اشترك بالحزمة الذهبية واحصل على وصول غير محدود شمرا أكاديميا
تسجيل مستخدم جديدApplication of the DRS4 Chip for GHz Waveform Digitizing Circuit
60
0
0.0
(
0
)
اسأل ChatGPT حول البحث
ﻻ يوجد ملخص باللغة العربية
At present, fast waveform digitizing circuit is more and more employed in modern physics experiments for processing the signals from an array detector. A new fast waveform sampling digitizing circuit developed by us is presented in this paper. Different with the traditional waveform digitizing circuit constructed with analog to digital converter(ADC) or time to digital converter(TDC), it is developed based on domino ring sampler(DRS), a switched capacitor array(SCA) chip. A DRS4 chip is used as a core device in our circuit, which has a fast sampling rate up to five gigabit samples per second (GSPS). The circuit has advantages of high resolution, low cost, low power dissipation, high channel density and small size. The quite satisfactory results are acquired by the preliminary performance test of this circuit board. Eight channels can be provided by one board, which has a 1-volt input dynamic range for each channel. The circuit linearity is better than 0.1%, the noise is less than 0.5 mV (root mean square, RMS), and its time resolution is about 50ps. The several boards can be cascaded to construct a multi-board system. The good performances make the circuit board to be used not only for physics experiments, but also for other applications.
قيم البحث
اقرأ أيضاً
In this paper we illustrate techniques for digitized waveform signal processing of fast timing detectors. In the example discussed here, timing analysis of SiPM signals in the presence of high Dark Count Rates, a large data set of digitized waveforms
is used to develop an optimal strategy relevant to the electronics front end design.
Microwave cavities for a Sikivie-type axion search are subject to several constraints. In the fabrication and operation of such cavities, often used at frequencies where the resonator is highly overmoded, it is important to be able to reliably identi
fy several properties of the cavity. Those include identifying the symmetry of the mode of interest, confirming its form factor, and determining the frequency ranges where mode crossings with intruder levels cause unacceptable admixture, thus leading to the loss of purity of the mode of interest. A simple and powerful diagnostic for mapping out the electric field of a cavity is the bead perturbation technique. While a standard tool in accelerator physics, we have, for the first time, applied this technique to cavities used in the axion search. We report initial results from an extensive study for the initial cavity used in the HAYSTAC experiment. Two effects have been investigated: the role of rod misalignment in mode localization, and mode-mixing at avoided crossings of TM/TE modes. Future work will extend these results by incorporating precision metrology and high-fidelity simulations.
Waveform feature is one of the requirements for the FRIB LLRF controllers. It is desired that the LLRF con-trollers store the internal data (e.g. the amplitude and phase information of forward/reverse/cavity signals) for at least one second of sample
d data at the RF feedback control loop rate (around 1.25 MHz). One use case is to freeze the data buffer when an interlock event happens and read out the fast data to diagnose the problem. An-other use case is to monitor a set of signals at a decimated rate (user settable) while the data buffer is still running, like using an oscilloscope. The detailed implementation will be discussed in the paper, including writing data into the DDR memory through the native interface, reading out the data through the bus interface, etc.
Mu3e is a novel experiment searching for charged lepton flavor violation in the rare decay $mu^+ rightarrow e^+e^-e^+$. Decay vertex position, decay time and particle momenta have to be precisely measured in order to reject both accidental and physic
s background. A silicon pixel tracker based on $50,mu$m thin high voltage monolithic active pixel sensors (HV-MAPS) in a 1 T solenoidal magnetic field provides precise vertex and momentum information. The MuPix chip combines pixel sensor cells with integrated analog electronics and a periphery with a complete digital readout. The MuPix7 is the first HV-MAPS prototype implementing all functionalities of the final sensor including a readout state machine and high speed serialization with 1.25 Gbit/s data output, allowing for a streaming readout in parallel to the data taking. The observed efficiency of the MuPix7 chip including the full readout system is $geq99%$ in a high rate test beam.
To better understand the energy response of the Antineutrino Detector (AD), the Daya Bay Reactor Neutrino Experiment installed a full Flash ADC readout system on one AD that allowed for simultaneous data taking with the current readout system. This p
aper presents the design, data acquisition, and simulation of the Flash ADC system, and focuses on the PMT waveform reconstruction algorithms. For liquid scintillator calorimetry, the most critical requirement to waveform reconstruction is linearity. Several common reconstruction methods were tested but the linearity performance was not satisfactory. A new method based on the deconvolution technique was developed with 1% residual non-linearity, which fulfills the requirement. The performance was validated with both data and Monte Carlo (MC) simulations, and 1% consistency between them has been achieved.
سجل دخول لتتمكن من نشر تعليقات
التعليقات
جاري جلب التعليقات
سجل دخول لتتمكن من متابعة معايير البحث التي قمت باختيارها
