اشترك بالحزمة الذهبية واحصل على وصول غير محدود شمرا أكاديميا
تسجيل مستخدم جديدInterfacial studies in CNT fibre/TiO$_{2}$ photoelectrodes for efficient H$_{2}$ production
54
0
0.0
(
0
)
اسأل ChatGPT حول البحث
ﻻ يوجد ملخص باللغة العربية
An attractive class of materials for photo(electro)chemical reactions are hybrids based on semiconducting metal oxides and nanocarbons (e.g. carbon nanotubes (CNT), graphene), where the nanocarbon acts as a highly-stable conductive scaffold onto which the nanostructured inorganic phase can be immobilised; an architecture that maximises surface area and minimises charge transport/transfer resistance. TiO$_{2}$/CNT photoanodes produced by atomic layer deposition on CNT fabrics are shown to be efficient for H$_{2}$ production ($0.07 mu mol/min$ $H_{2}$ at $0.2V$ $vs Ag/AgCl$), nearly doubling the performance of TiO$_{2}$ deposited on planar substrates, with $100 %$ Faradaic efficiency. The results are rationalised based on electrochemical impedance spectroscopy measurements showing a large reduction in photoelectron transport resistance compared to control samples and a higher surface area. The low TiO$_{2}$/CNT interfacial charge transfer resistance ($10 Omega$) is consistent with the presence of an interfacial Ti-O-C bond and corresponding electronic hybridisation determined by spatially-resolved Scanning Photoelectron Microscopy (SPEM) using synchrotron radiation.
قيم البحث
اقرأ أيضاً
Hybridisation is a powerful strategy towards the next generation of multifunctional materials for environmental and sustainable energy applications. Here, we report a new inorganic nanocarbon hybrid material prepared with atomically controlled deposi
tion of a monocrystalline TiO2 layer that conformally coats a macroscopic carbon nanotube (CNT) fiber. Through X-ray diffraction, Raman spectroscopy and photoemission spectroscopy we detect the formation of a covalent Ti-O-C bond at the TiO2/CNT interface and a residual strain of approximately 0.7-2 %, which is tensile in TiO2 and compressive in the CNT. It arises after deposition of the amorphous oxide onto the CNT surface previously functionalized by the oxygen plasma used in ALD. These features are observed in samples of different TiO2 thickness, in the range from 10 to 80 nm. Ultraviolet photoemission spectroscopy on a 20 nm-thick TiO2 coated sample gives a work function of 4.27 eV, between that of TiO2 (4.23 eV) and the CNT fiber (4.41 eV), and the presence of new interband gap states that shift the valence band maximum to 1.05 eV below the Fermi level. Photoelectrochemical measurements demonstrate electron transfer from TiO2 to the CNT fiber network under UV irradiation. Electrochemical impedance spectroscopy measurements reveal a low resistance for charge transfer and transport, as well as a large capacitance. Our results point to the fact that these hybrids, in which each phase has nanometric thickness and the current collector is integrated into the material, are very different from conventional electrodes and can provide a number of superior properties.
(LaNiO3)n/(LaMnO3)2 superlattices were grown using ozone-assisted molecular beam epitaxy, where LaNiO3 is a paramagnetic metal and LaMnO3 is an antiferromagnetic insulator. The superlattices exhibit excellent crystallinity and interfacial roughness o
f less than 1 unit cell. X-ray spectroscopy and dichroism measurements indicate that electrons are transferred from the LaMnO3 to the LaNiO3, inducing magnetism in LaNiO3. Magnetotransport measurements reveal a transition from metallic to insulating behavior as the LaNiO3 layer thickness is reduced from 5 unit cells to 2 unit cells and suggest a modulated magnetic structure within LaNiO3.
