ترغب بنشر مسار تعليمي؟ اضغط هنا

Thermoelectric Properties of Intermetallic Semiconducting RuIn3 and Metallic IrIn3

56   0   0.0 ( 0 )
 نشر من قبل Neel Haldolaarachchige
 تاريخ النشر 2013
  مجال البحث فيزياء
والبحث باللغة English




اسأل ChatGPT حول البحث

Low temperature (<400 K) thermoelectric properties of semiconducting RuIn3 and metallic IrIn3 are reported. RuIn3 is a narrow band gap semiconductor with a large n-type Seebeck coefficient at room temperature (S(290K)~400 {mu}V/K), but the thermoelectric Figure of merit (ZT(290K) = 0.007) is small because of high electrical resistivity and thermal conductivity ({kappa}(290 K) ~ 2.0 W/m K). IrIn3 is a metal with low thermopower at room temperature (S(290K)~20 {mu}V/K) . Iridium substitution on the ruthenium site has a dramatic effect on transport properties, which leads to a large improvement in the power factor and corresponding Figure of merit (ZT(380 K) = 0.053), improving the efficiency of the material by an over of magnitude.

قيم البحث

اقرأ أيضاً

222 - C. Robert , R. Picard , D. Lagarde 2016
MoTe2 belongs to the semiconducting transition metal dichalcogenide family with some properties differing from the other well-studied members (Mo,W)(S,Se)2. The optical band gap is in the near infrared region and both monolayers and bilayers may have a direct optical band gap. We first simulate the band structure of both monolayer and bilayer MoTe2 with DFT-GW calculations. We find a direct (indirect) electronic band gap for the monolayer (bilayer). By solving the Bethe-Salpeter equation, we calculate similar energies for the direct excitonic states in monolayer and bilayer. We then study the optical properties by means of photoluminescence (PL) excitation, time-resolved PL and power dependent PL spectroscopy. We identify the same energy for the B exciton state in monolayer and bilayer. Following circularly polarized excitation, we do not find any exciton polarization for a large range of excitation energies. At low temperature (T=10 K), we measure similar PL decay times of the order of 4 ps for both monolayer and bilayer excitons with a slightly longer one for the bilayer. Finally, we observe a reduction of the exciton-exciton annihilation contribution to the non-radiative recombination in bilayer.
Structural transformation between metallic (1T) and semiconducting (2H) phases of single-layered MoS2 was systematically investigated by an in situ STEM with atomic precision. The 1T/2H phase transition is comprised of S and/or Mo atomic-plane glides , and requires an intermediate phase ({alpha}-phase) as an indispensable precursor. Migration of two kinds of boundaries ({beta} and {gamma}-boundaries) is also found to be responsible for the growth of the second phase. The 1T phase can be intentionally introduced in the 2H matrix by using a high dose of incident electron beam during heating the MoS2 single-layers up to 400~700{deg}C in high vacuum and indeed controllable in size. This work may lead to the possible fabrication of composite nano-devices made of local domains with distinct electronic properties.
We present an investigation of the thermoelectric properties of cubic perovskite SrTiO3. The results are derived from a combination of calculated transport functions obtained from Boltzmann transport theory in the constant scattering time approximati on based on the electronic structure and existing experimental data for La-doped SrTiO3. The figure of merit ZT is modeled with respect to carrier concentration and temperature. The model predicts a relatively high $ZT$ at optimized doping, and suggests that the $ZT$ value can reach 0.7 at T = 1400 K. Thus $ZT$ can be improved from the current experimental values by carrier concentration optimization.
A suite measurements of the electrical, thermal, and vibrational properties are conducted on palladium sulfide (PdS) in order to investigate its thermoelectric performance. The tetragonal structure with the space group $P$42/$m$ for PdS is determined from X-ray diffraction measurement. The unique temperature dependence of mobility suggests that acoustic phonons and ion impurity scattering are two dominant scattering mechanisms within the compound. The obtained power factor of $27$ $mu$Wcm$^{-1}$K$^{-2}$ at 800 K is the largest value in the remaining transition-metal sulfides studied so far. The maximum value of the dimensionless figure of merit is 0.33 at 800 K. The observed phonon softening with temperature indicates that the reduction of the lattice thermal conductivity is mainly controlled by the enhanced lattice anharmonicity. These results indicate that the binary bulk PdS has promising potential to have good thermoelectrical performance.
Bismuth oxyselenide (Bi$_2$O$_2$Se) attracts great interest as a potential n-type complement to p-type thermoelectric oxides in practical applications. Previous investigations were generally focused on polycrystals. Here, we performed a study on the thermoelectric properties of Bi$_2$O$_2$Se single crystals. Our samples exhibit electron mobility as high as 250 cm$^2.$V$^{-1}$.s$^{-1}$ and thermal conductivity as low as $2$ W.m$^{-1}$.K$^{-1}$ near room temperature. The maximized figure of merit is yielded to be 0.188 at 390 K, higher than that of polycrystals. Consequently, a rough estimation of the phonon mean free path ($ell_textrm{ph}$) from the kinetic model amounts to 12 $r{A}$ at 390 K and follows a $T^{-1}$ behavior. An extrapolation of $ell_textrm{ph}$ to higher temperatures indicates that this system approaches the Ioffe-Regel limit at about 1100 K. In light of the phonon dispersions, we argue that the ultralow $ell_textrm{ph}$ is attributed to intense anharmonic phonon-phonon scattering, including Umklapp process and acoustic to optical phonon scattering. Our results suggest that single crystals provide a further improvement of thermoelectric performance of Bi$_2$O$_2$Se.
التعليقات
جاري جلب التعليقات جاري جلب التعليقات
سجل دخول لتتمكن من متابعة معايير البحث التي قمت باختيارها
mircosoft-partner

هل ترغب بارسال اشعارات عن اخر التحديثات في شمرا-اكاديميا