اشترك بالحزمة الذهبية واحصل على وصول غير محدود شمرا أكاديميا
تسجيل مستخدم جديدFabrication and properties of luminescence polymer composites with erbium/ytterbium oxides and gold nanoparticles
58
0
0.0
(
0
)
اسأل ChatGPT حول البحث
ﻻ يوجد ملخص باللغة العربية
Rare-earth-doped optical materials are important for light sources in optoelectronics, as well as for efficient optical amplification elements and other elements of photonics. On the basis of the previously developed method of anhydrous, low-temperature synthesis of Er/Yb oxides from their chlorides we fabricated proper nanoparticles with defined parameters and used them for the development of optically transparent, luminescent polymer nanocomposite with low optical scattering, suitable for direct, light-induced formation of photonic elements. Introduction of preformed gold nanoparticles in such a nanocomposite was also performed and an enhancement of luminescence due to the influence of plasmon effects was detected.
قيم البحث
اقرأ أيضاً
We aim at combining high coercivity magnetic nanowires in a polymer matrix in a view to fabricate rare--earth free bonded magnets. In particular, our aim is to fabricate anisotropic materials by aligning the wires in the polymer matrix. We have explo
red the different parameters of the fabrication process in order to produce a material with the best possible magnetic properties. We show that the choice of a proper solvent allows obtaining stable nanowire suspensions. The length and the type of the polymer chains play also an important role. Smaller chains ($M_w < 10000$) provide better magnetization results. The magnetic field applied during the casting of the material plays also a role and should be of the order of a fraction of a tesla. The local order of the nanowires in the matrix has been characterized by TEM and Small Angle Neutron Scattering. The correlation between the local order of the wires and the magnetic properties is discussed. Materials with coercivity $mu_0 H_c$ up to 0.70 $T$ at room temperature have been obtained.
102 -
N.I. Matskevich
, E.V. Korotaev (Nikolaev Institute of Inorganicn Chemistry SB RAS
, Novosibirsk
2015
We synthesized bismuth - cobalt oxide doped by erbium with general formula Bi3-xErxCoO3-y. Compound has structure of delta-form bismuth oxide. Magnetic properties of the compound were measured by Faradays method using quartz scales in the temperature
range of 80-500 K. The magnetic susceptibility and effective magnetic moment were calculated.
In the field of atomically thin 2D materials, oxides are relatively unexplored in spite of the large number of layered oxide structures amenable to exfoliation. There is an increasing interest in ultra-thin film oxide nanostructures from applied poin
ts of view. In this perspective paper, recent progress in understanding the fundamental properties of 2D oxides is discussed. Two families of 2D oxides are considered: (1) van der Waals bonded layered materials in which the transition metal is in its highest valence state (represented by V$_2$O$_5$ and MoO$_3$) and (2) layered materials with ionic bonding between positive alkali cation layers and negatively charged transition metal oxide layers (LiCoO$_2$). The chemical exfoliation process and its combinaton with mechanical exfoliation are presented for the latter. Structural phase stability of the resulting nanoflakes, the role of cation size and the importance of defects in oxides are discussed. Effects of two-dimensionality on phonons, electronic band structures and electronic screening are placed in the context of what is known on other 2D materials, such as transition metal dichalcogenides. Electronic structure is discussed at the level of many-body-perturbation theory using the quasiparticle self-consistent $GW$ method, the accuracy of which is critically evaluated including effects of electron-hole interactions on screening and electron-phonon coupling. The predicted occurence of a two-dimensional electron gas on Li covered surfaces of LiCoO$_2$ and its relation to topological aspects of the band structure and bonding is presented as an example of the essential role of the surface in ultrathin materials. Finally, some case studies of the electronic transport and the use of these oxides in nanoscale field effect transistors are presented.
We generalize and systematize basic experimental data on optical and luminescence properties of ZnO single crystals, thin films, powders, ceramics, and nanocrystals. We consider and study mechanisms by which two main emission bands occur, a short-wav
elength band near the fundamental absorption edge and a broad long-wavelength band, the maximum of which usually lies in the green spectral range. We determine a relationship between the two luminescence bands and study in detail the possibility of controlling the characteristics of ZnO by varying the maximum position of the short-wavelength band. We show that the optical and luminescence characteristics of ZnO largely depend on the choice of the corresponding impurity and the parameters of the synthesis and subsequent treatment of the sample. Prospects for using zinc oxide as a scintillator material are discussed. Additionally, we consider experimental results that are of principal interest for practice.
Polymer assisted spherical FeNi nanoparticles were prepared via wet chemical method using hydrazine as a reducing agent and polymers (PVP and PEG) as reducing and stabilizing agent. Structural studies performed using XRD and TEM shows uniform dispers
ion of fine FeNi nanocrystallites in nanocomposite particles. The size and thermal stability of FeNi nanoparticles prepared under same reaction condition was found to be dependent on the type and the molecular weight of the polymer used. However, the magnetic properties of nanocomposite particles were not influenced by the polymers. The study highlights subtle differences in using polymers during the synthesis of alloyed nanocomposite particles.
سجل دخول لتتمكن من نشر تعليقات
التعليقات
جاري جلب التعليقات
سجل دخول لتتمكن من متابعة معايير البحث التي قمت باختيارها
