اشترك بالحزمة الذهبية واحصل على وصول غير محدود شمرا أكاديميا
تسجيل مستخدم جديدOn the efficiency of production of the Fe Kalpha emission line in neutral matter
200
0
0.0
(
0
)
تأليف
T. Yaqoob
اسأل ChatGPT حول البحث
ﻻ يوجد ملخص باللغة العربية
The absolute luminosity of the Fe Kalpha emission line from matter illuminated by X-rays in astrophysical sources is nontrivial to calculate except when the line-emitting medium is optically-thin to absorption and scattering. We characterize the Fe Kalpha line flux using a dimensionless efficiency, defined as the fraction of continuum photons above the Fe K shell absorption edge threshold energy that appear in the line. The optically-thin approximation begins to break down even for column densities as small as 2 x 10^22 cm^-2. We show how to obtain reliable estimates of the Fe Kalpha line efficiency in the case of cold, neutral matter, even for the Compton-thick regime. We find that, regardless of geometry and covering factor, the largest Fe Kalpha line efficiency is attained well before the medium becomes Compton-thick. For cosmic elemental abundances it is difficult to achieve an efficiency higher than a few percent under the most favorable conditions and lines of sight. For a given geometry, Compton-thick lines-of-sight may have Fe Kalpha line efficiencies that are orders of magnitude less than the maximum possible for that geometry. Configurations that allow unobscured views of a Compton-thick reflecting surface are capable of yielding the highest efficiencies. Our results can be used to estimate the predicted flux of the narrow Fe Kalpha line at ~6.4 keV from absorption models in AGN. In particular we show that contrary to a recent claim in the literature, absorption dominated models for the relativistic Fe Kalpha emission line in MCG -6-30-15 do not over-predict the narrow Fe Kalpha line for any column density or covering factor.
قيم البحث
اقرأ أيضاً
We present new, high signal-to-noise ratio results from a Monte Carlo study of the properties of the Compton shoulder of the Fe Kalpha emission line in the toroidal X-ray reprocessor model of Murphy & Yaqoob (2009, MNRAS, 397, 1549). The model compre
hensively covers the Compton-thin to Compton-thick regimes and we find that the variety of Compton shoulder profiles is greater than that for both (centrally-illuminated) spherical and disk geometries. Our Monte Carlo simulations were done with a statistical accuracy that is high enough to reveal, for the case of an edge-on, Compton-thick torus, a new type of Compton shoulder that is not present in the spherical or disk geometries. Such a Compton shoulder is dominated by a narrow back-scattering feature at ~6.24 keV. Our results also reveal a dependence of the shape of the Compton shoulder (and its magnitude relative to the Fe Kalpha line core) on the spectral shape of the incident X-ray continuum. We also show the effects of velocity broadening on the Fe Kalpha line profile and find that if either the velocity width or instrument resolution is greater than a FWHM of ~2000 km/s, the Compton shoulder begins to become blended with the line core and the characteristic features of the Compton shoulder become harder to resolve. In particular, at a FWHM of ~7000 km/s the Compton shoulder is NOT resolved at all, its only signature being a weak asymmetry in the blended line profile. Thus, CCD X-ray detectors cannot unambiguously resolve the Compton shoulder. Our results are freely available in a format that is suitable for direct spectral-fitting of the continuum and line model to real data.
We report on a detailed study of the Fe K emission/absorption complex in the nearby, bright Seyfert 1 galaxy Mrk 509. The study is part of an extensive XMM-Newton monitoring consisting of 10 pointings (~60 ks each) about once every four days, and inc
ludes also a reanalysis of previous XMM-Newton and Chandra observations. Mrk 509 shows a clear (EW=58 eV) neutral Fe Kalpha emission line that can be decomposed into a narrow (sigma=0.027 keV) component (found in the Chandra HETG data) plus a resolved (sigma=0.22 keV) component. We find the first successful measurement of a linear correlation between the intensity of the resolved line component and the 3-10 keV flux variations on time-scales of years down to a few days. The Fe Kalpha reverberates the hard X-ray continuum without any measurable lag, suggesting that the region producing the resolved Fe Kalpha component is located within a few light days-week (r<~10^3 rg) from the Black Hole (BH). The lack of a redshifted wing in the line poses a lower limit of >40 rg for its distance from the BH. The Fe Kalpha could thus be emitted from the inner regions of the BLR, i.e. within the ~80 light days indicated by the Hbeta line measurements. In addition to these two neutral Fe Kalpha components, we confirm the detection of weak (EW~8-20 eV) ionised Fe K emission. This ionised line can be modeled with either a blend of two narrow FeXXV and FeXXVI emission lines or with a single relativistic line produced, in an ionised disc, down to a few rg from the BH. Finally, we observe a weakening/disappearing of the medium and high velocity high ionisation Fe K wind features found in previous XMM-Newton observations. This campaign has made possible the first reverberation measurement of the resolved component of the Fe Kalpha line, from which we can infer a location for the bulk of its emission at a distance of r~40-1000 rg from the BH.
