ترغب بنشر مسار تعليمي؟ اضغط هنا

99.992 % $^{28}$Si CVD-grown epilayer on 300 mm substrates for large scale integration of silicon spin qubits

152   0   0.0 ( 0 )
 نشر من قبل Marc Sanquer
 تاريخ النشر 2018
  مجال البحث فيزياء
والبحث باللغة English




اسأل ChatGPT حول البحث

Silicon-based quantum bits with electron spins in quantum dots or nuclear spins on dopants are serious contenders in the race for quantum computation. Added to process integration maturity, the lack of nuclear spins in the most abundant $^{28}$silicon isotope host crystal for qubits is a major asset for this silicon quantum technology. We have grown $^{28}$silicon epitaxial layers (epilayers) with an isotopic purity greater than 99.992 % on 300mm natural abundance silicon crystals. The quality of the mono-crystalline isotopically purified epilayer conforms to the same drastic quality requirements as the natural epilayers used in our pre-industrial CMOS facility. The isotopically purified substrates are now ready for the fabrication of silicon qubits using a state-of-the-art 300 mm Si CMOS-foundries equipment and processes



قيم البحث

اقرأ أيضاً

386 - M. Lesik , T. Plays , A. Tallaire 2015
Thick CVD diamond layers were successfully grown on (113)-oriented substrates. They exhibited smooth surface morphologies and a crystalline quality comparable to (100) electronic grade material, and much better than (111)-grown layers. High growth ra tes (15-50 {mu}m/h) were obtained while nitrogen doping could be achieved in a fairly wide range without seriously imparting crystalline quality. Electron spin resonance measurements were carried out to determine NV centers orientation and concluded that one specific orientation has an occurrence probability of 73 % when (100)-grown layers show an equal distribution in the 4 possible directions. A spin coherence time of around 270 {mu}s was measured which is equivalent to that reported for material with similar isotopic purity. Although a higher degree of preferential orientation was achieved with (111)-grown layers (almost 100 %), the ease of growth and post-processing of the (113) orientation make it a potentially useful material for magnetometry or other quantum mechanical applications.
Czochralski-grown silicon crystals were studied by the techniques of the low-angle mid-IR-light scattering and electron-beam-induced current. The large-scale accumulations of electrically-active impurities detected in this material were found to be d ifferent in their nature and formation mechanisms from the well-known impurity clouds in a FZ-grown silicon. A classification of the large-scale impurity accumulations in CZ Si is made and point centers constituting them are analyzed in this paper. A model of the large-scale impurity accumulations in CZ-grown Si is also proposed. In addition, the images of the large-scale impurity accumulations obtained by means of the scanning mid-IR-laser microscopy are demonstrated.
We report on a flexible 300 mm process that optimally combines optical and electron beam lithography to fabricate silicon spin qubits. It enables on-the-fly layout design modifications while allowing devices with either n- or p-type ohmic implants, a pitch smaller than 100 nm, and uniform critical dimensions down to 30 nm with a standard deviation ~ 1.6 nm. Various n- and p-type qubits are characterized in a dilution refrigerator at temperatures ~ 10 mK. Electrical measurements demonstrate well-defined quantum dots, tunable tunnel couplings, and coherent spin control, which are essential requirements for the implementation of a large-scale quantum processor.
10 nm and 50 nm Co$_{2}$FeAl (CFA) thin films have been deposited on MgO(001) and Si(001) substrates by magnetron sputtering and annealed at different temperatures. X-rays diffraction revealed polycrystalline or epitaxial growth (according to the rel ation CFA(001)[110]//MgO(001)[100] epitaxial relation), respectively for CFA films grown on a Si and on a MgO substrate. For these later, the chemical order varies from the A2 phase to the B2 phase when increasing the annealing temperature (Ta) while only the A2 disorder type has been observed for CFA grown on Si. Microstrip ferromagnetic resonance (MS-FMR) measurements revealed that the in-plane anisotropy results from the superposition of a uniaxial and of a fourfold symmetry term for CFA grown on MgO substrates. This fourfold anisotropy, which disappears completely for samples grown on Si, is in accord with the crystal structure of the samples. The fourfold anisotropy field decreases when increasing Ta while the uniaxial anisotropy field is nearly unaffected by Ta within the investigated range. The MS-FMR data also allow for concluding that the gyromagnetic factor remains constant and that the exchange stiffness constant increases with $T_{a}$. Finally, the FMR linewidth decreases when increasing Ta, due to the enhancement of the chemical order. We derive a very low intrinsic damping parameter (1.3*10^-3 and 1.1*10^-3 for films of 50 nm thickness annealed at 615 {deg}C grown on MgO and on Si, respectively).
Spins in the `semiconductor vacuum of silicon-28 ($^{28}$Si) are suitable qubit candidates due to their long coherence times. An isotopically purified substrate of $^{28}$Si is required to limit the decoherence pathway caused by magnetic perturbation s from surrounding $^{29}$Si nuclear spins (I=1/2), present in natural Si (nat Si) at an abundance of 4.67%. We isotopically enrich surface layers of nat Si by sputtering using high fluence $^{28}$Si$^-$ implantation. Phosphorus (P) donors implanted into one such $^{28}$Si layer with ~3000 ppm $^{29}$Si, produced by implanting 30 keV $^{28}$Si$^-$ ions at a fluence of 4x10^18 cm^-2, were measured with pulsed electron spin resonance, confirming successful donor activation upon annealing. The mono-exponential decay of the Hahn echo signal indicates a depletion of $^{29}$Si. A coherence time of T2 = 285 +/- 14 us is extracted, which is longer than that obtained in nat Si for similar doping concentrations and can be increased by reducing the P concentration in future. The isotopic enrichment was improved by employing one-for-one ion sputtering using 45 keV $^{28}$Si$^-$ implantation. A fluence of 2.63x10^18 cm^-2 $^{28}$Si$^-$ ions were implanted at this energy into nat Si, resulting in an isotopically enriched surface layer ~100 nm thick; suitable for providing a sufficient volume of $^{28}$Si for donor qubits implanted into the near-surface region. We observe a depletion of $^{29}$Si to 250 ppm as measured by secondary ion mass spectrometry. The impurity content and the crystallization kinetics via solid phase epitaxy are discussed. The $^{28}$Si layer is confirmed to be a single crystal using transmission electron microscopy. This method of Si isotopic enrichment shows promise for incorporating into the fabrication process flow of Si spin qubit devices.
التعليقات
جاري جلب التعليقات جاري جلب التعليقات
سجل دخول لتتمكن من متابعة معايير البحث التي قمت باختيارها
mircosoft-partner

هل ترغب بارسال اشعارات عن اخر التحديثات في شمرا-اكاديميا