اشترك بالحزمة الذهبية واحصل على وصول غير محدود شمرا أكاديميا
تسجيل مستخدم جديدThe dust sublimation radius as an outer envelope to the bulk of the narrow Fe Kalpha line emission in Type 1 AGN
472
0
0.0
(
0
)
اسأل ChatGPT حول البحث
ﻻ يوجد ملخص باللغة العربية
The Fe Kalpha emission line is the most ubiquitous feature in the X-ray spectra of active galactic nuclei (AGN), but the origin of its narrow core remains uncertain. Here, we investigate the connection between the sizes of the Fe core emission regions and the measured sizes of the dusty tori in 13 local Type 1 AGN. The observed Fe K emission radii (R_fe) are determined from spectrally resolved line widths in X-ray grating spectra, and the dust sublimation radii (R_dust) are measured either from optical/near-infrared reverberation time lags or from resolved near-infrared interferometric data. This direct comparison shows, on an object-by-object basis, that the dust sublimation radius forms an outer envelope to the bulk of the Fe K emission. R_fe matches R_dust well in the AGN with the best constrained line widths currently. In a significant fraction of objects without a clear narrow line core, R_fe is similar to, or smaller than the radius of the optical broad line region. These facts place important constraints on the torus geometries for our sample. Extended tori in which the solid angle of fluorescing gas peaks at well beyond the dust sublimation radius can be ruled out. We also test for luminosity scalings of R_fe, finding that Eddington ratio is not a prime driver in determining the line location in our sample. We discuss in detail potential caveats due to data analysis and instrumental limitations, simplistic line modeling, uncertain black hole masses, as well as sample selection, showing that none of these is likely to bias our core result. The calorimeter on board Astro-H will soon vastly increase the parameter space over which line measurements can be made, overcoming many of these limitations.
قيم البحث
اقرأ أيضاً
Recently, Gandhi, Honig, and Kishimoto submitted a manuscript to the arXiv e-print service on the location of the emitting region of the narrow FeK$alpha $ line that appears in the X-ray spectra of active galactic nuclei (AGNs) compared with the inne
r radius of the dust torus (arXiv:1502.02661). Prior to their manuscript, a similar discussion had already been presented in a section of Minezaki & Matsushita (2015), which had been accepted for publication in the Astrophysical Journal. Because Gandhi et al. made no reference to Minezaki & Matsushita (2015) apart from improperly citing it merely as an application of the dust reverberation of AGNs, we present a brief comparison of both papers. Gandhi et al. compared the location of the FeK$alpha$ emitting region with the individually measured radius of the dust torus for type 1 AGNs, whereas Minezaki & Matsushita (2015) examined it based on the scaling relation of the dust reverberation radius for both type 1 and type 2 AGNs. Nevertheless, Gandhi et als main result is basically consistent with and supports the results of Minezaki & Matsushita (2015).
The absolute luminosity of the Fe Kalpha emission line from matter illuminated by X-rays in astrophysical sources is nontrivial to calculate except when the line-emitting medium is optically-thin to absorption and scattering. We characterize the Fe K
alpha line flux using a dimensionless efficiency, defined as the fraction of continuum photons above the Fe K shell absorption edge threshold energy that appear in the line. The optically-thin approximation begins to break down even for column densities as small as 2 x 10^22 cm^-2. We show how to obtain reliable estimates of the Fe Kalpha line efficiency in the case of cold, neutral matter, even for the Compton-thick regime. We find that, regardless of geometry and covering factor, the largest Fe Kalpha line efficiency is attained well before the medium becomes Compton-thick. For cosmic elemental abundances it is difficult to achieve an efficiency higher than a few percent under the most favorable conditions and lines of sight. For a given geometry, Compton-thick lines-of-sight may have Fe Kalpha line efficiencies that are orders of magnitude less than the maximum possible for that geometry. Configurations that allow unobscured views of a Compton-thick reflecting surface are capable of yielding the highest efficiencies. Our results can be used to estimate the predicted flux of the narrow Fe Kalpha line at ~6.4 keV from absorption models in AGN. In particular we show that contrary to a recent claim in the literature, absorption dominated models for the relativistic Fe Kalpha emission line in MCG -6-30-15 do not over-predict the narrow Fe Kalpha line for any column density or covering factor.