The structure and dehydration mechanism of the proton conducting oxide Ba$_{2}$In$_{2}$O$_{5}$(H$_{2}$O)$_{x}$ are investigated by means of variable temperature Raman spectroscopy together with inelastic neutron scattering. At room temperature, Ba$_{
2}$In$_{2}$O$_{5}$(H$_{2}$O)$_{x}$ is found to be fully hydrated ($x=1$) and to have a perovskite-like structure, which dehydrates gradually with increasing temperature and at around 600 $^{circ}$C the material is essentially completely dehydrated ($x=0$). The dehydrated material exhibits a brownmillerite structure, which is featured by alternating layers of InO$_{6}$ octahedra and InO$_{4}$ tetrahedra. The transition from a perovskite-like to a brownmillerite-like structure is featured by a hydrated-to-intermediate phase transition at $ca.$ 370 {deg}C. The structure of the intermediate phase is similar to the structure of the fully dehydrated material, but with the difference that it exhibits a non-centrosymmetric distortion of the InO$_{6}$ octahedra not present in the latter. For temperatures below the hydrated-to-intermediate phase transition, dehydration is featured by the release of protons confined to the layers of InO$_{4}$ tetrahedra, whereas above the transition also protons bound to oxygens of the layers of InO$_{6}$ are released. Finally, we found that the O-H stretch region of the vibrational spectra is not consistent with a single-phase spectrum, but is in agreement with the superposition of spectra associated with two different proton configurations. The relative contributions of the two proton configurations depend on how the sample is hydrated.
Transition metal dichalcogenides (TMDs) are promising materials for efficient generation of current-induced spin-orbit torques on an adjacent ferromagnetic layer. Numerous effects, both interfacial and bulk, have been put forward to explain the diffe
rent torques previously observed. Thus far, however, there is no clear consensus on the microscopic origin underlying the spin-orbit torques observed in these TMD/ferromagnet bilayers. To shine light on the microscopic mechanisms at play, here we perform thickness dependent spin-orbit torque measurements on the semiconducting WSe$_{2}$/permalloy bilayer with various WSe$_{2}$ layer thickness, down to the monolayer limit. We observe a large out-of-plane field-like torque with spin-torque conductivities up to $1times10^4 ({hbar}/2e) ({Omega}m)^{-1}$. For some devices, we also observe a smaller in-plane antidamping-like torque, with spin-torque conductivities up to $4times10^{3} ({hbar}/2e) ({Omega}m)^{-1}$, comparable to other TMD-based systems. Both torques show no clear dependence on the WSe$_{2}$ thickness, as expected for a Rashba system. Unexpectedly, we observe a strong in-plane magnetic anisotropy - up to about $6.6times10^{4} erg/cm^{3}$ - induced in permalloy by the underlying hexagonal WSe$_{2}$ crystal. Using scanning transmission electron microscopy, we confirm that the easy axis of the magnetic anisotropy is aligned to the armchair direction of the WSe$_{2}$. Our results indicate a strong interplay between the ferromagnet and TMD, and unveil the nature of the spin-orbit torques in TMD-based devices. These findings open new avenues for possible methods for optimizing the torques and the interaction with interfaced magnets, important for future non-volatile magnetic devices for data processing and storage.
We report measurements of the dynamics of isolated $^{8}$Li$^{+}$ in single crystal rutile TiO$_{2}$ using $beta$-detected NMR. From spin-lattice relaxation and motional narrowing, we find two sets of thermally activated dynamics: one below 100 K; an
d one at higher temperatures. At low temperature, the activation barrier is $26.8(6)$ meV with prefactor $1.23(5) times 10^{10}$ s$^{-1}$. We suggest this is unrelated to Li$^{+}$ motion, and rather is a consequence of electron polarons in the vicinity of the implanted $^{8}$Li$^{+}$ that are known to become mobile in this temperature range. Above 100 K, Li$^{+}$ undergoes long-range diffusion as an isolated uncomplexed cation, characterized by an activation energy and prefactor of $0.32(2)$ eV and $1.0(5) times 10^{16}$ s$^{-1}$, in agreement with macroscopic diffusion measurements. These results in the dilute limit from a microscopic probe indicate that Li$^{+}$ concentration does not limit the diffusivity even up to high concentrations, but that some key ingredient is missing in the calculations of the migration barrier. The anomalous prefactors provide further insight into both Li$^{+}$ and polaron motion.
سجل دخول لتتمكن من نشر تعليقات
التعليقات
جاري جلب التعليقات
سجل دخول لتتمكن من متابعة معايير البحث التي قمت باختيارها
