ترغب بنشر مسار تعليمي؟ اضغط هنا

HybridDeepRx: Deep Learning Receiver for High-EVM Signals

138   0   0.0 ( 0 )
 نشر من قبل Dani Korpi
 تاريخ النشر 2021
والبحث باللغة English




اسأل ChatGPT حول البحث

In this paper, we propose a machine learning (ML) based physical layer receiver solution for demodulating OFDM signals that are subject to a high level of nonlinear distortion. Specifically, a novel deep learning based convolutional neural network receiver is devised, containing layers in both time- and frequency domains, allowing to demodulate and decode the transmitted bits reliably despite the high error vector magnitude (EVM) in the transmit signal. Extensive set of numerical results is provided, in the context of 5G NR uplink incorporating also measured terminal power amplifier characteristics. The obtained results show that the proposed receiver system is able to clearly outperform classical linear receivers as well as existing ML receiver approaches, especially when the EVM is high in comparison with modulation order. The proposed ML receiver can thus facilitate pushing the terminal power amplifier (PA) systems deeper into saturation, and thereon improve the terminal power-efficiency, radiated power and network coverage.



قيم البحث

اقرأ أيضاً

In this work, we develop DeepWiPHY, a deep learning-based architecture to replace the channel estimation, common phase error (CPE) correction, sampling rate offset (SRO) correction, and equalization modules of IEEE 802.11ax based orthogonal frequency division multiplexing (OFDM) receivers. We first train DeepWiPHY with a synthetic dataset, which is generated using representative indoor channel models and includes typical radio frequency (RF) impairments that are the source of nonlinearity in wireless systems. To further train and evaluate DeepWiPHY with real-world data, we develop a passive sniffing-based data collection testbed composed of Universal Software Radio Peripherals (USRPs) and commercially available IEEE 802.11ax products. The comprehensive evaluation of DeepWiPHY with synthetic and real-world datasets (110 million synthetic OFDM symbols and 14 million real-world OFDM symbols) confirms that, even without fine-tuning the neural networks architecture parameters, DeepWiPHY achieves comparable performance to or outperforms the conventional WLAN receivers, in terms of both bit error rate (BER) and packet error rate (PER), under a wide range of channel models, signal-to-noise (SNR) levels, and modulation schemes.
138 - Houpu Yao , Jingjing Wen , Yi Ren 2019
Special high-end sensors with expensive hardware are usually needed to measure shock signals with high accuracy. In this paper, we show that cheap low-end sensors calibrated by deep neural networks are also capable to measure high-g shocks accurately . Firstly we perform drop shock tests to collect a dataset of shock signals measured by sensors of different fidelity. Secondly, we propose a novel network to effectively learn both the signal peak and overall shape. The results show that the proposed network is capable to map low-end shock signals to its high-end counterparts with satisfactory accuracy. To the best of our knowledge, this is the first work to apply deep learning techniques to calibrate shock sensors.
107 - Feng Shu , Lin Liu , Yumeng Zhang 2019
As a green and secure wireless transmission way, secure spatial modulation (SM) is becoming a hot research area. Its basic idea is to exploit both the index of activated transmit antenna and amplitude phase modulation (APM) signal to carry messages, improve security, and save energy. In this paper, we reviewed its crucial techniques: transmit antenna selection (TAS), artificial noise (AN) projection, power allocation (PA), and joint detection at desired receiver. To achieve the optimal performance of maximum likelihood (ML) detector, a deep-neural-network (DNN) joint detector is proposed to jointly infer the index of transmit antenna and signal constellation point with a lower-complexity. Here, each layer of DNN is redesigned to optimize the joint inference performance of two distinct types of information: transmit antenna index and signal constellation point. Simulation results show that the proposed DNN method performs 3dB better than the conventional DNN structure and is close to ML detection in the low and medium signal-to-noise ratio regions in terms of the bit error rate (BER) performance, but its complexity is far lower-complexity compared to ML. Finally, three key techniques TAS, PA, and AN projection at transmitter can be combined to make SM a true secure modulation.
Faster-than-Nyquist (FTN) is a promising paradigm to improve bandwidth utilization at the expense of additional intersymbol interference (ISI). In this paper, we apply state-of-the-art deep learning (DL) technology into receiver design for FTN signal ing and propose two DL-based new architectures. Firstly, we propose an FTN signal detection based on DL and connect it with the successive interference cancellation (SIC) to replace traditional detection algorithms. Simulation results show that this architecture can achieve near-optimal performance in both uncoded and coded scenarios. Additionally, we propose a DL-based joint signal detection and decoding for FTN signaling to replace the complete baseband part in traditional FTN receivers. The performance of this new architecture has also been illustrated by simulation results. Finally, both the proposed DL-based receiver architecture has the robustness to signal to noise ratio (SNR). In a nutshell, DL has been proved to be a powerful tool for the FTN receiver design.
104 - Shilian Zheng , Shichuan Chen , 2020
A canonical wireless communication system consists of a transmitter and a receiver. The information bit stream is transmitted after coding, modulation, and pulse shaping. Due to the effects of radio frequency (RF) impairments, channel fading, noise a nd interference, the signal arriving at the receiver will be distorted. The receiver needs to recover the original information from the distorted signal. In this paper, we propose a new receiver model, namely DeepReceiver, that uses a deep neural network to replace the traditional receivers entire information recovery process. We design a one-dimensional convolution DenseNet (1D-Conv-DenseNet) structure, in which global pooling is used to improve the adaptability of the network to different input signal lengths. Multiple binary classifiers are used at the final classification layer to achieve multi-bit information stream recovery. We also exploit the DeepReceiver for unified blind reception of multiple modulation and coding schemes (MCSs) by including signal samples of corresponding MCSs in the training set. Simulation results show that the proposed DeepReceiver performs better than traditional step-by-step serial hard decision receiver in terms of bit error rate under the influence of various factors such as noise, RF impairments, multipath fading, cochannel interference, dynamic environment, and unified reception of multiple MCSs.

الأسئلة المقترحة

التعليقات
جاري جلب التعليقات جاري جلب التعليقات
سجل دخول لتتمكن من متابعة معايير البحث التي قمت باختيارها
mircosoft-partner

هل ترغب بارسال اشعارات عن اخر التحديثات في شمرا-اكاديميا