اشترك بالحزمة الذهبية واحصل على وصول غير محدود شمرا أكاديميا
تسجيل مستخدم جديدQuantification of the bond-angle dispersion by Raman spectroscopy and the strain energy of amorphous silicon
212
0
0.0
(
0
)
اسأل ChatGPT حول البحث
ﻻ يوجد ملخص باللغة العربية
A thorough critical analysis of the theoretical relationships between the bond-angle dispersion in a-Si and the width of the transverse optical (TO) Raman peak is presented. It is shown that the discrepancies between them are drastically reduced when unified definitions for these magnitudes are used. This reduced dispersion in the predicted values of the bond-angle dispersion together with the broad agreement with its scarce direct determinations is then used to analyze the strain energy in partially relaxed pure a-Si. It is concluded that defect annihilation does not contribute appreciably to reducing the a-Si energy during structural relaxation. In contrast, it can account for half of the crystallization energy, which can be as low as 7 kJ/mol in defect-free a-Si.
قيم البحث
اقرأ أيضاً
The nanostructure of hydrogenated amorphous silicon (a Si:H) is studied by a combination of small-angle X-ray (SAXS) and neutron scattering (SANS) with a spatial resolution of 0.8 nm. The a-Si:H materials were deposited using a range of widely varied
conditions and are representative for this class of materials. We identify two different phases which are embedded in the a-Si:H matrix and quantified both according to their scattering cross-sections. First, 1.2 nm sized voids (multivacancies with more than 10 missing atoms) which form a superlattice with 1.6 nm void-to-void distance are detected. The voids are found in concentrations as high as 6*10^19 ccm in a-Si:H material that is deposited at a high rate. Second, dense ordered domains (DOD) that are depleted of hydrogen with 1 nm average diameter are found. The DOD tend to form 10-15 nm sized aggregates and are largely found in all a-Si:H materials considered here. These quantitative findings make it possible to understand the complex correlation between structure and electronic properties of a-Si:H and directly link them to the light-induced formation of defects. Finally, a structural model is derived, which verifies theoretical predictions about the nanostructure of a-Si:H.
We revisit here how Raman spectroscopy can be used to estimate the H content in hard hydrogenated amorphous carbon layers. The H content was varied from 2 at.% to 30 at.%, using heat treatments of a a-C:H, from room temperature to 1300 K and was dete
rmined independently using ion beam analysis. We examine the correlation of various Raman parameters and the consistency of their thermal evolution with thermo-desorption results. We identify a weak band at 860 cm-1 attributed to H bonded to C(sp2). We show that the HD/HG parameter (Height ratio between the D and G bands) is quasi-linear in the full range of H content and can thus be used to estimate the H content. Conversely, we show that the m/HG parameter (ratio between the photoluminescence background, m, and the height of the G band), often used to estimate the H content, should be used with care, first because it is sensitive to various photoluminescence quenching processes and second because it is not sensitive to H bonded to C(sp2).
Raman spectroscopy has been used to identify defective bonding in neon and silicon ion irradiated single crystals of 6H-SiC. Observable differences exist in the C-C bonding region corresponding to different defect structures for neon and silicon ion
implantations. Raman spectra of ion irradiated SiC show less tensile strain than neutron irradiations, explained by a residual compressive stress caused by the swelling constrained by the undamaged substrate. Evidence of oxidation during high temperature ion implantation is observed as C-O and Si-O Raman signals. Annealing irradiated SiC while acquiring Raman spectra shows rapid recovery of Si-C bonding, but not a complete recovery of the unirradiated structure. Annealing irradiated SiC causes surface oxidation where unirradiated SiC does not oxidise. Comparisons are made to the apparent radiation resistance of diamond and silicon which have similar crystal structures, but are monatomic, leading to the suggestion that chemical defects are responsible for increased radiation damage in SiC.
Raman spectroscopy is a powerful tool for characterizing the local properties of graphene. Here, we introduce a method for evaluating unknown strain configurations and simultaneous doping. It relies on separating the effects of hydrostatic strain (pe
ak shift) and shear strain (peak splitting) on the Raman spectrum of graphene. The peak shifts from hydrostatic strain and doping are separated with a correlation analysis of the 2D and G frequencies. This enables us to obtain the local hydrostatic strain, shear strain and doping without any assumption on the strain configuration prior to the analysis. We demonstrate our approach for two model cases: Graphene under uniaxial stress on a PMMA substrate and graphene suspended on nanostructures that induce an unknown strain configuration. We measured $omega_mathrm{2D}/omega_mathrm{G} = 2.21 pm 0.05$ for pure hydrostatic strain. Raman scattering with circular corotating polarization is ideal for analyzing strain and doping, especially for weak strain when the peak splitting by shear strain cannot be resolved.
The effect of grain boundaries and wrinkles on the electrical properties of polycrystalline graphene is pronounced. Here we investigate the stitching between grains of polycrystalline graphene, specifically, overlapping of layers at the boundaries, g
rown by chemical vapor deposition (CVD) and subsequently doped by the oxidized Cu substrate. We analyze overlapped regions between 60 and 220 nm wide via Raman spectroscopy, and find that some of these overlapped boundaries contain AB stacked bilayers. The Raman spectra from the overlapped grain boundaries are distinctly different from bilayer graphene and exhibit splitting of the G band peak. The degree of splitting, peak widths, as well as peak intensities depend on the width of the overlap. We attribute these features to inhomogeneous doping by charge carriers (holes) across the overlapped regions via the oxidized Cu substrate. As a result, the Fermi level at the overlapped grain boundaries lies between 0.3 and 0.4 eV below the charge neutrality point. Our results suggest an enhancement of electrical conductivity across overlapped grain boundaries, similar to previously observed measurements(1). The dependence of charge distribution on the width of overlapping of grain boundaries may have strong implications for the growth of large-area graphene with enhanced conductivity.
سجل دخول لتتمكن من نشر تعليقات
التعليقات
جاري جلب التعليقات
سجل دخول لتتمكن من متابعة معايير البحث التي قمت باختيارها
