اشترك بالحزمة الذهبية واحصل على وصول غير محدود شمرا أكاديميا
تسجيل مستخدم جديدSoft chemical control of superconductivity in lithium iron selenide hydroxides Li1-xFex(OH)Fe1-ySe
125
0
0.0
(
0
)
اسأل ChatGPT حول البحث
ﻻ يوجد ملخص باللغة العربية
Hydrothermal synthesis is described of layered lithium iron selenide hydroxides Li1-xFex(OH)Fe1-ySe (x ~ 0.2; 0.02 < y < 0.15) with a wide range of iron site vacancy concentrations in the iron selenide layers. This iron vacancy concentration is revealed as the only significant compositional variable and as the key parameter controlling the crystal structure and the electronic properties. Single crystal X-ray diffraction, neutron powder diffraction and X-ray absorption spectroscopy measurements are used to demonstrate that superconductivity at temperatures as high as 40 K is observed in the hydrothermally synthesised samples when the iron vacancy concentration is low (y < 0.05) and when the iron oxidation state is reduced slightly below +2, while samples with a higher vacancy concentration and a correspondingly higher iron oxidation state are not superconducting. The importance of combining a low iron oxidation state with a low vacancy concentration in the iron selenide layers is emphasised by the demonstration that reductive post-synthetic lithiation of the samples turns on superconductivity with critical temperatures exceeding 40 K by displacing iron atoms from the Li1-xFex(OH) reservoir layer to fill vacancies in the selenide layer
قيم البحث
اقرأ أيضاً
The pressure-induced reemergence of the second high-Tc superconducting phase (SC-II) in the alkali-metal intercalated AxFe2-ySe2 (A = K, Rb, Cs, Tl) remains an enigma and proper characterizations on the superconducting- and normal-state properties of
the SC-II phase were hampered by the intrinsic inhomogeneity and phase separation. To elucidate this intriguing problem, we performed a detailed high-pressure magnetotransport study on the recently discovered (Li1-xFex)OHFe1-ySe single crystals, which have high Tc~40 K and share similar Fermi surface topology as AxFe2-ySe2, but are free from the sample complications. We found that the ambient-pressure Tc~41 K is suppressed gradually to below 2 K upon increasing pressure to Pc ~5 GPa, above which a SC-II phase with higher Tc emerges and the Tc increases progressively to above 50 K up to 12.5 GPa. Interestingly, our high-precision resistivity data enable us to uncover the sharp transition of the normal state from a Fermi liquid for SC-I phase (0 < P < 5 GPa) to a non-Fermi-liquid for SC-II phase (P > 5GPa). In addition, the reemergence of high-Tc SC-II phase is found to accompany with a concurrent enhancement of electron carrier density. Since high-pressure structural study based on the synchrotron X-ray diffraction rules out the structural transition below 10 GPa, the observed SC-II phase with enhanced carrier density should be ascribed to an electronic origin associated with a pressure-induced Fermi surface reconstruction.
Inspired by naturally occurring sulfide minerals, we present a new family of iron-based superconductors. A metastable form of FeS known as the mineral mackinawite forms two-dimensional sheets that can be readily intercalated by various cationic guest
species. Under hydrothermal conditions using alkali metal hydroxides, we prepare three different cation and metal hydroxide-intercalated FeS phases including (Li$_{1-x}$Fe$_x$OH)FeS, [(Na$_{1-x}$Fe$_x$)(OH)$_2$]FeS, and K$_x$Fe$_{2-y}$S$_2$. Upon successful intercalation of the FeS layer, the superconducting critical temperature $T_c$ of mackinawite is enhanced from 5 K to 8 K for the (Li$_{1-x}$Fe$_x$OH)$^{delta+}$ intercalate. Layered heterostructures of [(Na$_{1-x}$Fe$_x$)(OH)$_2$]FeS resemble the natural mineral tochilinite, which contains an iron square lattice interleaved with a hexagonal hydroxide lattice. Whilst heterostructured [(Na$_{1-x}$Fe$_x$)(OH)$_2$]FeS displays long-range magnetic ordering near 15 K, K$_x$Fe$_{2-y}$S$_2$ displays short range antiferromagnetism.
Iron pnictides are the only known family of unconventional high-temperature superconductors besides cuprates. Until recently, it was widely accepted that superconductivity is spin-fluctuation driven and intimately related to their fermiology, specifi
cally, hole and electron pockets separated by the same wave vector that characterizes the dominant spin fluctuations, and supporting order parameters (OP) of opposite signs. This picture was questioned after the discovery of a new family, based on the FeSe layers, either intercalated or in the monolayer form. The critical temperatures there reach ~40 K, the same as in optimally doped bulk FeSe - despite the fact that intercalation removes the hole pockets from the Fermi level and, seemingly, undermines the basis for the spin-fluctuation theory and the idea of a sign-changing OP. In this paper, using the recently proposed phase-sensitive quasiparticle interference technique, we show that in LiOH intercalated FeSe compound the OP does change sign, albeit within the electronic pockets, and not between the hole and electron ones. This result unifies the pairing mechanism of iron based superconductors with or without the hole Fermi pockets and supports the conclusion that spin fluctuations play the key role in electron pairing.
We have carried out a systematic study of the PbO-type compound FeSe_{1-x}Te_x (x = 0~1), where Te substitution effect on superconductivity is investigated. It is found that superconducting transition temperature reaches a maximum of Tc=15.2K at abou
t 50% Te substitution. The pressure-enhanced Tc of FeSe0.5Te0.5 is more than 10 times larger than that of FeSe. Interestingly, FeTe is no longer superconducting. A low temperature structural distortion changes FeTe from triclinic symmetry to orthorhombic symmetry. We believe that this structural change breaks the magnetic symmetry and suppresses superconductivity in FeTe.
We report on the local electronic structure of oxygen incorporated FeTe and FeSe films and how this relates to superconductivity observed in these films. In the case of FeTe, intially grown films are measured to be non-superconducting, but become sup
erconducting following oxygen incorporation. In FeSe the opposite happens, initially grown films are measured to be superconducting, but experience a quenching of superconductivity following oxygen incorporation. Total Fluorescence Yield (TFY) X-ray absorption experiments show that oxygen incorporation changes the initial Fe valence state in both the initially grown FeTe and FeSe films to mainly Fe3+ in the oxygen incorporated films. In contrast we observe that while Te moves to a mixed Te0/Te4+ valence state, the Se always remains Se0. This work highlights how different responses of the electronic structure by the respective chalcogenides to oxidation could be related to the mechanisms which are inducing superconductivity in FeTe and quenching superconductivity in FeSe.
سجل دخول لتتمكن من نشر تعليقات
التعليقات
جاري جلب التعليقات
سجل دخول لتتمكن من متابعة معايير البحث التي قمت باختيارها
