اشترك بالحزمة الذهبية واحصل على وصول غير محدود شمرا أكاديميا
تسجيل مستخدم جديدDetermination of spin-dependent Seebeck coefficients of CoFeB/MgO/CoFeB magnetic tunnel junction nanopillars
250
0
0.0
(
0
)
اسأل ChatGPT حول البحث
ﻻ يوجد ملخص باللغة العربية
We investigate the spin-dependent Seebeck coefficient and the tunneling magneto thermopower of CoFeB/MgO/CoFeB magnetic tunnel junctions (MTJ) in the presence of thermal gradients across the MTJ. Thermal gradients are generated by an electric heater on top of the nanopillars. The thermo power voltage across the MTJ is found to scale linearly with the heating power and reveals similar field dependence as the tunnel magnetoresistance. The amplitude of the thermal gradient is derived from calibration measurements in combination with finite element simulations of the heat flux. Based on this, large spin-dependent Seebeck coefficients of the order of (240 pm 110) muV/K are derived. From additional measurements on MTJs after dielectric breakdown, a tunneling magneto thermopower up to 90% can be derived for 1.5 nm MgO based MTJ nanopillars.
قيم البحث
اقرأ أيضاً
Thin electrodes of magnetic tunnel junctions can show superparamagnetism at surprisingly low temperature. We analysed their thermally induced switching for varying temperature, magnetic and electric field. Although the dwell times follow an Arrhenius
law, they are orders of magnitude too small compared to a model of single domain activation. Including entropic effects removes this inconsistency and leads to a magnetic activation volume much smaller than that of the electrode. Comparing data for varying barrier thickness then allows to separate the impact of Zeman energy, spin-transfer-torque and voltage induced anisotropy change on the dwell times. Based on these results, we demonstrate a tuning of the switching rates by combining magnetic and electric fields, which opens a path for their application in noisy neural networks.
We investigated the dependence of giant tunnel magnetoresistance (TMR) on the thickness of an MgO barrier and on the annealing temperature of sputtered CoFeB/MgO/CoFeB magnetic tunnel junctions deposited on SiO2/Si wafers. The resistance-area product
exponentially increases with MgO thickness, indicating that the quality of MgO barriers is high in the investigated thickness range of 1.15-2.4 nm. High-resolution transmission electron microscope images show that annealing at 375 C results in the formation of crystalline CoFeB/MgO/CoFeB structures, even though CoFeB electrodes are amorphous in the as-sputtered state. The TMR ratio increases with annealing temperature and is as high as 260% at room temperature and 403% at 5 K.
We investigated the low temperature performance of CoFeB/MgO based perpendicular magnetic tunnel junctions (pMTJs) by characterizing their quasi-static switching voltage, high speed pulse write error rate and endurance down to 9 K. pMTJ devices exhib
ited high magnetoresistance (>120%) and reliable (error rate<10-4) bi-directional switching with 2 to 200 ns voltage pulses. The endurance of the devices at 9 K surpassed that at 300 K by three orders of magnitude under the same write conditions, functioning for more than 10^12 cycles with 10 ns write pulses. The critical switching voltage at 9 K was observed to increase by 33% to 93%, depending on pulse duration, compared to that at 350 K. Ferromagnetic resonance and magnetization measurements on blanket pMTJ film stacks suggest that the increased switching voltage is associated with an increase in effective magnetic anisotropy and magnetization of free layer with decreasing temperature. Our work demonstrates that CoFeB/MgO based pMTJs have great potential to enable cryogenic MRAM and that their low temperature magnetization and effective magnetic anisotropy can be further optimized to lower operating power and improve endurance.
Current-driven magnetization switching in low-resistance Co40Fe40B20/MgO/Co40Fe40B20 magnetic tunnel junctions (MTJs) is reported. The critical-current densities Jc required for current-driven switching in samples annealed at 270C and 300C are found
to be as low as 7.8 x 10^5 A/cm^2 and 8.8 x 10^5 A/cm^2 with accompanying tunnel magnetoresistance (TMR) ratios of 49% and 73 %, respectively. Further annealing of the samples at 350C increases TMR ratio to 160 %, while accompanying Jc increases to 2.5 x 10^6 A/cm^2. We attribute the low Jc to the high spin-polarization of tunnel current and small MsV product of the CoFeB single free layer, where Ms is the saturation magnetization and V the volume of the free layer.
Recent advances in the understanding of spin orbital effects in ultrathin magnetic heterostructures have opened new paradigms to control magnetic moments electrically. The Dzyaloshinskii-Moriya interaction (DMI) is said to play a key role in forming
a Neel-type domain wall that can be driven by the spin Hall torque, a torque resulting from the spin current generated in a neighboring non-magnetic layer via the spin Hall effect. Here we show that the sign of the DMI, which determines the direction to which a domain wall moves with current, can be changed by modifying the adjacent non-magnetic layer. We find that the sense of rotation of a domain wall spiral is reversed when the Ta underlayer is doped with nitrogen in Ta|CoFeB|MgO heterostructures. The spin Hall angle of the Ta and nitrogen doped Ta underlayers carry the same sign, suggesting that the sign of the DMI is defined at the interface. Depending on the sense of rotation, spin transfer torque and spin Hall torque can either compete or assist each other, thus influencing the efficiency of moving domain walls with current.
سجل دخول لتتمكن من نشر تعليقات
التعليقات
جاري جلب التعليقات
سجل دخول لتتمكن من متابعة معايير البحث التي قمت باختيارها
