ترغب بنشر مسار تعليمي؟ اضغط هنا

Band-edge Bilayer Plasmonic Nanostructure for Surface Enhanced Raman Spectroscopy

141   0   0.0 ( 0 )
 نشر من قبل S. Hamed Shams Mousavi
 تاريخ النشر 2014
  مجال البحث فيزياء
والبحث باللغة English




اسأل ChatGPT حول البحث

Spectroscopic analysis of large biomolecules is critical in a number of applications, including medical diagnostics and label-free biosensing. Recently, it has been shown that Raman spectroscopy of proteins can be used to diagnose some diseases, including a few types of cancer. These experiments have however been performed using traditional Raman spectroscopy and the development of the Surface enhanced Raman spectroscopy (SERS) assays suitable for large biomolecules could lead to a substantial decrease in the amount of specimen necessary for these experiments. We present a new method to achieve high local field enhancement in surface enhanced Raman spectroscopy through the simultaneous adjustment of the lattice plasmons and localized surface plasmon polaritons, in a periodic bilayer nanoantenna array resulting in a high enhancement factor over the sensing area, with relatively high uniformity. The proposed plasmonic nanostructure is comprised of two interacting nanoantenna layers, providing a sharp band-edge lattice plasmon mode and a wide-band localized surface plasmon for the separate enhancement of the pump and emitted Raman signals. We demonstrate the application of the proposed nanostructure for the spectral analysis of large biomolecules by binding a protein (streptavidin) selectively on the hot-spots between the two stacked layers, using a low concentration solution (100 nM) and we successfully acquire its SERS spectrum.



قيم البحث

اقرأ أيضاً

545 - Xuechao Yu , Jin Tao , Youde Shen 2014
Raman intensity of Rhodamine B (RhB) is enhanced by inserting a thin high k{appa} dielectric layer which reduces the surface plasmon damping at the gold-graphene interface. The results indicate that the Raman intensity increases sharply by plasmonic resonance enhancement while maintaining efficient fluorescence quenching with optimized dielectric layer thickness.
Ag nanorod arrays/dielectrics/mirror-structured multilayer thin-film are well known, highly sensitive surface-enhanced Raman scattering (SERS) substrates that enhance the Raman scattering cross-section by the interference of light. However, extractin g biomarkers directly from human skin using these solid substrates is difficult. To overcome this problem, we propose a multilayer thin-film flake dispersion gel by centrifugal mixing of the multilayer thin-film and hydroxyethyl cellulose (HEC) gel. The multilayer thin-film was prepared by serial bideposition using the dynamic oblique angle deposition technique. The mixing process was optimized to obtain flakes of ~10 {mu}m so that the optical properties of the multilayer film can be preserved, and there is no risk of adverse effects on humans. The SERS features of the flakes dispersion gel were tested using 4, 4-bipyridine (BPY). The BPY molecules diffused through the highly porous gel within a few seconds, generating significant SERS signals. The multilayer film flakes dispersion gel showed a SERS signal about 20 times better than the gel-dispersed Ag nanorod arrays without a multilayer film structure. These SERS active flakes dispersion gel can be used directly on the skin surface to collect body fluids from sweat, for biomarker sensing.
144 - N. I. Cade , T. Ritman-Meer , 2008
We have investigated the effects of tuning the localized surface plasmon resonances (LSPRs) of silver nanoparticles on the fluorescence intensity, lifetime, and Raman signal from nearby fluorophores. The presence of a metallic structure can alter the optical properties of a molecule by increasing the excitation field, and by modifying radiative and non-radiative decay mechanisms. By careful choice of experimental parameters we have been able to decouple these effects. We observe a four-fold increase in fluorescence enhancement and an almost 30-fold increase in decay rate from arrays of Ag nanoparticles, when the LSPR is tuned to the emission wavelength of a locally situated fluorophore. This is consistent with a greatly increased efficiency for energy transfer from fluorescence to surface plasmons. Additionally, surface enhanced Raman scattering (SERS) measurements show a maximum enhancement occurs when both the incident laser light and the Raman signal are near resonance with the plasmon energy. Spatial mapping of the SERS signal from a nanoparticle array reveals highly localized differences in the excitation field resulting from small differences in the LSPR energy.
87 - Li Tao , Zhiyong Li , Kun Chen 2021
To develop highly sensitive, stable and repeatable surface-enhanced Raman scattering (SERS) substrates is crucial for analytical detection, which is a challenge for traditional metallic structures. Herein, by taking advantage of the high surface acti vity of 1T transition metal telluride, we have fabricated high-density gold nanoparticles (AuNPs) that are spontaneously in-situ prepared on the 1T MoTe2 atomic layers via a facile method, forming a plasmonic-2D material hybrid SERS substrate. This AuNP formation is unique to the 1T phase, which is repressed in 2H MoTe2 with less surface activity. The hybrid structure generates coupling effects of electromagnetic and chemical enhancements, as well as excellent molecule adsorption, leading to the ultrasensitive (4*10^-17 M) and reproducible detection. Additionally, the immense fluorescence and photobleaching phenomena are mostly avoided. Flexible SERS tapes have been demonstrated in practical applications. Our approach facilitates the ultrasensitive SERS detection by a facile method, as well as the better mechanistic understanding of SERS beyond plasmonic effects.
We demonstrate an unexpectedly strong surface-plasmonic absorption at the interface of silver and high-index dielectrics based on electron and photon spectroscopy. The measured bandwidth and intensity of absorption deviate significantly from the clas sical theory. Our density-functional calculation well predicts the occurrence of this phenomenon. It reveals that due to the low metal-to-dielectric work function at such interfaces, conduction electrons can display a drastic quantum spillover, causing the interfacial electron-hole pair production to dominate the decay of surface plasmons. This finding can be of fundamental importance in understanding and designing quantum nano-plasmonic devices that utilize noble metals and high-index dielectrics.
التعليقات
جاري جلب التعليقات جاري جلب التعليقات
سجل دخول لتتمكن من متابعة معايير البحث التي قمت باختيارها
mircosoft-partner

هل ترغب بارسال اشعارات عن اخر التحديثات في شمرا-اكاديميا