اشترك بالحزمة الذهبية واحصل على وصول غير محدود شمرا أكاديميا
تسجيل مستخدم جديدA compact structure for realizing Lorentzian, Fano and EIT resonance lineshapes in a microring resonator
183
0
0.0
(
0
)
اسأل ChatGPT حول البحث
ﻻ يوجد ملخص باللغة العربية
Microring resonators, as a fundamental building block of photonic integrated circuits, have been well developed into numerous functional devices, whose performances are strongly determined by microrings resonance lineshapes. We propose a compact structure to reliably realize Lorentzian, Fano, and electromagnetically induced transparency (EIT) resonance lineshapes in a microring. By simply inserting two air-holes in the side-coupled waveguide of a microring, a Fabry-Perot (FP) resonance is involved to couple with microrings resonant modes, showing Lorentzian, Fano, and EIT lineshapes over one free spectral range of the FP resonance. The quality factors, extinction ratios, and slope rates in different lineshapes are discussed. At microrings specific resonant wavelength, the lineshape could be tuned among these three types by controlling the FP cavitys length. Experiment results verify the theoretical analysis well and represent Fano lineshapes with extinction ratios of about 20 dB and slope rates over 280 dB/nm. The reliably and flexibly tunable lineshapes in the compact structure have potentials to improve microring-based devices and expand their application scopes.
قيم البحث
اقرأ أيضاً
We propose and demonstrate, by simply inserting an air-hole in the waveguide side-coupling with a microring resonator (MRR), the transmission spectrum presents Fano lineshapes at all of the resonant modes. Measured from the fabricated devices, Fano l
ineshapes with slope rates over 400 dB/nm and extinction ratios over 20 dB are obtained. We ascribe it to the air-hole-induced phase-shift between the discrete resonant modes of the MRR and the continuum propagating mode of the bus-waveguide, which modifies their interference lineshapes from symmetric Lorentzian to asymmetric Fano. From devices with varied locations and diameters of the air-hole, different Fano asymmetric parameters are extracted, verifying the air-hole-induced phase-shifts. This air-hole-assisted waveguide-MRR structure for achieving Fano resonance lineshapes has advantages of simple design, compact footprint, large tolerance of fabrication errors, as well as broadband operation range. It has great potentials to expand and improve performances of on-chip MRR-based devices, including sensors, switchings and filters.
We demonstrate that linear absorption coefficient (LAC) of a graphene-silicon hybrid waveguide (GSHW) is determined by the optical transmission spectra of a graphene coated symmetrically coupled add-drop silicon microring resonator (SC-ADSMR), of whi
ch the value is around 0.23 dB/um. In contrast to the traditional cut-back method, the measured results are not dependent on the coupling efficiency of the fiber tip and the waveguide. Moreover, precision evaluation of graphene coated silicon microring resonator (SMR) is crucial for the optoelectronic devices targeting for compact footprint and low power consumption.
Coupled-resonance spectroscopy has been recently reported and applied for spectroscopic measurements and laser stabilizations. With coupled-resonance spectroscopy, one may indirectly measure some transitions between the excited states that are hard t
o be measured directly because of the lack of populations in the excited states. An improvement of the coupled-resonance spectroscopy by combining the technology of electromagnetically induced transparency (EIT) is proposed. The coupled-resonance spectroscopy signal can be significantly enhanced by EIT. Several experimental schemes have been discussed. The line shape of the EIT-enhanced coupled-resonance spectroscopy has been calculated.The EIT-enhanced coupled-resonance spectroscopy can be used for simultaneously stabilizing two lasers to the same atomic source.
We demonstrate an ultralow loss monolithic integrated lithium niobate photonic platform consisting of dry-etched subwavelength waveguides. We show microring resonators with a quality factor of 10$^7$ and waveguides with propagation loss as low as 2.7 dB/m.
In this letter, we report a method of symmetry-breaking in an artificial Mie-based metamolecule. A Fano resonance with a Q factor of 96 is observed at microwave frequencies in a structure combining a split ring resonator (SRR) and a high-permittivity
dielectric cube. Calculations indicate resonant frequency tunability will result from altering the cubes permittivity. The asymmetric spectrum is attributed to both constructive and destructive near-field interactions between the two distinct resonators. Experimental data and simulation results are in good agreement. The underlying physics is seen in field distribution and dipole analysis. This work substantiates an approach for the manipulation of Mie resonances which can potentially be utilized in light modulating and sensing.
سجل دخول لتتمكن من نشر تعليقات
التعليقات
جاري جلب التعليقات
سجل دخول لتتمكن من متابعة معايير البحث التي قمت باختيارها
