ترغب بنشر مسار تعليمي؟ اضغط هنا

Development of a New Gas Puff Imaging Diagnostic on the HL-2A Tokamak

76   0   0.0 ( 0 )
 نشر من قبل Boda Yuan
 تاريخ النشر 2017
  مجال البحث فيزياء
والبحث باللغة English




اسأل ChatGPT حول البحث

A new gas puff imaging (GPI) diagnostic has been developed on the HL-2A tokamak to study two-dimensional plasma edge turbulence in poloidal vs. radial plane. During a discharge, neutral helium or deuterium gas is puffed at the edge of the plasma through a rectangular multi-capillary nozzle to generate a gas cloud on the observing plane. Then a specially designed telescope and a high-speed camera are used to observe and photograph the emission from the neutral gas cloud. The brightness and contrast in the 2-D poloidal vs. radial frames reveal the structures and movements of the turbulence. The diagnostic was put into the first experiment during the latest campaign and successfully captured blob structures of different shapes and sizes in scrape-off layer (SOL).



قيم البحث

اقرأ أيضاً

Edge shear flow and its effect on regulating turbulent transport have long been suspected to play an important role in plasmas operating near the Greenwald density limit $ n_G $. In this study, equilibrium profiles as well as the turbulent particle f lux and Reynolds stress across the separatrix in the HL-2A tokamak are examined as $ n_G $ is approached in ohmic L-mode discharges. As the normalized line-averaged density $ bar{n}_e/n_G $ is raised, the shearing rate of the mean poloidal flow $ omega_{rm sh} $ drops, and the turbulent drive for the low-frequency zonal flow (the Reynolds power $ mathcal{P}_{Re} $) collapses. Correspondingly, the turbulent particle transport increases drastically with increasing collision rates. The geodesic acoustic modes (GAMs) gain more energy from the ambient turbulence at higher densities, but have smaller shearing rate than low-frequency zonal flows. The increased density also introduces decreased adiabaticity which not only enhances the particle transport but is also related to a reduction in the eddy-tilting and the Reynolds power. Both effects may lead to the cooling of edge plasmas and therefore the onset of MHD instabilities that limit the plasma density.
67 - R. Hong , T. L. Rhodes , G. Wang 2021
A combined Doppler backscattering/cross-polarization scattering (DBS/CPS) system is being deployed on MAST-U, for simultaneous measurements of local density turbulence, turbulence flows, and magnetic turbulence. In this design, CPS shares the probing beam with the DBS and uses a separate parallel-viewing receiver system. In this study, we utilize a modified GENRAY 3D ray-tracing code, to simulate the propagation of the probing and scattered beams. The contributions of different scattering locations along the entire beam trajectories are considered, and the corresponding local $tilde{mathbf{B}}$ wavenumbers are estimated using the wave-vector matching criterion. The wavenumber ranges of the local $tilde{mathbf{B}}$ that is detectable to the CPS system are explored for simulated L- and H-mode plasmas.
Statistical properties of the scrape-off layer (SOL) plasma fluctuations are studied in ohmically heated plasmas in the Alcator C-Mod tokamak. For the first time, plasma fluctuations as well as parameters that describe the fluctuations are compared a cross measurements from a mirror Langmuir probe (MLP) and from gas-puff imaging (GPI) that sample the same plasma discharge. This comparison is complemented by an analysis of line emission time-series data, synthesized from the MLP electron density and temperature measurements. The fluctuations observed by the MLP and GPI typically display relative fluctuation amplitudes of order unity together with positively skewed and flattened probability density functions. Such data time series are well described by an established stochastic framework which model the data as a superposition of uncorrelated, two-sided exponential pulses. The most important parameter of the process is the intermittency parameter, {gamma} = {tau}d / {tau}w where {tau}d denotes the duration time of a single pulse and {tau}w gives the average waiting time between consecutive pulses. Here we show, using a new deconvolution method, that these parameters can be consistently estimated from different statistics of the data. We also show that the statistical properties of the data sampled by the MLP and GPI diagnostic are very similar. Finally, a comparison of the GPI signal to the synthetic line-emission time series suggests that the measured emission intensity can not be explained solely by a simplified model which neglects neutral particle dynamics.
Various MHD (magnetohydrodynamic) equilibrium tools, some of which being recently developed or considerably updated, are used on the COMPASS tokamak at IPP Prague. MHD equilibrium is a fundamental property of the tokamak plasma, whose knowledge is re quired for many diagnostics and modelling tools. Proper benchmarking and validation of equilibrium tools is thus key for interpreting and planning tokamak experiments. We present here benchmarks and comparisons to experimental data of the EFIT++ reconstruction code [L.C. Appel et al., EPS 2006, P2.184], the free-boundary equilibrium code FREEBIE [J.-F. Artaud, S.H. Kim, EPS 2012, P4.023], and a rapid plasma boundary reconstruction code VacTH [B. Faugeras et al., PPCF 56, 114010 (2014)]. We demonstrate that FREEBIE can calculate the equilibrium and corresponding poloidal field (PF) coils currents consistently with EFIT++ reconstructions from experimental data. Both EFIT++ and VacTH can reconstruct equilibria generated by FREEBIE from synthetic, optionally noisy diagnostic data. Hence, VacTH is suitable for real-time control. Optimum reconstruction parameters are estimated.
93 - Yuejiang Shi 2018
A novel magnetic confined fusion scheme for the fusion reactor is proposed in this paper. A simple numerical estimation shows that ignition of D-T plasma can be achieved in tokamak with only OH heating by major and minor radius adiabatic compression. The density and temperature of compressed plasma can reach 1-3*10^22/m^3 and 15-25keV, respectively. Alternating current with adiabatic compression pulse of ACACT with R0 = 1.8m can deliver 400MW fusion power.
التعليقات
جاري جلب التعليقات جاري جلب التعليقات
سجل دخول لتتمكن من متابعة معايير البحث التي قمت باختيارها
mircosoft-partner

هل ترغب بارسال اشعارات عن اخر التحديثات في شمرا-اكاديميا