ترغب بنشر مسار تعليمي؟ اضغط هنا

Growth of Strongly Biaxially Aligned MgB2 Thin Films on Sapphire by Post-annealing of Amorphous Precursors

52   0   0.0 ( 0 )
 نشر من قبل Mark Blamire
 تاريخ النشر 2001
  مجال البحث فيزياء
والبحث باللغة English
 تأليف A. Berenov




اسأل ChatGPT حول البحث

MgB2 thin films were cold-grown on sapphire substrates by pulsed laser deposition (PLD), followed by post-annealing in mixed, reducing gas, Mg-rich, Zr gettered, environments. The films had Tcs in the range 29 K to 34 K, Jcs (20K, H=0) in the range 30 kA/cm2 to 300 kA/cm2, and irreversibility fields at 20 K of 4 T to 6.2 T. An inverse correlation was found between Tc and irreversibility field. The films had grain sizes of 0.1-1 micron and a strong biaxial alignment was observed in the 950C annealed film.

قيم البحث

اقرأ أيضاً

294 - R. Gandikota , R.K. Singh , J. Kim 2005
The effect of damage induced by 2-MeV alpha particles, followed by annealing, on the critical temperature (Tc), resistivity, and upper critical field (Hc2), of three MgB2 films made by different deposition processes has been studied. Damage creates a linear decrease in Tc with residual resistivity, and produces maxima in both Hc2(0)-perpendicular and Hc2(0)-parallel. Below Tcs of about 25 K, Hc2(0) depends roughly linearly on Tc, while the anisotropy of Hc2(0) decreases as Tc decreases. Annealing the films reproduces the Tc vs. residual resistivity dependence but not the Hc2(0) values induced by damage.
We report the effect of annealing on the superconductivity of MgB2 thin films as functions of the postannealing temperature in the range from 700 C to 950 C and of the postannealing time in the range from 30 min to 120 min. On annealing at 900 C for 30 min, we obtained the best-quality MgB2 films with a transition temperature of 39 K and a critical current density of ~ 10^7 A/cm^2. Using the scanning electron microscopy, we also investigated the film growth mechanism. The samples annealed at higher temperatures showed the larger grain sizes, well-aligned crystal structures with preferential orientations along the c-axis, and smooth surface morphologies. However, a longer annealing time prevented the alignment of grains and reduced the superconductivity, indicating a strong interfacial reaction between the substrate and the MgB2 film.
239 - Y. Zhao , M. Ionescu , J. Horvat 2003
A series of MgB2 thin films were fabricated by pulsed laser deposition (PLD), doped with various amounts of Si up to a level of 18wt%. Si was introduced into the PLD MgB2 films by sequential ablation of a stoichiometric MgB2 target and a Si target. T he doped films were deposited at 250 C and annealed in situ at 685 C for 1min. Up to a Si doping level of ~11wt%, the superconducting transition temperature (Tc) of the film does not change significantly, as compared to the control, undoped film. The magnetic critical current density (Jc) of the film at 5K was increased by 50% for a Si doping level of ~3.5wt%, as compared to the control film. Also, the irreversibility field of Si-doped MgB2 films (Hirr) at low temperature is higher than for the undoped film.
The growth mechanisms of MgB2 films obtained by different methods on various substrates are compared via a detailed cross-sectional scanning electron microscopy (SEM) study. The analyzed films include (a) samples obtained by an ex-situ post-anneal at 900 degree of e-beam evaporated boron in the presence of an Mg vapor (exhibiting bulk-like Tc0 about 38.8 K), (b) samples obtained by the same ex-situ 900 degree anneal of pulsed laser deposition (PLD)-grown Mg+B precursors (exhibiting Tc0 ~ 25 K), and (c) films obtained by a low-temperature (600 - 630 degree) in-situ anneal of PLD-grown Mg+B precursors (with Tc0 about 24 K). A significant oxygen contamination was also present in films obtained from a PLD-grown precursors. On the other hand, it is clearly observed that the films obtained by the high-temperature reaction of e-beam evaporated B with Mg vapor are formed by the nucleation of independent MgB2 grains at the film surface, indicating that this approach may not be suitable to obtain smooth and (possibly) epitaxial films.
التعليقات
جاري جلب التعليقات جاري جلب التعليقات
سجل دخول لتتمكن من متابعة معايير البحث التي قمت باختيارها
mircosoft-partner

هل ترغب بارسال اشعارات عن اخر التحديثات في شمرا-اكاديميا