اشترك بالحزمة الذهبية واحصل على وصول غير محدود شمرا أكاديميا
تسجيل مستخدم جديدImproving Freeway Merging Efficiency via Flow-Level Coordination of Connected and Autonomous Vehicles
158
0
0.0
(
0
)
اسأل ChatGPT حول البحث
ﻻ يوجد ملخص باللغة العربية
Freeway on-ramps are typical bottlenecks in the freeway network due to the frequent disturbances caused by their associated merging, weaving, and lane-changing behaviors. With real-time communication and precise motion control, Connected and Autonomous Vehicles (CAVs) provide an opportunity to substantially enhance the traffic operational performance of on-ramp bottlenecks. In this paper, we propose an upper-level control strategy to coordinate the two traffic streams at on-ramp merging through proactive gap creation and platoon formation. The coordination consists of three components: (1) mainline vehicles proactively decelerate to create large merging gaps; (2) ramp vehicles form platoons before entering the main road; (3) the gaps created on the main road and the platoons formed on the ramp are coordinated with each other in terms of size, speed, and arrival time. The coordination is formulated as a constrained optimization problem, incorporating both macroscopic and microscopic traffic flow models, for flow-level efficiency gains. The model uses traffic state parameters as inputs and determines the optimal coordination plan adaptive to real-time traffic conditions. The benefits of the proposed coordination are demonstrated through an illustrative case study. Results show that the coordination is compatible with real-world implementation and can substantially improve the overall efficiency of on-ramp merging, especially under high traffic volume conditions, where recurrent traffic congestion is prevented, and merging throughput increased.
قيم البحث
اقرأ أيضاً
This paper deals with the lateral control of a convoy of autonomous and connected following vehicles (ACVs) for executing an Emergency Lane Change (ELC) maneuver. Typically, an ELC maneuver is triggered by emergency cues from the front or the end of
convoy as a response to either avoiding an obstacle or making way for other vehicles to pass. From a safety viewpoint, connectivity of ACVs is essential as it entails obtaining or exchanging information about other ACVs in the convoy. This paper assumes that ACVs have reliable connectivity and that every following ACV has the information about GPS position traces of the lead and immediately preceding vehicles in the convoy. This information provides a discretized preview of the trajectory to be tracked. Based on the available information, this article focuses on two schemes for synthesizing lateral control of ACVs based on(a) a single composite ELC trajectory that fuses lead and preceding vehicles GPS traces and (b) separate ELC trajectories based on preview data of preceding and lead vehicles. The former case entails the construction of a single composite ELC trajectory, determine the cross-track error, heading and yaw rate errors with respect to this trajectory and synthesize a lateral control action. The latter case entails the construction of two separate trajectories corresponding to the lead vehicles and preceding vehicles data separately and the subsequent computation of two sets of associated errors and lateral control actions and combining them to provide a steering command. Numerical and experimental results corroborate the effectiveness of these two schemes.
Connected and Automated Vehicles (CAVs), particularly those with a hybrid electric powertrain, have the potential to significantly improve vehicle energy savings in real-world driving conditions. In particular, the Eco-Driving problem seeks to design
optimal speed and power usage profiles based on available information from connectivity and advanced mapping features to minimize the fuel consumption over an itinerary. This paper presents a hierarchical multi-layer Model Predictive Control (MPC) approach for improving the fuel economy of a 48V mild-hybrid powertrain in a connected vehicle environment. Approximate Dynamic Programming (ADP) is used to solve the Receding Horizon Optimal Control Problem (RHOCP), where the terminal cost for the RHOCP is approximated as the base-policy obtained from the long-term optimization. The controller was extensively tested virtually (using both deterministic and Monte Carlo simulations) across multiple real-world routes where energy savings of more than 20% have been demonstrated. Further, the developed controller was deployed and tested at a proving ground in real-time on a test vehicle equipped with a rapid prototyping embedded controller. Real-time in-vehicle testing confirmed the energy savings observed in simulation and demonstrated the ability of the developed controller to be effective in real-time applications.
In this paper, we study how to secure the platooning of autonomous vehicles when an unknown vehicle is under attack and bounded system uncertainties exist. For the attacked vehicle, its position and speed measurements from GPS can be manipulated arbi
trarily by a malicious attacker. First, to find out which vehicle is under attack, two detectors are proposed by using the relative measurements (by camera or radar) and the local innovation obtained through measurements from neighboring vehicles. Then, based on the results of the detectors, we design a local state observer for each vehicle by applying a saturation method to the measurement innovation. Moreover, based on the neighbor state estimates provided by the observer, a distributed controller is proposed to achieve the consensus in vehicle speed and keep fixed desired distance between two neighboring vehicles. The estimation error by the observer and the platooning error by the controller are shown to be asymptotically upper bounded under certain conditions. The effectiveness of the proposed methods is also evaluated in numerical simulations.
Capacity drop is an empirically observed phenomenon in vehicular traffic flow on freeways whereby, after a critical density is reached, a state of congestion sets in, but the freeway does not become decongested again until the density drops well belo
w the critical density. This introduces a hysteresis effect so that it is easier to enter the congested state than to leave it. However, many existing first-order models of traffic flow, particularly those used for control design, ignore capacity drop, leading to suboptimal controllers. In this paper, we consider a cell transmission model of traffic flow that incorporates capacity drop to study the problem of optimal freeway ramp metering. We show that, if capacity drop is ignored in the control design, then the resulting controller, obtained via a convex program, may be significantly suboptimal. We then propose an alternative model predictive controller that accounts for capacity drop via a mixed integer linear program and show that, for sufficiently large rollout horizon, this controller is optimal. We also compare these approaches to a heuristic hand-crafted controller that is viewed as a modification of an integral feedback controller to account for capacity drop. This heuristic controller outperforms the controller that ignores capacity drop but underperforms compared to the proposed alternative model predictive controller. These results suggest that it is generally important to include capacity drop in the controller design process, and we demonstrate this insight on several case studies.
The paper considers the problem of controlling Connected and Automated Vehicles (CAVs) traveling through a three-entry roundabout so as to jointly minimize both the travel time and the energy consumption while providing speed-dependent safety guarant
ees, as well as satisfying velocity and acceleration constraints. We first design a systematic approach to dynamically determine the safety constraints and derive the unconstrained optimal control solution. A joint optimal control and barrier function (OCBF) method is then applied to efficiently obtain a controller that optimally track the unconstrained optimal solution while guaranteeing all the constraints. Simulation experiments are performed to compare the optimal controller to a baseline of human-driven vehicles showing effectiveness under symmetric and asymmetric roundabout configurations, balanced and imbalanced traffic rates and different sequencing rules for CAVs.
سجل دخول لتتمكن من نشر تعليقات
التعليقات
جاري جلب التعليقات
سجل دخول لتتمكن من متابعة معايير البحث التي قمت باختيارها
