اشترك بالحزمة الذهبية واحصل على وصول غير محدود شمرا أكاديميا
تسجيل مستخدم جديدExcitonic properties of semiconducting monolayer and bilayer MoTe2
223
0
0.0
(
0
)
اسأل ChatGPT حول البحث
ﻻ يوجد ملخص باللغة العربية
MoTe2 belongs to the semiconducting transition metal dichalcogenide family with some properties differing from the other well-studied members (Mo,W)(S,Se)2. The optical band gap is in the near infrared region and both monolayers and bilayers may have a direct optical band gap. We first simulate the band structure of both monolayer and bilayer MoTe2 with DFT-GW calculations. We find a direct (indirect) electronic band gap for the monolayer (bilayer). By solving the Bethe-Salpeter equation, we calculate similar energies for the direct excitonic states in monolayer and bilayer. We then study the optical properties by means of photoluminescence (PL) excitation, time-resolved PL and power dependent PL spectroscopy. We identify the same energy for the B exciton state in monolayer and bilayer. Following circularly polarized excitation, we do not find any exciton polarization for a large range of excitation energies. At low temperature (T=10 K), we measure similar PL decay times of the order of 4 ps for both monolayer and bilayer excitons with a slightly longer one for the bilayer. Finally, we observe a reduction of the exciton-exciton annihilation contribution to the non-radiative recombination in bilayer.
قيم البحث
اقرأ أيضاً
Anisotropic materials, with orientation-dependent properties, have attracted more and more attention due to their compelling tunable and flexible performance in electronic and optomechanical devices. So far, two-dimensional (2D) black phosphorus show
s the largest known anisotropic behavior, which is highly desired for synaptic and neuromorphic devices, multifunctional directional memories, and even polarization-sensitive photodetector, whereas it is unstable at ambient conditions. Recently, 2D few-layered As2S3 with superior chemical stability was successfully exfoliated in experiments. However, the electronic and mechanical properties of monolayer and bilayer As2S3 is still lacking. Here, we report the large anisotropic electronic and mechanical properties of As2S3 systems through first-principles calculations and general angle-dependent Hookes law. Monolayer and bilayer As2S3 exhibit anisotropic factors of Youngs modulus of 3.15 and 3.32, respectively, which are larger than the black phosphorous with experimentally confirmed and an anisotropic factor of 2. This study provides an effective route to flexible orientation-dependent nanoelectronics, nanomechanics, and offers implications in promoting related experimental investigations.
The recent advent of two-dimensional monolayer materials with tunable optoelectronic properties and high carrier mobility offers renewed opportunities for efficient, ultra-thin excitonic solar cells alternative to those based on conjugated polymer an
d small molecule donors. Using first-principles density functional theory and many-body calculations, we demonstrate that monolayers of hexagonal BN and graphene (CBN) combined with commonly used acceptors such as PCBM fullerene or semiconducting carbon nanotubes can provide excitonic solar cells with tunable absorber gap, donor-acceptor interface band alignment, and power conversion efficiency, as well as novel device architectures. For the case of CBN-PCBM devices, we predict the limit of power conversion efficiencies to be in the 10 - 20% range depending on the CBN monolayer structure. Our results demonstrate the possibility of using monolayer materials in tunable, efficient, polymer-free thin-film solar cells in which unexplored exciton and carrier transport regimes are at play.
The recent demonstration of saturable absorption and negative optical conductivity in the Terahertz range in graphene has opened up new opportunities for optoelectronic applications based on this and other low dimensional materials. Recently, populat
ion inversion across the Dirac point has been observed directly by time- and angle-resolved photoemission spectroscopy (tr-ARPES), revealing a relaxation time of only ~ 130 femtoseconds. This severely limits the applicability of single layer graphene to, for example, Terahertz light amplification. Here we use tr-ARPES to demonstrate long-lived population inversion in bilayer graphene. The effect is attributed to the small band gap found in this compound. We propose a microscopic model for these observations and speculate that an enhancement of both the pump photon energy and the pump fluence may further increase this lifetime.
Atomically thin transition metal dichalcogenides (TMDs) are direct-gap semiconductors with strong light-matter and Coulomb interaction. The latter accounts for tightly bound excitons, which dominate the optical properties of these technologically pro
mising materials. Besides the optically accessible bright excitons, these systems exhibit a variety of dark excitonic states. They are not visible in optical spectra, but can strongly influence the coherence lifetime and the linewidth of the emission from bright exciton states. In a recent study, an experimental evidence for the existence of such dark states has been demonstrated, as well as their strong impact on the quantum efficiency of light emission in TMDs. Here, we reveal the microscopic origin of the excitonic coherence lifetime in two representative TMD materials (WS$_2$ and MoSe$_2$) within a joint study combining microscopic theory with optical experiments. We show that the excitonic coherence lifetime is determined by phonon-induced intra- and intervalley scattering into dark excitonic states. Remarkably, and in accordance with the theoretical prediction, we find an efficient exciton relaxation in WS$_2$ through phonon emission at all temperatures.
Low temperature (<400 K) thermoelectric properties of semiconducting RuIn3 and metallic IrIn3 are reported. RuIn3 is a narrow band gap semiconductor with a large n-type Seebeck coefficient at room temperature (S(290K)~400 {mu}V/K), but the thermoelec
tric Figure of merit (ZT(290K) = 0.007) is small because of high electrical resistivity and thermal conductivity ({kappa}(290 K) ~ 2.0 W/m K). IrIn3 is a metal with low thermopower at room temperature (S(290K)~20 {mu}V/K) . Iridium substitution on the ruthenium site has a dramatic effect on transport properties, which leads to a large improvement in the power factor and corresponding Figure of merit (ZT(380 K) = 0.053), improving the efficiency of the material by an over of magnitude.
سجل دخول لتتمكن من نشر تعليقات
التعليقات
جاري جلب التعليقات
سجل دخول لتتمكن من متابعة معايير البحث التي قمت باختيارها
