ترغب بنشر مسار تعليمي؟ اضغط هنا

Can small-scale magnetic fields be the major cause for the near-surface effect of the solar p-mode frequencies?

82   0   0.0 ( 0 )
 نشر من قبل Yan Li
 تاريخ النشر 2021
  مجال البحث فيزياء
والبحث باللغة English




اسأل ChatGPT حول البحث

Small-scale magnetic fields are not only the fundamental element of the solar magnetism, but also closely related to the structure of the solar atmosphere. The observations have shown that there is a ubiquitous tangled small-scale magnetic field with a strength of 60 $sim$ 130,G in the canopy forming layer of the quiet solar photosphere. On the other hand, the multi-dimensional MHD simulations show that the convective overshooting expels the magnetic field to form the magnetic canopies at a height of about 500,km in the upper photosphere. However, the distribution of such small-scale ``canopies in the solar photosphere cannot be rigorously constrained by either observations and numerical simulations. Based on stellar standard models, we identify that these magnetic canopies can act as a global magnetic-arch splicing layer, and find that the reflections of the solar p-mode oscillations at this magnetic-arch splicing layer results in significant improvement on the discrepancy between the observed and calculated p-mode frequencies. The location of the magnetic-arch splicing layer is determined at a height of about 630,km, and the inferred strength of the magnetic field is about 90,G. These features of the magnetic-arch splicing layer derived independently in the present study are quantitatively in agreement with the presence of small-scale magnetic canopies as those obtained by the observations and 3-D MHD simulations.



قيم البحث

اقرأ أيضاً

Solar twins have been a focus of attention for more than a decade, because their structure is extremely close to that of the Sun. Today, thanks to high-precision spectrometers, it is possible to use asteroseismology to probe their interiors. Our goal is to use time series obtained from the HARPS spectrometer to extract the oscillation frequencies of 18 Sco, the brightest solar twin. We used the tools of spectral analysis to estimate these quantities. We estimate 52 frequencies using an MCMC algorithm. After examination of their probability densities and comparison with results from direct MAP optimization, we obtain a minimal set of 21 reliable modes. The identification of each pulsation mode is straightforwardly accomplished by comparing to the well-established solar pulsation modes. We also derived some basic seismic indicators using these values. These results offer a good basis to start a detailed seismic analysis of 18 Sco using stellar models.
While the longitudinal field that dominates photospheric network regions has been studied extensively, small scale transverse fields have recently been found to be ubiquitous in the quiet internetwork photosphere. Few observations have captured how t his field evolves. We aim to statistically characterise the magnetic properties and observe the temporal evolution of small scale magnetic features. We present two high spatial/temporal resolution observations that reveal the dynamics of two disk centre internetwork regions taken by the new GRIS/IFU (GREGOR Infrared Spectrograph Integral Field Unit) with the highly magnetically sensitive Fe I line pair at 15648.52 {AA} and 15652.87 {AA}. With the SIR code, we consider two inversion schemes: scheme 1 (S1), where a magnetic atmosphere is embedded in a field free medium, and scheme 2 (S2), with two magnetic models and a fixed stray light component. S1
This paper is the second in a series of studies working towards constructing a realistic, evolving, non-potential coronal model for the solar magnetic carpet. In the present study, the interaction of two magnetic elements is considered. Our objective s are to study magnetic energy build up, storage and dissipation as a result of emergence, cancellation, and flyby of these magnetic elements. In the future these interactions will be the basic building blocks of more complicated simulations involving hundreds of elements. Each interaction is simulated in the presence of an overlying uniform magnetic field, which lies at various orientations with respect to the evolving magnetic elements. For these three small-scale interactions, the free energy stored in the field at the end of the simulation ranges from $0.2-2.1times 10^{26}$ ergs, while the total energy dissipated ranges from $1.3-6.3times 10^{26}$ ergs. For all cases, a stronger overlying field results in higher energy storage and dissipation. For the cancellation and emergence simulations, motion perpendicular to the overlying field results in the highest values. For the flyby simulations, motion parallel to the overlying field gives the highest values. In all cases, the free energy built up is sufficient to explain small-scale phenomena such as X-ray bright points or nanoflares. In addition, if scaled for the correct number of magnetic elements for the volume considered, the energy continually dissipated provides a significant fraction of the quiet Sun coronal heating budget.
The CoRoT and Kepler missions have provided high-quality measurements of the frequency spectra of solar-like pulsators, enabling us to probe stellar interiors with a very high degree of accuracy by comparing the observed and modeled frequencies. Howe ver, the frequencies computed with 1D models suffer from systematic errors related to the poor modeling of the uppermost layers of stars. These biases are what is commonly named the near surface effect. The dominant effect is related to the turbulent pressure that modifies the hydrostatic equilibrium and thus the frequencies. This has already been investigated using grids of 3D RMHD simulations, which also were used to constrain the parameters of the empirical correction models. However, the effect of metallicity has not been considered so far. We study the impact of metallicity on the surface effect across the HR diagram, and provide a method for accounting for it when using the empirical correction models. We computed a grid of patched 1D stellar models with the stellar evolution code CESTAM in which poorly modeled surface layers have been replaced by averaged stratification computed with the 3D RMHD code CO5BOLD. We found that metallicity has a strong impact on the surface effect: keeping T_eff and log g constant, the frequency residuals can vary by up to a factor two. Therefore, the influence of metallicity cannot be neglected. We found that a correct way of accounting for it is to consider the surface Rosseland mean opacity. It allowed us to give a physically-grounded justification as well as a scaling relation for the frequency differences at nu_max as a function of T_eff, log g and kappa. Finally, we provide prescriptions for the fitting parameters of the correction functions. We show that the impact of metallicity through the Rosseland mean opacity must be taken into account when studying and correcting the surface effect.
50 - R. Howe , S. Basu , G. R. Davies 2016
The solar-cyle variation of acoustic mode frequencies has a frequency dependence related to the inverse mode inertia. The discrepancy between model predictions and measured oscillation frequencies for solar and solar-type stellar acoustic modes inclu des a significant frequency-dependent term known as the surface term that is also related to the inverse mode inertia. We parametrize both the surface term and the frequency variations for low-degree solar data from Birmingham Solar-Oscillations Network (BiSON) and medium-degree data from the Global Oscillations Network Group (GONG) using the mode inertia together with cubic and inverse frequency terms. We find that for the central frequency of rotationally split multiplets the cubic term dominates both the average surface term and the temporal variation, but for the medium-degree case the inverse term improves the fit to the temporal variation. We also examine the variation of the even-order splitting coefficients for the medium-degree data and find that, as for the central frequency, the latitude-dependent frequency variation, which reflects the changing latitudinal distribution of magnetic activity over the solar cycle, can be described by the combination of a cubic and an inverse function of frequency scaled by inverse mode inertia. The results suggest that this simple parametrization could be used to assess the activity-related frequency variation in solar-like asteroseismic targets.
التعليقات
جاري جلب التعليقات جاري جلب التعليقات
سجل دخول لتتمكن من متابعة معايير البحث التي قمت باختيارها
mircosoft-partner

هل ترغب بارسال اشعارات عن اخر التحديثات في شمرا-اكاديميا