اشترك بالحزمة الذهبية واحصل على وصول غير محدود شمرا أكاديميا
تسجيل مستخدم جديدCorrelation of size and oxygen bonding at the interface of Si nanocrystal in Si-SiO2 nanocomposite: A Raman mapping study
226
0
0.0
(
0
)
اسأل ChatGPT حول البحث
ﻻ يوجد ملخص باللغة العربية
Si-SiO2 multilayer nanocomposite (NCp) films, grown using pulsed laser deposition with varying Si deposition time are investigated using Raman spectroscopy/mapping for studying the variation of Si phonon frequency observed in these NCps. The lower frequency (LF) phonons (~ 495 - 510 cm-1) and higher frequency (HF) phonons (~ 515 - 519 cm-1) observed in Raman mapping data (Fig. 1A) in all samples studied are attributed to have originated from surface (Si-SiO2 interface) and core of Si nanocrystals, respectively. The consistent picture of this understanding is developed using Raman spectroscopy monitored laser heating/annealing and cooling (LHC) experiment at the site of a desired frequency chosen with the help of Raman mapping, which brings out clear difference between core and surface (interface) phonons of Si nanocrystals. In order to further support our attribution of LF being surface (interface) phonons, Raman spectra calculations for Si41 cluster with oxygen termination are performed which shows strong Si phonon frequency at 512 cm-1 corresponding to the surface Si atoms. This can be considered analogous to the observed phonon frequencies in the range 495 - 510 cm-1 originating at the Si-SiO2 interface (extended). These results along with XPS data show that nature of interface (oxygen bonding) in turn depends on the size of nanocrystals and thus LF phonons originate at the surface of smaller Si nanocrystals. The understanding developed can be extended to explain large variation observed in Si phonon frequencies of Si-SiO2 nanocomposites reported in the literature, especially lower frequencies.
قيم البحث
اقرأ أيضاً
Intermediate frequency range (511 - 514 cm-1) Si phonons in Si-SiO2 nanocomposites are shown to have contribution from both core1 and surface/interface1 Si phonons, where, ratio of contribution of the two depends on the size of a Si nanocrystal. Furt
her, laser heating experiment shows that contribution of the core phonon increases due to increase in size of a nanocrystal. Wavelength dependent Raman mapping reveals that interface phonons are observable due to Resonance Raman scattering. This can well be corroborated with the absorption spectra. This understanding can be gainfully used to manipulate and characterize Si-SiO2 nanocomposite, simultaneously for photovoltaic device applications.
The presence of interface states at the MOS interface is a well-known cause of device degradation. This is particularly true for ultra-scaled FinFET geometries where the presence of a few traps can strongly influence device behavior. Typical methods
for interface trap density (Dit) measurements are not performed on ultimate devices, but on custom designed structures. We present the first set of methods that allow direct estimation of Dit in state-of-the-art FinFETs, addressing a critical industry need.
Binary collision simulations of high-fluence 1 keV Si ion implantation into 8 nm thick SiO2 films on (001)Si were combined with kinetic Monte Carlo simulations of Si nanocrystal (NC) formation by phase separation during annealing. For nonvolatile mem
ory applications, these simulations help to control size and location of NCs. For low concentrations of implanted Si, NCs form via nucleation, growth and Ostwald ripening, whereas for high concentrations Si separates by spinodal decomposition. In both regimes, NCs form above a thin NC free oxide layer at the SiO2/Si interface. This, self-adjusted layer has just a thickness appropriate for NC charging by direct electron tunneling. Only in the nucleation regime the width of the tunneling oxide and the mean NC diameter remain constant during a long annealing period. This behavior originates from the competition of Ostwald ripening and Si loss to the Si/SiO2 interface. The process simulations predict that, for nonvolatile memories, the technological demands on NC synthesis are fulfilled best in the nucleation regime.
In Raman spectroscopy of graphite and graphene, the $D$ band at $sim 1355$cm$^{-1}$ is used as the indication of the dirtiness of a sample. However, our analysis suggests that the physics behind the $D$ band is closely related to a very clear idea fo
r describing a molecule, namely bonding and antibonding orbitals in graphene. In this paper, we review our recent work on the mechanism for activating the $D$ band at a graphene edge.
In the present theoretical work we have considered impurities, either boron or phosphorous, located at different substitutional sites in silicon quantum dots (Si-QDs) with diameters around 1.5,nm, embedded in a SiO2 matrix. Formation energy calculati
ons reveal that the most energetically-favored doping sites are inside the QD and at the Si/SiO2 interface for P and B impurities, respectively. Furthermore, electron and hole transport calculations show in all the cases a strong reduction of the minimum voltage threshold, and a corresponding increase of the total current in the low-voltage regime. At higher voltage, our findings indicate a significant increase of transport only for P-doped Si-QDs, while the electrical response of B-doped ones does not stray from the undoped case. These findings are of support for the employment of doped Si-QDs in a wide range of applications, such as Si-based photonics or photovoltaic solar cells.
سجل دخول لتتمكن من نشر تعليقات
التعليقات
جاري جلب التعليقات
سجل دخول لتتمكن من متابعة معايير البحث التي قمت باختيارها
