ترغب بنشر مسار تعليمي؟ اضغط هنا

Electrochemical solid-state amorphization in the immiscible Cu-Li system: Size matters

154   0   0.0 ( 0 )
 نشر من قبل Muhua Sun
 تاريخ النشر 2018
  مجال البحث فيزياء
والبحث باللغة English




اسأل ChatGPT حول البحث

As a typical immiscible binary system, copper (Cu) and lithium (Li) show no alloying and chemical intermixing under normal circumstances. A notable example that takes advantages of the immiscibility between Cu and Li is the widespread utilization of Cu foils as the anodic current collector in Li-ion batteries. Here we show that the nanoscale size effect can play a subtle yet critical role in mediating the chemical activity of Cu and therefore its miscibility with Li, such that the electrochemical alloying and solid-state amorphization will occur in such an immiscible system when decreasing Cu nanoparticle sizes into ultrasmall range. This unusual observation was accomplished by performing in-situ studies of the electrochemical lithiation processes of individual CuO nanowires inside a transmission electron microscopy (TEM). Upon lithiation, CuO nanowires are first electrochemically reduced to form discrete ultrasmall Cu nanocrystals that, unexpectedly, can in turn undergo further electrochemical lithiation to form amorphous CuLix nanoalloys. Real-time dynamic observations by in-situ TEM unveil that there is a critical grain size (ca. 6 nm), below which the crystalline Cu nanoparticles can be continuously lithiated and amorphized. Electron energy loss spectra indicate that there is a net charge transfer from Li to Cu in the amorphous CuLix nanoalloys. Another intriguing finding is that the amorphous alloying phenomena in Cu-Li system is reversible, as manifested by the in-situ observation of electron-beam-induced delithiation of the as-formed amorphous CuLix nanoalloys.