We present new, high signal-to-noise ratio results from a Monte Carlo study of the properties of the Compton shoulder of the Fe Kalpha emission line in the toroidal X-ray reprocessor model of Murphy & Yaqoob (2009, MNRAS, 397, 1549). The model compre
hensively covers the Compton-thin to Compton-thick regimes and we find that the variety of Compton shoulder profiles is greater than that for both (centrally-illuminated) spherical and disk geometries. Our Monte Carlo simulations were done with a statistical accuracy that is high enough to reveal, for the case of an edge-on, Compton-thick torus, a new type of Compton shoulder that is not present in the spherical or disk geometries. Such a Compton shoulder is dominated by a narrow back-scattering feature at ~6.24 keV. Our results also reveal a dependence of the shape of the Compton shoulder (and its magnitude relative to the Fe Kalpha line core) on the spectral shape of the incident X-ray continuum. We also show the effects of velocity broadening on the Fe Kalpha line profile and find that if either the velocity width or instrument resolution is greater than a FWHM of ~2000 km/s, the Compton shoulder begins to become blended with the line core and the characteristic features of the Compton shoulder become harder to resolve. In particular, at a FWHM of ~7000 km/s the Compton shoulder is NOT resolved at all, its only signature being a weak asymmetry in the blended line profile. Thus, CCD X-ray detectors cannot unambiguously resolve the Compton shoulder. Our results are freely available in a format that is suitable for direct spectral-fitting of the continuum and line model to real data.
In 2016 we carried out a Swift monitoring program to track the X-ray hardness variability of eight type-I AGN over a year. The purpose of this monitoring was to find intense obscuration events in AGN, and thereby study them by triggering joint XMM-Ne
wton, NuSTAR, and HST observations. We successfully accomplished this for NGC 3783 in December 2016. We found heavy X-ray absorption produced by an obscuring outflow in this AGN. As a result of this obscuration, interesting absorption features appear in the UV and X-ray spectra, which are not present in the previous epochs. Namely, the obscuration produces broad and blue-shifted UV absorption lines of Ly$alpha$, C IV, and N V, together with a new high-ionisation component producing Fe XXV and Fe XXVI absorption lines. In soft X-rays, only narrow emission lines stand out above the diminished continuum as they are not absorbed by the obscurer. Our analysis shows that the obscurer partially covers the central source with a column density of few $10^{23}$ cm$^{-2}$, outflowing with a velocity of few thousand km s$^{-1}$. The obscuration in NGC 3783 is variable and lasts for about a month. Unlike the commonly-seen warm-absorber winds at pc-scale distances from the black hole, the eclipsing wind in NGC 3783 is located at about 10 light days. Our results suggest the obscuration is produced by an inhomogeneous and clumpy medium, consistent with clouds in the base of a radiatively-driven disk wind at the outer broad-line region of the AGN.
The recent detection of X-ray reverberation lags, especially in the Fe Kalpha line region, around Active Galactic Nuclei (AGN) has opened up the possibility of studying the time-resolved response (reflection) of hard X-rays from the accretion disk ar
ound supermassive black holes. Here, we use general relativistic transfer functions for reflection of X-rays from a point source located at some height above the black hole to study the time lags expected as a function of frequency and energy in the Fe Kalpha line region. We explore the models and the dependence of the lags on key parameters such as the height of the X-ray source, accretion disk inclination, black hole spin and black hole mass. We then compare these models with the observed frequency and energy dependence of the Fe Kalpha line lag in NGC 4151. Assuming the optical reverberation mapping mass of $4.6times10^7~M_odot$ we get a best fit to the lag profile across the Fe Kalpha line in the frequency range $(1-2)times10^{-5}$ Hz for an X-ray source located at a height $h = 7^{+2.9}_{-2.6}~R_G$ with a maximally spinning black hole and an inclination $i < 30^circ$.
سجل دخول لتتمكن من نشر تعليقات
التعليقات
جاري جلب التعليقات
سجل دخول لتتمكن من متابعة معايير البحث التي قمت باختيارها
