ترغب بنشر مسار تعليمي؟ اضغط هنا

Ray-tracing Analysis for Cross-polarization Scattering Diagnostic on MAST-Upgrade Spherical Tokamak

68   0   0.0 ( 0 )
 نشر من قبل Rongjie Hong
 تاريخ النشر 2021
  مجال البحث فيزياء
والبحث باللغة English




اسأل ChatGPT حول البحث

A combined Doppler backscattering/cross-polarization scattering (DBS/CPS) system is being deployed on MAST-U, for simultaneous measurements of local density turbulence, turbulence flows, and magnetic turbulence. In this design, CPS shares the probing beam with the DBS and uses a separate parallel-viewing receiver system. In this study, we utilize a modified GENRAY 3D ray-tracing code, to simulate the propagation of the probing and scattered beams. The contributions of different scattering locations along the entire beam trajectories are considered, and the corresponding local $tilde{mathbf{B}}$ wavenumbers are estimated using the wave-vector matching criterion. The wavenumber ranges of the local $tilde{mathbf{B}}$ that is detectable to the CPS system are explored for simulated L- and H-mode plasmas.



قيم البحث

اقرأ أيضاً

The Beam Emission Spectroscopy (BES) turbulence diagnostic on MAST is to be upgraded in June 2010 from a 1D trial system to a 2D imaging system (8 radial times 4 poloidal channels) based on a newly developed APD array camera. The spatial resolution o f the new system is calculated in terms of the point spread function (PSF) to account for the effects of field-line curvature, observation geometry, the finite lifetime of the excited state of the beam atoms, and beam attenuation and divergence. It is found that the radial spatial resolution is ~ 2-3 cm and the poloidal spatial resolution ~ 1-5 cm depending on the radial viewing location. The absolute number of detected photons is also calculated, hence the photon noise level can be determined
75 - B.Yuan , M.Xu , Y.Yu 2017
A new gas puff imaging (GPI) diagnostic has been developed on the HL-2A tokamak to study two-dimensional plasma edge turbulence in poloidal vs. radial plane. During a discharge, neutral helium or deuterium gas is puffed at the edge of the plasma thro ugh a rectangular multi-capillary nozzle to generate a gas cloud on the observing plane. Then a specially designed telescope and a high-speed camera are used to observe and photograph the emission from the neutral gas cloud. The brightness and contrast in the 2-D poloidal vs. radial frames reveal the structures and movements of the turbulence. The diagnostic was put into the first experiment during the latest campaign and successfully captured blob structures of different shapes and sizes in scrape-off layer (SOL).
A potentially important feature in a divertor design for a high-power tokamak is an extended and expanded divertor leg. The upgrade to MAST will allow a wide range of such divertor leg geometries to be produced, and hence will allow the roles of grea tly increased connection length and flux expansion to be experimentally tested. This will include testing the potential of the Super-X configuration [1]. The design process for the upgrade has required analysis of producing and controlling the magnetic configurations, and has included consideration of the roles that divertor closure and increasing magnetic connection length will play.
Results from the last FTU campaigns on the deuterium large (wrt FTU volume) pellet REs suppression capability, mainly due to the induced burst MHD activity expelling REs seed are presented for discharges with 0.5 MA and 5.3T. Clear indications of ava lanche multiplication of REs following single pellet injection on 0.36 MA flat-top discharges is shown together with quantitative indications of dissipative effects in terms of critical electrical field increase due to fan-like instabilities. Analysis of large fan-like instabilities on post-disruption RE beams, that seem to be correlated with low electrical field and background density drops, reveal their strong RE energy suppression capability suggesting a new strategy for RE energy suppression controlling large fan instabilities. We demonstrate how such density drops can be induced using modulated ECRH power on post-disruption beams.
Sustained ELM mitigation has been achieved on MAST and AUG using RMPs with a range of toroidal mode numbers over a wide region of low to medium collisionality discharges. The ELM energy loss and peak heat loads at the divertor targets have been reduc ed. The ELM mitigation phase is typically associated with a drop in plasma density and overall stored energy. In one particular scenario on MAST, by carefully adjusting the fuelling it has been possible to counteract the drop in density and to produce plasmas with mitigated ELMs, reduced peak divertor heat flux and with minimal degradation in pedestal height and confined energy. While the applied resonant magnetic perturbation field can be a good indicator for the onset of ELM mitigation on MAST and AUG there are some cases where this is not the case and which clearly emphasise the need to take into account the plasma response to the applied perturbations. The plasma response calculations show that the increase in ELM frequency is correlated with the size of the edge peeling-tearing like response of the plasma and the distortions of the plasma boundary in the X-point region.
التعليقات
جاري جلب التعليقات جاري جلب التعليقات
سجل دخول لتتمكن من متابعة معايير البحث التي قمت باختيارها
mircosoft-partner

هل ترغب بارسال اشعارات عن اخر التحديثات في شمرا-اكاديميا