قيم البحث

اقرأ أيضاً

We study the oxo-hexametallate Li$_7$TaO$_6$ with first-principles and classical molecular dynamics simulations, obtaining a low activation barrier for diffusion of $sim$0.29 eV and a high ionic conductivity of $5.7 times 10^{-4}$ S cm$^{-1}$ at room temperature (300 K). We find evidence for a wide electrochemical stability window from both calculations and experiments, suggesting its viable use as a solid-state electrolyte in next-generation solid-state Li-ion batteries. To assess its applicability in an electrochemical energy storage system, we performed electrochemical impedance spectroscopy measurements on multicrystalline pellets, finding substantial ionic conductivity, if below the values predicted from simulation. We further elucidate the relationship between synthesis conditions and the observed ionic conductivity using X-ray diffraction, inductively coupled plasma optical emission spectrometry, and X-ray photoelectron spectroscopy, and study the effects of Zr and Mo doping.
Solid-state batteries (SSBs) can offer a paradigm shift in battery safety and energy density. Yet, the promise hinges on the ability to integrate high-performance electrodes with state-of-the-art solid electrolytes. For example, lithium (Li) metal, t he most energy-dense anode candidate, suffers from severe interfacial chemomechanical issues that lead to cell failure. Li alloys of In/Sn are attractive alternatives, but their exploration has mostly been limited to the low capacity(low Li content)and In rich Li$_x$In (x$leq$0.5). Here, the fundamental electro-chemo-mechanical behavior of Li-In and Li-Sn alloys of varied Li stoichiometries is unravelled in sulfide electrolyte based SSBs. The intermetallic electrodes developed through a controlled synthesis and fabrication technique display impressive (electro)chemical stability with Li$_6$PS$_5$Cl as the solid electrolyte and maintain nearly perfect interfacial contact during the electrochemical Li insertion/deinsertion under an optimal stack pressure. Their intriguing variation in the Li migration barrier with composition and its influence on the observed Li cycling overpotential is revealed through combined computational and electrochemical studies. Stable interfacial chemomechanics of the alloys allow long-term dendrite free Li cycling (>1000 h) at relatively high current densities (1 mA cm$^{-2}$) and capacities (1 mAh cm$^{-2}$), as demonstrated for Li$_{13}$In$_3$ and Li$_{17}$Sn$_4$, which are more desirable from a capacity and cost consideration compared to the low Li content analogues. The presented understanding can guide the development of high-capacity Li-In/Sn alloy anodes for SSBs.
137 - Mingcheng Yang , Hongru Ma 2008
The solid-solid coexistence of a polydisperse hard sphere system is studied by using the Monte Carlo simulation. The results show that for large enough polydispersity the solid-solid coexistence state is more stable than the single-phase solid. The t wo coexisting solids have different composition distributions but the same crystal structure. Moreover, there is evidence that the solid-solid transition terminates in a critical point as in the case of the fluid-fluid transition.
Oxygen activity and surface stability are two key parameters in the search for advanced materials for intermediate temperature solid oxide electrochemical cells, as overall device performance depends critically on them. In particular $in$ $situ$ and $operando$ characterisation techniques have accelerated the understanding of degradation processes and the identification of active sites, motivating the design and synthesis of improved, nanoengineered materials. In this short topical review we report on the latest developments of various sophisticated $in$ $situ$ and $operando$ characterization techniques, including Transmission and Scanning Electron Microscopy (TEM and SEM), surface-enhanced Raman spectroscopy (SERS), Electrochemical Impedance Spectroscopy (EIS), X-ray Diffraction (XRD) and synchrotron based X-ray photoelectron spectroscopy (XPS) and X-ray absorption spectroscopy (XAS), among others. We focus on their use in three emerging topics, namely: (i) the analysis of general electrochemical reactions and the surface defect chemistry of electrode materials; (ii) the evolution of electrode surfaces achieved by nanoparticle exsolution for enhanced oxygen activity and (iii) the study of surface degradation caused by Sr segregation, leading to reduced durability. For each of these topics we highlight the most remarkable examples recently published. We anticipate that ongoing improvements in the characterisation techniques and especially a complementary use of them by multimodal approaches will lead to improved knowledge of $operando$ processes, hence allowing a significant advancement in cell performance in the near future.
In the Al-Co-Cu alloy system, both the decagonal quasicrystal with the space group of $Poverline{10}m2$ and its approximant Al$_{13}$Co$_4$ phase with monoclinic $Cm$ symmetry are present around 20 at.% Co-10 at.% Cu. In this study, we examined the c rystallographic features of prepared Al-(30-x) at.% Co-x at.% Cu samples mainly by transmission electron microscopy in order to make clear the crystallographic relation between the decagonal quasicrystal and the monoclinic Al$_{13}$Co$_4$ structure. The results revealed a coexistence state consisting of decagonal quasicrystal and approximant Al$_{13}$Co$_4$ regions in Al-20 at.% Co-10 at.% Cu alloy samples. With the help of the coexistence state, the orientation relationship was established between the monoclinic Al$_{13}$Co$_4$ structure and the decagonal quasicrystal. In the determined relationship, the crystallographic axis in the quasicrystal was found to be parallel to the normal direction of the (010)$_{rm m}$ plane in the Al$_{13}$Co$_4$ structure, where the subscript m denotes the monoclinic system. Based on data obtained experimentally, the state stability of the decagonal quasicrystal was also examined in terms of the Hume-Rothery (HR) mechanism on the basis of the nearly-free-electron approximation. It was found that a model based on the HR mechanism could explain the crystallographic features such as electron diffraction patterns and atomic arrangements found in the decagonal quasicrystal. In other words, the HR mechanism is most likely appropriate for the stability of the decagonal quasicrystal in the Al-Co-Cu alloy system.
التعليقات
جاري جلب التعليقات جاري جلب التعليقات
سجل دخول لتتمكن من متابعة معايير البحث التي قمت باختيارها
mircosoft-partner

هل ترغب بارسال اشعارات عن اخر التحديثات في شمرا-اكاديميا