اشترك بالحزمة الذهبية واحصل على وصول غير محدود شمرا أكاديميا
تسجيل مستخدم جديدQuantum Nuclei at Weakly Bonded Interfaces: The Case of Cyclohexane on Rh(111)
165
0
0.0
(
0
)
تأليف
Karen Fidanyan
اسأل ChatGPT حول البحث
ﻻ يوجد ملخص باللغة العربية
The electronic properties of interfaces can depend on their isotopic constitution. One known case is that of cyclohexane physisorbed on Rh(111), in which isotope effects have been measured on the work function change and desorption energies. These effects can only be captured by calculations including nuclear quantum effects (NQE). In this paper, this interface is addressed employing dispersion-inclusive density-functional theory coupled to a quasi-harmonic (QH) approximation for NQE, as well as to fully anharmonic ab initio path integral molecular dynamics (PIMD). The QH approximation is able to capture that deuterated cyclohexane has a smaller adsorption energy and lies about 0.01 A farther from the Rh(111) surface than its isotopologue, which can be correlated to the isotope effect in the work function change. An investigation of the validity of the QH approximation relying on PIMD simulations, leads to the conclusion that although this interface is highly impacted by anharmonic quantum fluctuations in the molecular layer and at bonding sites, these anharmonic contributions play a minor role when analysing isotope effects at low temperatures. Nevertheless, anharmonic quantum fluctuations cause an increase in the distance between the molecular layer and Rh(111), a consequent smaller overall work function change, and intricate changes in orbital hybridization.
قيم البحث
اقرأ أيضاً
GaN-based HEMTs have the potential to be widely used in high-power and high-frequency electronics while their maximum output powers are limited by high channel temperature induced by near-junction Joule-heating, which degrades device performance and
reliability. Increasing the TBC between GaN and SiC will aid in the heat dissipation of GaN-on-SiC power devices, taking advantage of the high thermal conductivity of the SiC substrate. However, a good understanding of the TBC of this technically important interface is still lacking due to the complicated nature of interfacial heat transport. In this work, a lattice-mismatch-insensitive surface activated bonding method is used to bond GaN directly to SiC and thus eliminating the AlN layer altogether. This allows for the direct integration of high quality GaN layers with SiC to create a high thermal boundary conductance interface. TDTR is used to measure the thermal properties of the GaN thermal conductivity and GaN-SiC TBC. The measured GaN thermal conductivity is larger than that of GaN grown by MBE on SiC, showing the impact of reducing the dislocations in the GaN near the interface. High GaN-SiC TBC is observed for the bonded GaN-SiC interfaces, especially for the annealed interface whose TBC (230 MW/m2-K) is close to the highest values ever reported. To understand the structure-thermal property relation, STEM and EELS are used to characterize the interface structure. The results show that, for the as-bonded sample, there exists an amorphous layer near the interface for the as bonded samples. This amorphous layer is crystallized upon annealing, leading to the high TBC found in our work. Our work paves the way for thermal transport across bonded interfaces, which will impact real-world applications of semiconductor integration and packaging.
The interface formation between copper phthalocyanine (CuPc) and two representative metal substrates, i.e., Au and Co, was investigated by the combination of ultraviolet photoelectron spectroscopy and inverse photoelectron spectroscopy. The occupied
and unoccupied molecular orbitals and thus the transport band gap of CuPc are highly influenced by film thickness, i.e., molecule-substrate distance. Due to the image charge potential given by the metallic substrates the transport band gap of CuPc opens from $(1.4 pm 0.3)$ eV for 1 nm thickness to $(2.2 pm 0.3)$ eV, and saturates at this value above 10 nm CuPc thickness. The interface dipoles with values of 1.2 eV and 1.0 eV for Au and Co substrates, respectively, predominantly depend on the metal substrate work functions. X-ray photoelectron spectroscopy measurements using synchrotron radiation provide detailed information on the interaction between CuPc and the two metal substrates. While charge transfer from the Au or Co substrate to the Cu metal center is present only at sub-monolayer coverages, the authors observe a net charge transfer from the molecule to the Co substrate for films in the nm range. Consequently, the Fermi level is shifted as in the case of a p-type doping of the molecule. This is, however, a competing phenomenon to the energy band shifts due to the image charge potential.
