اشترك بالحزمة الذهبية واحصل على وصول غير محدود شمرا أكاديميا
تسجيل مستخدم جديدLow-frequency and shot noises in CoFeB/MgO/CoFeB magnetic tunneling junctions
208
0
0.0
(
0
)
اسأل ChatGPT حول البحث
ﻻ يوجد ملخص باللغة العربية
The low-frequency and shot noises in spin-valve CoFeB/MgO/CoFeB magnetic tunneling junctions were studied at low temperature. The measured 1/f noise around the magnetic hysteresis loops of the free layer indicates that the main origin of the 1/f noise is the magnetic fluctuation, which is discussed in terms of a fluctuation-dissipation relation. Random telegraph noise (RTN) is observed to be symmetrically enhanced in the hysteresis loop with regard to the two magnetic configurations. We found that this enhancement is caused by the fluctuation between two magnetic states in the free layer. Although the 1/f noise is almost independent of the magnetic configuration, the RTN is enhanced in the antiparallel configuration. These findings indicate the presence of spin-dependent activation of RTN. Shot noise reveals the spin-dependent coherent tunneling process via a crystalline MgO barrier.
قيم البحث
اقرأ أيضاً
We measured the shot noise in the CoFeB/MgO/CoFeB-based magnetic tunneling junctions with a high tunneling magnetoresistance ratio (over 200% at 3 K). Although the Fano factor in the anti-parallel configuration is close to unity, it is observed to be
typically 0.91pm0.01 in the parallel configuration. It indicates the sub-Poissonian process of the electron tunneling in the parallel configuration due to the relevance of the spin-dependent coherent transport in the low bias regime.
Current-driven magnetization switching in low-resistance Co40Fe40B20/MgO/Co40Fe40B20 magnetic tunnel junctions (MTJs) is reported. The critical-current densities Jc required for current-driven switching in samples annealed at 270C and 300C are found
to be as low as 7.8 x 10^5 A/cm^2 and 8.8 x 10^5 A/cm^2 with accompanying tunnel magnetoresistance (TMR) ratios of 49% and 73 %, respectively. Further annealing of the samples at 350C increases TMR ratio to 160 %, while accompanying Jc increases to 2.5 x 10^6 A/cm^2. We attribute the low Jc to the high spin-polarization of tunnel current and small MsV product of the CoFeB single free layer, where Ms is the saturation magnetization and V the volume of the free layer.
Thin electrodes of magnetic tunnel junctions can show superparamagnetism at surprisingly low temperature. We analysed their thermally induced switching for varying temperature, magnetic and electric field. Although the dwell times follow an Arrhenius
law, they are orders of magnitude too small compared to a model of single domain activation. Including entropic effects removes this inconsistency and leads to a magnetic activation volume much smaller than that of the electrode. Comparing data for varying barrier thickness then allows to separate the impact of Zeman energy, spin-transfer-torque and voltage induced anisotropy change on the dwell times. Based on these results, we demonstrate a tuning of the switching rates by combining magnetic and electric fields, which opens a path for their application in noisy neural networks.
Thermal stability factor (delta) of recording layer was studied in perpendicular anisotropy CoFeB/MgO magnetic tunnel junctions (p-MTJs) with various CoFeB recording layer thicknesses and junction sizes. In all series of p-MTJs with different thickne
sses, delta is virtually independent of the junction sizes of 48-81 nm in diameter. The values of delta increase linearly with increasing the recording layer thickness. The slope of the linear fit is explained well by a model based on nucleation type magnetization reversal.
We investigate the spin-dependent Seebeck coefficient and the tunneling magneto thermopower of CoFeB/MgO/CoFeB magnetic tunnel junctions (MTJ) in the presence of thermal gradients across the MTJ. Thermal gradients are generated by an electric heater
on top of the nanopillars. The thermo power voltage across the MTJ is found to scale linearly with the heating power and reveals similar field dependence as the tunnel magnetoresistance. The amplitude of the thermal gradient is derived from calibration measurements in combination with finite element simulations of the heat flux. Based on this, large spin-dependent Seebeck coefficients of the order of (240 pm 110) muV/K are derived. From additional measurements on MTJs after dielectric breakdown, a tunneling magneto thermopower up to 90% can be derived for 1.5 nm MgO based MTJ nanopillars.
سجل دخول لتتمكن من نشر تعليقات
التعليقات
جاري جلب التعليقات
سجل دخول لتتمكن من متابعة معايير البحث التي قمت باختيارها
