied by assuming the availability of global channel state information (CSI). For the case of one eavesdropper, an iterative scheme is proposed to obtain the optimal solution for the problem of transmit power minimization. For the case of multiple eavesdroppers, the problem of secrecy capacity maximization or transmit power minimization is in general intractable. Suboptimal system design is proposed by adding an additional constraint, i.e., the complete nulling of signals at all eavesdroppers, which yields simple closed-form solutions for the aforementioned two problems. Then, the impact of imperfect CSI of eavesdroppers on system design is studied, in which the ergodic secrecy capacity is of interest.
A range of efficient wireless processes and enabling techniques are put under a magnifier glass in the quest for exploring different manifestations of correlated processes, where sub-Nyquist sampling may be invoked as an explicit benefit of having a
sparse transform-domain representation. For example, wide-band next-generation systems require a high Nyquist-sampling rate, but the channel impulse response (CIR) will be very sparse at the high Nyquist frequency, given the low number of reflected propagation paths. This motivates the employment of compressive sensing based processing techniques for frugally exploiting both the limited radio resources and the network infrastructure as efficiently as possible. A diverse range of sophisticated compressed sampling techniques is surveyed and we conclude with a variety of promising research ideas related to large-scale antenna arrays, non-orthogonal multiple access (NOMA), and ultra-dense network (UDN) solutions, just to name a few.
With the high development of wireless communication techniques, it is widely used in various fields for convenient and efficient data transmission. Different from commonly used assumption of the time-invariant wireless channel, we focus on the resear
ch on the time-varying wireless downlink channel to get close to the practical situation. Our objective is to gain the maximum value of sum rate in the time-varying channel under the some constraints about cut-off signal-to-interference and noise ratio (SINR), transmitted power and beamforming. In order to adapt the rapid changing channel, we abandon the frequently used algorithm convex optimization and deep reinforcement learning algorithms are used in this paper. From the view of the ordinary measures such as power control, interference incoordination and beamforming, continuous changes of measures should be put into consideration while sparse reward problem due to the abortion of episodes as an important bottleneck should not be ignored. Therefore, with the analysis of relevant algorithms, we proposed two algorithms, Deep Deterministic Policy Gradient algorithm (DDPG) and hierarchical DDPG, in our work. As for these two algorithms, in order to solve the discrete output, DDPG is established by combining the Actor-Critic algorithm with Deep Q-learning (DQN), so that it can output the continuous actions without sacrificing the existed advantages brought by DQN and also can improve the performance. Also, to address the challenge of sparse reward, we take advantage of meta policy from the idea of hierarchical theory to divide one agent in DDPG into one meta-controller and one controller as hierarchical DDPG. Our simulation results demonstrate that the proposed DDPG and hierarchical DDPG performs well from the views of coverage, convergence and sum rate performance.
We investigate the optimality and power allocation algorithm of beam domain transmission for single-cell massive multiple-input multiple-output (MIMO) systems with a multi-antenna passive eavesdropper. Focusing on the secure massive MIMO downlink tra
nsmission with only statistical channel state information of legitimate users and the eavesdropper at base station, we introduce a lower bound on the achievable ergodic secrecy sum-rate, from which we derive the condition for eigenvectors of the optimal input covariance matrices. The result shows that beam domain transmission can achieve optimal performance in terms of secrecy sum-rate lower bound maximization. For the case of single-antenna legitimate users, we prove that it is optimal to allocate no power to the beams where the beam gains of the eavesdropper are stronger than those of legitimate users in order to maximize the secrecy sum-rate lower bound. Then, motivated by the concave-convex procedure and the large dimension random matrix theory, we develop an efficient iterative and convergent algorithm to optimize power allocation in the beam domain. Numerical simulations demonstrate the tightness of the secrecy sum-rate lower bound and the near-optimal performance of the proposed iterative algorithm.
سجل دخول لتتمكن من نشر تعليقات
التعليقات
جاري جلب التعليقات
سجل دخول لتتمكن من متابعة معايير البحث التي قمت باختيارها