The wide bandgap, high-breakdown electric field, and high carrier mobility makes GaN an ideal material for high-power and high-frequency electronics applications such as wireless communication and radar systems. However, the performance and reliabili
ty of GaN-based HEMTs are limited by the high channel temperature induced by Joule-heating in the device channel. High thermal conductivity substrates integrated with GaN can improve the extraction of heat from GaN based HEMTs and lower the device operating temperature. However, heterogeneous integration of GaN with diamond substrates is not trivial and presents technical challenges to maximize the heat dissipation potential brought by the diamond substrate. In this work, two modified room temperature surface activated bonding techniques are used to bond GaN and single crystal diamond with different interlayer thicknesses. TDTR is used to measure the thermal properties from room temperature to 480 K. A relatively large TBC of the GaN-diamond interfaces with a 4nm interlayer was observed and material characterization was performed to link the structure of the interface to the TBC. Device modeling shows that the measured GaN-diamond TBC values obtained from bonding can enable high power GaN devices by taking the full advantage of the high thermal conductivity of single crystal diamond and achieve excellent cooling effect. Furthermore, the room-temperature bonding process in this work do not induce stress problem due to different coefficient of thermal expansion in other high temperature integration processes in previous studies. Our work sheds light on the potential for room-temperature heterogeneous integration of semiconductors with diamond for applications of electronics cooling especially for GaN-on-diamond devices.
Although common in nature, the self-assembly of small molecules at sold-liquid interfaces is difficult to control in artificial systems. The high mobility of dissolved small molecules limits their residence at the interface, typically restricting the
self-assembly to systems under confinement or with mobile tethers between the molecules and the surface. Small hydrogen-bonding molecules can overcome these issues by exploiting group-effect stabilization to achieve non-tethered self-assembly at hydrophobic interfaces. Significantly, the weak molecular interactions with the solid makes it possible to influence the interfacial hydrogen bond network, potentially creating a wide variety of supramolecular structures. Here we investigate the nanoscale details of water and alcohols mixtures self-assembling at the interface with graphite through group effect. We explore the interplay between inter-molecular and surface interactions by adding small amounts of foreign molecules able to interfere with the hydrogen bond network and systematically varying the length of the alcohol hydrocarbon chain. The resulting supramolecular structures forming at room temperature are then examined using atomic force microscopy with insights from computer simulations. We show that the group-based self-assembly approach investigated here is general and can be reproduced on other substrates such as molybdenum disulphide and graphene oxide, potentially making it relevant for a wide variety of systems.
The unique electronic structure found at interfaces between materials can allow unconventional quantum states to emerge. Here we observe superconductivity in electron gases formed at interfaces between (111) oriented KTaO$_3$ and insulating overlayer
s of either EuO or LaAlO$_3$. The superconducting transition temperature, approaching 2.2 K, is about one order of magnitude higher than that of the LaAlO$_3$/SrTiO$_3$ system. Strikingly, similar electron gases at (001) KTaO$_3$ interfaces remain normal down to 25 mK. The critical field and current-voltage measurements indicate that the superconductivity is two dimensional. Higher mobility EuO/KTaO$_3$ (111) samples show a large in-plane anisotropy in transport properties at low temperatures prior to onset of superconductivity, suggesting the emergence of a stripe like phase where the superconductivity is nearly homogeneous in one direction, but strongly modulated in the other.
سجل دخول لتتمكن من نشر تعليقات
التعليقات
جاري جلب التعليقات
سجل دخول لتتمكن من متابعة معايير البحث التي قمت باختيارها
