اشترك بالحزمة الذهبية واحصل على وصول غير محدود شمرا أكاديميا
تسجيل مستخدم جديدRaindrop impact on sand: a dynamic explanation of crater morphologies
62
0
0.0
(
0
)
اسأل ChatGPT حول البحث
ﻻ يوجد ملخص باللغة العربية
As a droplet impacts on a granular substrate, both the intruder and the target deform, during which the liquid may penetrate into the substrate. {These three aspects together distinguish} it from other impact phenomena in the literature. We perform high-speed, double-laser profilometry measurements and disentangle the dynamics into three aspects: the deformation of the substrate during the impact, the maximum spreading diameter of the droplet, and the penetration of the liquid into the substrate. By systematically varying the impact speed and the packing fraction of the substrate, (i) the substrate deformation indicates a critical packing fraction $phi^*approx 0.585$; (ii) the maximum droplet spreading diameter is found to scale with a Weber number corrected by the substrate deformation; and (iii) a model about the liquid penetration is established and is used to explain the observed crater morphology transition.
قيم البحث
اقرأ أيضاً
How does the impact of a deformable droplet on a granular bed differ from that caused by a solid impactor of similar size and density? Here, we experimentally study this question and focus on the effect of intruder deformability on the crater shape.
For comparable impact energies, we show that the crater diameter is larger for droplets than for solid intruders but that the impact of the latter results in deeper craters. Interestingly, for initially dense beds of packing fractions larger than 0.58, we find that the resultant excavated crater volume is independent of the intruder deformability, suggesting an impactor-independent dissipation mechanism within the sand for these dense beds.
We develop a theoretical framework for understanding dynamic morphologies and stability of droplet interface bilayers (DIBs), accounting for lipid kinetics in the monolayers and bilayer, and droplet evaporation due to imbalance between osmotic and La
place pressures. Our theory quantitatively describes distinct pathways observed in experiments when DIBs become unstable. We find that when the timescale for lipid desorption is slow compared to droplet evaporation, the lipid bilayer will grow and the droplets approach a hemispherical shape. In contrast, when lipid desorption is fast, the bilayer area will shrink and the droplets eventually detach. Our model also suggests there is a critical size below which DIBs cannot be stable, which may explain experimental difficulties in miniaturising the DIB platform.
We show here that the standard physical model used by Vriend et al. to analyse seismograph data, namely a non-dispersive bulk propagation, does not apply to the surface layer of sand dunes. According to several experimental, theoretical and field res
ults, the only possible propagation of sound waves in a dry sand bed under gravity is through an infinite, yet discrete, number of dispersive surface modes. Besides, we present a series of evidences, most of which have already been published in the literature, that the frequency of booming avalanches is not controlled by any resonance as argued in this article. In particular, plotting the data provided by Vriend et al. as a table, it turns out that they do not present any correlation between the booming frequency and their estimate of the resonant frequency.
An experimental study of a granular surface submitted to a circular fluid motion is presented. The appearance of an instability along the sand-water interface is observed beyond a critical radius $r_c$. This creates ripples with a spiral shape on the
granular surface. A phase diagram of such patterns is constructed and discussed as a function of the rotation speed $omega$ of the flow and as a function of the height of water $h$ above the surface. The study of $r_c$ as a function of $h$, $omega$ and $r$ parameters is reported. Thereafter, $r_c$ is shown to depend on the rotation speed according to a power law. The ripple wavelength is found to decrease when the rotation speed increases and is proportional to the radial distance $r$. The azimuthal angle az of the spiral arms is studied. It is found that az scales with $homega r$. This lead to the conclusion that az depends on the fluid momentum. Comparison with experiments performed with fluids allows us to state that the spiral patterns are not the signature of an instability of the boundary layer.
Dense particulate suspensions can not only increase their viscosity and shear thicken under external forcing, but also jam into a solid-like state that is fully reversible when the force is removed. An impact on the surface of a dense suspension can
trigger this jamming process by generating a shear front that propagates into the bulk of the system. Tracking and visualizing such a front is difficult because suspensions are optically opaque and the front can propagate as fast as several meters per second. Recently, high-speed ultrasound imaging has been used to overcome this problem and extract two-dimensional sections of the flow field associated with jamming front propagation. Here we extend this method to reconstruct the three-dimensional flow field. This enables us to investigate the evolution of jamming fronts for which axisymmetry cannot be assumed, such as impact at angles tilted away from the normal to the free surface of the suspension. We find that sufficiently far from solid boundaries the resulting flow field is approximately identical to that generated by normal impact, but rotated and aligned with the angle of impact. However, once the front approaches the solid boundary at the bottom of the container, it generates a squeeze flow that deforms the front profile and causes jamming to proceed in a non-axisymmetric manner.
سجل دخول لتتمكن من نشر تعليقات
التعليقات
جاري جلب التعليقات
سجل دخول لتتمكن من متابعة معايير البحث التي قمت باختيارها
