اشترك بالحزمة الذهبية واحصل على وصول غير محدود شمرا أكاديميا
تسجيل مستخدم جديدAdvanced broad-band solid-state supermirror polarizers for cold neutrons
262
0
0.0
(
0
)
اسأل ChatGPT حول البحث
ﻻ يوجد ملخص باللغة العربية
An ideal solid-state supermirror (SM) neutron polarizer assumes total reflection of neutrons from the SM coating for one spin-component and total absorption for the other, thus providing a perfectly polarized neutron beam at the exit. However, in practice, the substrates neutron-nucleai optical potential does not match perfectly that for spin-down neutrons in the SM. For a positive step in the optical potential (as in a Fe/SiN(x) SM on Si substrate), this mismatch results in spin-independent total reflection for neutrons with small momentum transfer Q, limiting the useful neutron bandwidth in the low-Q region. To overcome this limitation, we propose to replace Si single-crystal substrates by media with higher optical potential than that for spin-down neutrons in the SM ferromagnetic layers. We found single-crystal sapphire and single-crystal quartz as good candidates for solid-state Fe/SiN(x) SM polarizers. To verify this idea, we coated a thick plate of single-crystal sapphire with a m=2.4 Fe/SiN(x) SM. At the T3 instrument at the ILL, we measured the spin-up and spin-down reflectivity curves with 7.5 A neutrons incident from the substrate to the interface between the substrate and the SM coating. The results of this experimental test were in excellent agreement with our expectations: the bandwidth of high polarizing power extended significantly into the low-Q region. This finding, together with the possibility to apply a strong magnetizing field, opens a new road to produce high-efficient solid-state SM polarizers with an extended neutron wavelength bandwidth and near-to-perfect polarizing power.
قيم البحث
اقرأ أيضاً
Among Super-Mirror (SM) polarizers, solid-state devices have many advantages. The most relevant is 5-10 times smaller length compared to air-gap polarizers allowing to apply stronger magnetic fields. An important condition for a good SM polarizer is
the matching of the substrate SLD (Scattering Length Density) with the SM coating SLD for spin-down neutrons. For traditional Fe/Si SM on Si substrate, this SLD step is positive when a neutron goes from the substrate to the SM, which leads to a significant loss of the polarizer performance at small Q. Instead, we use single-crystal Sapphire/Quartz substrates. The latter show a negative SLD step for spin-down neutrons at the interface with Fe and, therefore, avoid the total reflection regime at small Q. To optimize the polarizer performance, we formulate the concept of Sapphire V-bender, perform ray-tracing simulations of Sapphire V-bender, compare results with those for traditional C-bender on Si, and study experimentally V-bender prototypes with different substrates. Our results show that the choice of substrate material, polarizer geometry and the strength and quality of magnetizing field have dramatic effect. In particular, we compare the performance of polarizer for the applied magnetic field strength of $50 mT$ and $300 mT$. Only the large field strength provides an excellent agreement between the simulated and measured polarization values. For the double-collision configuration, a record polarization $>0.999$ was obtained in the neutron wavelength band of $0.3-1.2 nm$ with only $1%$ decrease at $2 nm$. Without any collimation, the polarization averaged over the full outgoing capture spectrum, $0.997$, was found to be equal to the value obtained previously only using a double polarizer in the crossed (X-SM) geometry. These results are applied in a full-scale polarizer for the PF1B instrument.
This work presents selected results from the first round of the DFG Priority Programme SPP 1491 precision experiments in particle and astroparticle physics with cold and ultra-cold neutrons.
A pixel detector with high spatial resolution and temporal information for ultra-cold neutrons is developed based on a commercial CCD on which a neutron converter is attached. 10B and 6Li are tested for the neutron converter and 10B is found to be mo
re suitable based on efficiency and spatial resolution. The pixel detector has an efficiency of 44.1 +- 1.1% and a spatial resolution of 2.9 +- 0.1 um (1 sigma).
For holographic gratings recorded in superparamagnetic nanoparticle-polymer composites the diffraction efficiency should -- next to grating spacing, nanoparticle concentration and grating thickness -- depend on the strength of an external magnetic fi
eld and the incident neutron spin state. As a consequence, diffraction gratings should be tunable to act as mirrors for one spin state, while being essentially transparent for the other. Thus, polarizing beam splitters for cold neutrons become feasible.
We developed an optical device for ultra-cold neutrons and investigated the influence of a tilt of its guiding components. A measurement of the time-of-flight of the neutrons through the device by means of a dedicated chopper system was performed and
a light-optical method for the alignment of the guiding components is demonstrated. A comparative analysis of former experiments with our results shows the potential of such a device to test the electrical neutrality of the free neutron on the $10^{-22} q_{rm e}$ level and to investigate the interaction of neutrons with gravity.
سجل دخول لتتمكن من نشر تعليقات
التعليقات
جاري جلب التعليقات
سجل دخول لتتمكن من متابعة معايير البحث التي قمت باختيارها
