ترغب بنشر مسار تعليمي؟ اضغط هنا

Biaxial versus uniaxial strain tuning of single-layer MoS$_2$

123   0   0.0 ( 0 )
 نشر من قبل Andres Castellanos-Gomez
 تاريخ النشر 2020
  مجال البحث فيزياء
والبحث باللغة English




اسأل ChatGPT حول البحث

Strain engineering has arisen as a powerful technique to tune the electronic and optical properties of two-dimensional semiconductors like molybdenum disulfide (MoS2). Although several theoretical works predicted that biaxial strain would be more effective than uniaxial strain to tune the band structure of MoS2, a direct experimental verification is still missing in the literature. Here we implemented a simple experimental setup that allows to apply biaxial strain through the bending of a cruciform polymer substrate. We used the setup to study the effect of biaxial strain on the differential reflectance spectra of 12 single-layer MoS2 flakes finding a redshift of the excitonic features at a rate between -40 meV/% and -110 meV/% of biaxial tension. We also directly compare the effect of biaxial and uniaxial strain on the same single-layer MoS2 finding that the biaxial strain gauge factor is 2.3 times larger than the uniaxial strain one.



قيم البحث

اقرأ أيضاً

The advancement of nanoscale electronics has been limited by energy dissipation challenges for over a decade. Such limitations could be particularly severe for two-dimensional (2D) semiconductors integrated with flexible substrates or multi-layered p rocessors, both being critical thermal bottlenecks. To shed light into fundamental aspects of this problem, here we report the first direct measurement of spatially resolved temperature in functioning 2D monolayer MoS$_2$ transistors. Using Raman thermometry we simultaneously obtain temperature maps of the device channel and its substrate. This differential measurement reveals the thermal boundary conductance (TBC) of the MoS$_2$ interface (14 $pm$ 4 MWm$^-$$^2$K$^-$$^1$) is an order magnitude larger than previously thought, yet near the low end of known solid-solid interfaces. Our study also reveals unexpected insight into non-uniformities of the MoS$_2$ transistors (small bilayer regions), which do not cause significant self-heating, suggesting that such semiconductors are less sensitive to inhomogeneity than expected. These results provide key insights into energy dissipation of 2D semiconductors and pave the way for the future design of energy-efficient 2D electronics.
We fabricate large-area atomically thin MoS$_2$ layers through the direct transformation of crystalline molybdenum MoS$_2$ (MoO$_3$) by sulfurization at relatively low temperatures. The obtained MoS2 sheets are polycrystalline (~10-20 nm single-cryst al domain size) with areas of up to 300x300 um$^2$ with 2-4 layers in thickness and show a marked p-type behaviour. The synthesized films are characterized by a combination of complementary techniques: Raman spectroscopy, X-ray diffraction, transmission electron microscopy and electronic transport measurements.
Semiconductors require stable doping for applications in transistors, optoelectronics, and thermoelectrics. However, this has been challenging for two-dimensional (2D) materials, where existing approaches are either incompatible with conventional sem iconductor processing or introduce time-dependent, hysteretic behavior. Here we show that low temperature (< 200$^circ$ C) sub-stoichiometric AlO$_x$ provides a stable n-doping layer for monolayer MoS$_2$, compatible with circuit integration. This approach achieves carrier densities > 2x10$^{13}$ 1/cm$^2$, sheet resistance as low as ~7 kOhm/sq, and good contact resistance ~480 Ohm.um in transistors from monolayer MoS$_2$ grown by chemical vapor deposition. We also reach record current density of nearly 700 uA/um (>110 MA/cm$^2$) in this three-atom-thick semiconductor while preserving transistor on/off current ratio > $10^6$. The maximum current is ultimately limited by self-heating and could exceed 1 mA/um with better device heat sinking. With their 0.1 nA/um off-current, such doped MoS$_2$ devices approach several low-power transistor metrics required by the international technology roadmap
We present a transient absorption setup combining broadband detection over the visible-UV range with high temporal resolution ($sim$20fs) which is ideally suited to trigger and detect vibrational coherences in different classes of materials. We gener ate and detect coherent phonons (CPs) in single layer (1L) MoS$_2$, as a representative semiconducting 1L-transition metal dichalcogenide (TMD), where the confined dynamical interaction between excitons and phonons is unexplored. The coherent oscillatory motion of the out-of-plane $A_{1}$ phonons, triggered by the ultrashort laser pulses, dynamically modulates the excitonic resonances on a timescale of few tens fs. We observe an enhancement by almost two orders of magnitude of the CP amplitude when detected in resonance with the C exciton peak, combined with a resonant enhancement of CP generation efficiency. Ab initio calculations of the change in 1L-MoS$_2$ band structure induced by the $A_{1}$ phonon displacement confirm a strong coupling with the C exciton. The resonant behavior of the CP amplitude follows the same spectral profile of the calculated Raman susceptibility tensor. This demonstrates that CP excitation in 1L-MoS$_2$ can be described as a Raman-like scattering process. These results explain the CP generation process in 1L-TMDs, paving the way for coherent all-optical control of excitons in layered materials in the THz frequency range.
In this letter we present photoluminescence measurements with different excitation energies on single-layer MoS$_2$ and MoSe$_2$ in order to examine the resonance behavior of the conservation of circular polarization in these transition metal dichalc ogenides. We find that the circular polarization of the emitted light is conserved to 100% in MoS$_2$ and 84% / 79% (A/A$^-$ peaks) in MoSe$_2$ close to resonance. The values for MoSe$_2$ surpass any previously reported value. However, in contrast to previous predictions, the degree of circular polarization decreases clearly at energies less than the two-phonon longitudinal acoustic phonon energy above the resonance. Our findings indicate that at least two competing processes underly the depolarization of the emission in single-layer transition metal dichalcogenides.
التعليقات
جاري جلب التعليقات جاري جلب التعليقات
سجل دخول لتتمكن من متابعة معايير البحث التي قمت باختيارها
mircosoft-partner

هل ترغب بارسال اشعارات عن اخر التحديثات في شمرا-اكاديميا