اشترك بالحزمة الذهبية واحصل على وصول غير محدود شمرا أكاديميا
تسجيل مستخدم جديدOn-chip detection of radiation guided by dielectric-loaded plasmonic waveguides
264
0
0.0
(
0
)
اسأل ChatGPT حول البحث
ﻻ يوجد ملخص باللغة العربية
We report a novel approach for on-chip electrical detection of the radiation guided by dielectric-loaded surface plasmon polariton waveguides (DLSPPW) and DLSPPW-based components. The detection is realized by fabricating DLSPPW components on the surface of a gold (Au) pad supported by a silicon (Si) substrate supplied with aluminum pads facilitating electrical connections, with the gold pad being perforated in a specific locations below the DLSPPWs in order to allow a portion of the DLSPPW-guided radiation to leak into the Si-substrate, where it is absorbed and electrically detected. We present two-dimensional photocurrent maps obtained when the laser beam is scanning across the gold pad containing the fabricated DLSPPW components that are excited via grating couplers located at the DLSPPW tapered terminations. By comparing photocurrent signals obtained when scanning over a DLSPPW straight waveguide with those related to a DLSPPW racetrack resonator, we first determine the background signal level and then the corrected DLSPPW resonator spectral response, which is found consistent with that obtained from full wave numerical simulations. The approach developed can be extended to other plasmonic waveguide configurations and advantageously used for rapid characterization of complicated plasmonic circuits.
قيم البحث
اقرأ أيضاً
We report a novel design of a compact wavelength add-drop multiplexer utilizing dielectric-loaded surface plasmon-polariton waveguides (DLSPPWs). The DLSPPW-based configuration exploits routing properties of directional couplers and filtering abiliti
es of Bragg gratings. We present practical realization of a 20-$mu$m-long device operating at telecom wavelengths that can reroute optical signals separated by approximately 70 nm in the wavelength band. We characterize the performance of the fabricated structures using scanning near-field optical microscopy as well as leakage-radiation microscopy and support our findings with numerical simulations.
In this article, a 2D plasmonic waveguide loaded with all dielectric anisotropic metamaterial, consisting of alternative layers of Si-SiO2, has been theoretically proposed and numerically analyzed. Main characteristics of waveguide i.e. propagation c
onstant, propagation length and normalized mode area have been calculated for different values of ridge width and height at telecommunication wavelength. The respective 1D structure of the waveguide has been analytically solved for the anisotropic ridge as a single uniaxial medium with dielectric tensor defined by Effective Medium Theory (EMT). The 2D structure has been analyzed numerically through FEM simulation using Mode analysis module in Comsol Multiphysics. Both the EMT and real multilayer structure have been considered in numerical simulations. Such structure with all dielectric metamaterial provides an extra degree of freedom namely fill factor, fraction of Si layer in a Si-SiO2 unit cell, to tune the propagation characteristics compared to the conventional DLSSP waveguide. A wide range of variations in all the characteristics have been observed for different fill factor values. Besides, the effect of the first interface layer has also been considered. Though all dielectric metamaterial has already been utilized in photonic waveguide as cladding, the implementation in plasmonic waveguide has not been investigated yet to our best knowledge. The proposed device might be a potential in deep sub-wavelength optics, PIC and optoelectronics.
Recent years have seen an explosive research and development of nanoplasmonics in the visible and near-infrared (near-ir) frequency regions. One of the most fundamental effects in nanoplasmonics is nano-concentration of optical energy. Plasmonic nano
focusing has been predicted and experimentally achieved. It will be very beneficial for the fundamental science, engineering, environmental, and defense applications to be able to nano-concentrate terahertz radiation (frequency 1 - 10 THz or vacuum wavelength 300 - 30 microns). This will allow for the nanoscale spatial resolution for THz imaging and introduce the THz spectroscopy on the nanoscale, taking full advantage of the rich THz spectra and submicron to nanoscale structures of many engineering, physical, and biological objects of wide interest: electronic components (integrated circuits, etc.), bacteria, their spores, viruses, macromolecules, carbon clusters and nanotubes, etc. In this Letter we establish the principal limits for the nanoconcentration of the THz radiation in metal/dielectric waveguides and determine their optimum shapes required for this nanoconcentration We predict that the adiabatic compression of THz radiation from the initial spot size of light wavelength to the final size of R = 100 - 250 nm can be achieved with the THz radiation intensity increased by a factor of 10 to 250. This THz energy nanoconcentration will not only improve the spatial resolution and increase the signal/noise ratio for the THz imaging and spectroscopy, but in combination with the recently developed sources of powerful THz pulses will allow the observation of nonlinear THz effects and a carrying out a variety of nonlinear spectroscopies (such as two-dimensional spectroscopy), which are highly informative.
As an analogue of electromagnetically induced transparency (EIT), plasmon-induced transparency (PIT) has been realized both in plasmonic metamaterial and waveguide structures. Via near-field coupling within unit cells, PIT with broadband could be pro
duced by plasmonic metamaterials, which, however, has not been realized in on-chip plasmonic waveguide structures. Here, we introduce broadband PIT based on a plasmonic metal-insulator-metal (MIM) waveguide system. Utilizing the direct coupling structure, PIT emerges based on an easy-fabricated structure without gap. By tuning coupling distance, the transparent window can be continuously tuned from narrow- to broadband. Such device is promising for on-chip applications on sensing, filtering and slow light over a broad frequency range.
Metallic nanoparticle-on-a-mirror (NPoM) cavities enable extreme field confinement in sub-nm gaps, leading to unrivaled performance for nonlinear processes such as surface-enhanced Raman scattering (SERS). So far, prevailing experimental approaches b
ased on NPoMs have been performed by means of free-space light excitation and collection under oblique incidence, since the fundamental radiatively-coupled NPoM mode does not scatter in the normal direction. Retaining this working principle, here we numerically show that plasmonic cavity modes in NPoM configurations can be efficiently excited in an integrated SERS approach through TM guided modes of silicon nitride (SiN) waveguides. Intensity enhancements beyond 10$^{5}$ can be achieved for gap spacings around 1 nm. So as to reduce unwanted SiN Raman background, the output Stokes signals are transferred to transversely placed waveguides, reaching coupling efficiencies of up to 10%. Geometrical parameters such as the gap thickness as well as the radius and position of the nanoparticle provide full control over the main spectral features, thereby enabling us to engineer and drive the optical response of NPoMs for high-performance SERS in Si-based photonic integrated platforms.
سجل دخول لتتمكن من نشر تعليقات
التعليقات
جاري جلب التعليقات
سجل دخول لتتمكن من متابعة معايير البحث التي قمت باختيارها