The Fe Kalpha emission line is the most ubiquitous feature in the X-ray spectra of active galactic nuclei (AGN), but the origin of its narrow core remains uncertain. Here, we investigate the connection between the sizes of the Fe core emission region
s and the measured sizes of the dusty tori in 13 local Type 1 AGN. The observed Fe K emission radii (R_fe) are determined from spectrally resolved line widths in X-ray grating spectra, and the dust sublimation radii (R_dust) are measured either from optical/near-infrared reverberation time lags or from resolved near-infrared interferometric data. This direct comparison shows, on an object-by-object basis, that the dust sublimation radius forms an outer envelope to the bulk of the Fe K emission. R_fe matches R_dust well in the AGN with the best constrained line widths currently. In a significant fraction of objects without a clear narrow line core, R_fe is similar to, or smaller than the radius of the optical broad line region. These facts place important constraints on the torus geometries for our sample. Extended tori in which the solid angle of fluorescing gas peaks at well beyond the dust sublimation radius can be ruled out. We also test for luminosity scalings of R_fe, finding that Eddington ratio is not a prime driver in determining the line location in our sample. We discuss in detail potential caveats due to data analysis and instrumental limitations, simplistic line modeling, uncertain black hole masses, as well as sample selection, showing that none of these is likely to bias our core result. The calorimeter on board Astro-H will soon vastly increase the parameter space over which line measurements can be made, overcoming many of these limitations.
The Fe-K line, an important physical diagnostic in the X-ray spectra of AGN, has been notoriously difficult to measure in the high-luminosity, radio-loud quasar 3C 273 (z=0.158). On the few occasions that it has been detected its intrinsic width has
been thought to be narrow (FWHM < 10,000 km/s) with an equivalent width (EW) of a few tens of eV.This was consistent with the general trend that as one goes from low to high luminosity AGNs the Fe-K line goes from being strong (EW ~200-300 eV) and broad (FWHM ~ 100,000 km/s) to being weak and narrow, or absent altogether. Here we present the results of new ASCA and RXTE observations, together with archival ASCA data, and show for the first time that the Fe-K line in 3C 273 is as broad as that seen in Seyfert 1. The line is resolved in two of the observations, with a mean Gaussian width of 0.8 +/- 0.3 keV, or FWHM of 0.3 +/- 0.1c. The smallest and largest EW measured is 43 +/- 34 eV, and 133 (+52,-53) eV respectively (quasar frame). The Compton-reflection continuum is less than 10% of that expected from a centrally illuminated semi-infinite, face-on, Compton-thick disk, confirming previous studies that Compton reflection is negligible in 3C 273. The largest values of the Fe-K line EW are under-predicted if the line originates in the disk, unless a time lag longer than several days between line and continuum and/or an over-abundance of Fe is invoked. We cannot unambiguously constrain the disk inclination angle. About 60 deg is preferred for a cold disk, while a face-on disk is allowed if the ionization state of Fe is H-like.
The recent detection of X-ray reverberation lags, especially in the Fe Kalpha line region, around Active Galactic Nuclei (AGN) has opened up the possibility of studying the time-resolved response (reflection) of hard X-rays from the accretion disk ar
ound supermassive black holes. Here, we use general relativistic transfer functions for reflection of X-rays from a point source located at some height above the black hole to study the time lags expected as a function of frequency and energy in the Fe Kalpha line region. We explore the models and the dependence of the lags on key parameters such as the height of the X-ray source, accretion disk inclination, black hole spin and black hole mass. We then compare these models with the observed frequency and energy dependence of the Fe Kalpha line lag in NGC 4151. Assuming the optical reverberation mapping mass of $4.6times10^7~M_odot$ we get a best fit to the lag profile across the Fe Kalpha line in the frequency range $(1-2)times10^{-5}$ Hz for an X-ray source located at a height $h = 7^{+2.9}_{-2.6}~R_G$ with a maximally spinning black hole and an inclination $i < 30^circ$.
سجل دخول لتتمكن من نشر تعليقات
التعليقات
جاري جلب التعليقات
سجل دخول لتتمكن من متابعة معايير البحث التي قمت باختيارها
