اشترك بالحزمة الذهبية واحصل على وصول غير محدود شمرا أكاديميا
تسجيل مستخدم جديدBinarized Gerchberg Saxton Algorithm for Hologram Generation Using a Digital Micromirror Device
294
0
0.0
(
0
)
تأليف
Chunde Huang
اسأل ChatGPT حول البحث
ﻻ يوجد ملخص باللغة العربية
In this paper, a modified Gerchberg Saxton algorithm for generating improved robust binary hologram is presented.
قيم البحث
اقرأ أيضاً
For this work, we introduced the use of binary amplitude for our proposed complex amplitude encoding of a phase-only hologram. By principle, a complex amplitude in a hologram plane can be represented by the amplitude and its phase. However, a phase-o
nly hologram contains only phase information of the complex amplitude, which results in degradation of reconstruction quality from the hologram. In our method, by approximating the amplitude in the hologram plane using a binary amplitude, we can finally record the complex amplitude of an original light in the phase-only hologram. We validated the effectiveness of our method with two examples, hologram reconstruction and generation of Hermite-Gaussian beams.
A digital micromirror device (DMD) is an amplitude-type spatial light modulator. However, a complex-amplitude light modulation with a DMD can be achieved using the superpixel scheme. In the superpixel scheme, we notice that multiple different DMD loc
al block patterns may correspond to the same complex superpixel value. Based on this inherent encoding redundancy, a large amount of external data can be embedded into the DMD pattern without extra cost. Meanwhile, the original complex light field information carried by the DMD pattern is fully preserved. This proposed scheme is favorable for applications such as secure information transmission and copyright protection.
Programable spatial light modulators (SLMs) have significantly advanced the configurable optical trapping of particles. Typically, these devices are utilized in the Fourier plane of an optical system, but direct imaging of an amplitude pattern can po
tentially result in increased simplicity and computational speed. Here we demonstrate high-resolution direct imaging of a digital micromirror device (DMD) at high numerical apertures (NA), which we apply to the optical trapping of a Bose-Einstein condensate (BEC). We utilise a (1200 x 1920) pixel DMD and commercially available 0.45 NA microscope objectives, finding that atoms confined in a hybrid optical/magnetic or all-optical potential can be patterned using repulsive blue-detuned (532 nm) light with 630(10) nm full-width at half-maximum (FWHM) resolution, within 5% of the diffraction limit. The result is near arbitrary control of the density the BEC without the need for expensive custom optics. We also introduce the technique of time-averaged DMD potentials, demonstrating the ability to produce multiple grayscale levels with minimal heating of the atomic cloud, by utilising the high switching speed (20 kHz maximum) of the DMD. These techniques will enable the realization and control of diverse optical potentials for superfluid dynamics and atomtronics applications with quantum gases. The performance of this system in a direct imaging configuration has wider application for optical trapping at non-trivial NAs.
Digital hologram rendering can be performed by a convolutional neural network, trained with image pairs calculated by numerical wave propagation from sparse generating images. 512-by-512 pixeldigital Gabor magnitude holograms are successfully estimat
ed from experimental interferograms by a standard UNet trained with 50,000 synthetic image pairs over 70 epochs.
A transverse mode selective laser system with gain regulation by a digital micromirror device (DMD) is presented in this letter. The gain regulation in laser medium is adjusted by the switch of the patterns loaded on DMD. Structured pump beam pattern
s can be obtained after the reflection of the loaded patterns on DMD, and then its defocused into a microchip laser medium by a short focal lens, so that the pump patterns can be transferred to the gain medium to regulate the gain distribution. Corresponding structured laser beams can be generated by this laser system. The laser beam pattern can be regulated easily and quickly, by switching the loaded patterns on DMD. Through this method, we show a simple and flexible laser system to generate on-demand laser beam patterns.
سجل دخول لتتمكن من نشر تعليقات
التعليقات
جاري جلب التعليقات
سجل دخول لتتمكن من متابعة معايير البحث التي قمت باختيارها
